Add the rt linux 4.1.3-rt3 as base
[kvmfornfv.git] / kernel / arch / arm / mm / proc-v7m.S
1 /*
2  *  linux/arch/arm/mm/proc-v7m.S
3  *
4  *  Copyright (C) 2008 ARM Ltd.
5  *  Copyright (C) 2001 Deep Blue Solutions Ltd.
6  *
7  * This program is free software; you can redistribute it and/or modify
8  * it under the terms of the GNU General Public License version 2 as
9  * published by the Free Software Foundation.
10  *
11  *  This is the "shell" of the ARMv7-M processor support.
12  */
13 #include <linux/linkage.h>
14 #include <asm/assembler.h>
15 #include <asm/v7m.h>
16 #include "proc-macros.S"
17
18 ENTRY(cpu_v7m_proc_init)
19         ret     lr
20 ENDPROC(cpu_v7m_proc_init)
21
22 ENTRY(cpu_v7m_proc_fin)
23         ret     lr
24 ENDPROC(cpu_v7m_proc_fin)
25
26 /*
27  *      cpu_v7m_reset(loc)
28  *
29  *      Perform a soft reset of the system.  Put the CPU into the
30  *      same state as it would be if it had been reset, and branch
31  *      to what would be the reset vector.
32  *
33  *      - loc   - location to jump to for soft reset
34  */
35         .align  5
36 ENTRY(cpu_v7m_reset)
37         ret     r0
38 ENDPROC(cpu_v7m_reset)
39
40 /*
41  *      cpu_v7m_do_idle()
42  *
43  *      Idle the processor (eg, wait for interrupt).
44  *
45  *      IRQs are already disabled.
46  */
47 ENTRY(cpu_v7m_do_idle)
48         wfi
49         ret     lr
50 ENDPROC(cpu_v7m_do_idle)
51
52 ENTRY(cpu_v7m_dcache_clean_area)
53         ret     lr
54 ENDPROC(cpu_v7m_dcache_clean_area)
55
56 /*
57  * There is no MMU, so here is nothing to do.
58  */
59 ENTRY(cpu_v7m_switch_mm)
60         ret     lr
61 ENDPROC(cpu_v7m_switch_mm)
62
63 .globl  cpu_v7m_suspend_size
64 .equ    cpu_v7m_suspend_size, 0
65
66 #ifdef CONFIG_ARM_CPU_SUSPEND
67 ENTRY(cpu_v7m_do_suspend)
68         ret     lr
69 ENDPROC(cpu_v7m_do_suspend)
70
71 ENTRY(cpu_v7m_do_resume)
72         ret     lr
73 ENDPROC(cpu_v7m_do_resume)
74 #endif
75
76         .section ".text.init", #alloc, #execinstr
77
78 /*
79  *      __v7m_setup
80  *
81  *      This should be able to cover all ARMv7-M cores.
82  */
83 __v7m_setup:
84         @ Configure the vector table base address
85         ldr     r0, =BASEADDR_V7M_SCB
86         ldr     r12, =vector_table
87         str     r12, [r0, V7M_SCB_VTOR]
88
89         @ enable UsageFault, BusFault and MemManage fault.
90         ldr     r5, [r0, #V7M_SCB_SHCSR]
91         orr     r5, #(V7M_SCB_SHCSR_USGFAULTENA | V7M_SCB_SHCSR_BUSFAULTENA | V7M_SCB_SHCSR_MEMFAULTENA)
92         str     r5, [r0, #V7M_SCB_SHCSR]
93
94         @ Lower the priority of the SVC and PendSV exceptions
95         mov     r5, #0x80000000
96         str     r5, [r0, V7M_SCB_SHPR2] @ set SVC priority
97         mov     r5, #0x00800000
98         str     r5, [r0, V7M_SCB_SHPR3] @ set PendSV priority
99
100         @ SVC to run the kernel in this mode
101         adr     r1, BSYM(1f)
102         ldr     r5, [r12, #11 * 4]      @ read the SVC vector entry
103         str     r1, [r12, #11 * 4]      @ write the temporary SVC vector entry
104         mov     r6, lr                  @ save LR
105         mov     r7, sp                  @ save SP
106         ldr     sp, =__v7m_setup_stack_top
107         cpsie   i
108         svc     #0
109 1:      cpsid   i
110         str     r5, [r12, #11 * 4]      @ restore the original SVC vector entry
111         mov     lr, r6                  @ restore LR
112         mov     sp, r7                  @ restore SP
113
114         @ Special-purpose control register
115         mov     r1, #1
116         msr     control, r1             @ Thread mode has unpriviledged access
117
118         @ Configure the System Control Register to ensure 8-byte stack alignment
119         @ Note the STKALIGN bit is either RW or RAO.
120         ldr     r12, [r0, V7M_SCB_CCR]  @ system control register
121         orr     r12, #V7M_SCB_CCR_STKALIGN
122         str     r12, [r0, V7M_SCB_CCR]
123         ret     lr
124 ENDPROC(__v7m_setup)
125
126         .align 2
127 __v7m_setup_stack:
128         .space  4 * 8                           @ 8 registers
129 __v7m_setup_stack_top:
130
131         define_processor_functions v7m, dabort=nommu_early_abort, pabort=legacy_pabort, nommu=1
132
133         .section ".rodata"
134         string cpu_arch_name, "armv7m"
135         string cpu_elf_name "v7m"
136         string cpu_v7m_name "ARMv7-M"
137
138         .section ".proc.info.init", #alloc
139
140         /*
141          * Match any ARMv7-M processor core.
142          */
143         .type   __v7m_proc_info, #object
144 __v7m_proc_info:
145         .long   0x000f0000              @ Required ID value
146         .long   0x000f0000              @ Mask for ID
147         .long   0                       @ proc_info_list.__cpu_mm_mmu_flags
148         .long   0                       @ proc_info_list.__cpu_io_mmu_flags
149         initfn  __v7m_setup, __v7m_proc_info    @ proc_info_list.__cpu_flush
150         .long   cpu_arch_name
151         .long   cpu_elf_name
152         .long   HWCAP_HALF|HWCAP_THUMB|HWCAP_FAST_MULT
153         .long   cpu_v7m_name
154         .long   v7m_processor_functions @ proc_info_list.proc
155         .long   0                       @ proc_info_list.tlb
156         .long   0                       @ proc_info_list.user
157         .long   nop_cache_fns           @ proc_info_list.cache
158         .size   __v7m_proc_info, . - __v7m_proc_info
159