These changes are the raw update to linux-4.4.6-rt14. Kernel sources
[kvmfornfv.git] / kernel / include / linux / platform_data / spi-davinci.h
1 /*
2  * Copyright 2009 Texas Instruments.
3  *
4  * This program is free software; you can redistribute it and/or modify
5  * it under the terms of the GNU General Public License as published by
6  * the Free Software Foundation; either version 2 of the License, or
7  * (at your option) any later version.
8  *
9  * This program is distributed in the hope that it will be useful,
10  * but WITHOUT ANY WARRANTY; without even the implied warranty of
11  * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.  See the
12  * GNU General Public License for more details.
13  *
14  * You should have received a copy of the GNU General Public License
15  * along with this program; if not, write to the Free Software
16  * Foundation, Inc., 675 Mass Ave, Cambridge, MA 02139, USA.
17  */
18
19 #ifndef __ARCH_ARM_DAVINCI_SPI_H
20 #define __ARCH_ARM_DAVINCI_SPI_H
21
22 #include <linux/platform_data/edma.h>
23
24 #define SPI_INTERN_CS   0xFF
25
26 enum {
27         SPI_VERSION_1, /* For DM355/DM365/DM6467 */
28         SPI_VERSION_2, /* For DA8xx */
29 };
30
31 /**
32  * davinci_spi_platform_data - Platform data for SPI master device on DaVinci
33  *
34  * @version:    version of the SPI IP. Different DaVinci devices have slightly
35  *              varying versions of the same IP.
36  * @num_chipselect: number of chipselects supported by this SPI master
37  * @intr_line:  interrupt line used to connect the SPI IP to the ARM interrupt
38  *              controller withn the SoC. Possible values are 0 and 1.
39  * @chip_sel:   list of GPIOs which can act as chip-selects for the SPI.
40  *              SPI_INTERN_CS denotes internal SPI chip-select. Not necessary
41  *              to populate if all chip-selects are internal.
42  * @cshold_bug: set this to true if the SPI controller on your chip requires
43  *              a write to CSHOLD bit in between transfers (like in DM355).
44  * @dma_event_q: DMA event queue to use if SPI_IO_TYPE_DMA is used for any
45  *              device on the bus.
46  */
47 struct davinci_spi_platform_data {
48         u8                      version;
49         u8                      num_chipselect;
50         u8                      intr_line;
51         u8                      *chip_sel;
52         u8                      prescaler_limit;
53         bool                    cshold_bug;
54         enum dma_event_q        dma_event_q;
55 };
56
57 /**
58  * davinci_spi_config - Per-chip-select configuration for SPI slave devices
59  *
60  * @wdelay:     amount of delay between transmissions. Measured in number of
61  *              SPI module clocks.
62  * @odd_parity: polarity of parity flag at the end of transmit data stream.
63  *              0 - odd parity, 1 - even parity.
64  * @parity_enable: enable transmission of parity at end of each transmit
65  *              data stream.
66  * @io_type:    type of IO transfer. Choose between polled, interrupt and DMA.
67  * @timer_disable: disable chip-select timers (setup and hold)
68  * @c2tdelay:   chip-select setup time. Measured in number of SPI module clocks.
69  * @t2cdelay:   chip-select hold time. Measured in number of SPI module clocks.
70  * @t2edelay:   transmit data finished to SPI ENAn pin inactive time. Measured
71  *              in number of SPI clocks.
72  * @c2edelay:   chip-select active to SPI ENAn signal active time. Measured in
73  *              number of SPI clocks.
74  */
75 struct davinci_spi_config {
76         u8      wdelay;
77         u8      odd_parity;
78         u8      parity_enable;
79 #define SPI_IO_TYPE_INTR        0
80 #define SPI_IO_TYPE_POLL        1
81 #define SPI_IO_TYPE_DMA         2
82         u8      io_type;
83         u8      timer_disable;
84         u8      c2tdelay;
85         u8      t2cdelay;
86         u8      t2edelay;
87         u8      c2edelay;
88 };
89
90 #endif  /* __ARCH_ARM_DAVINCI_SPI_H */