--- /dev/null
+/*
+ * $Id: mtd-abi.h,v 1.13 2005/11/07 11:14:56 gleixner Exp $
+ *
+ * Portions of MTD ABI definition which are shared by kernel and user space
+ */
+
+#ifndef __MTD_ABI_H__
+#define __MTD_ABI_H__
+
+#if 1
+#include <linux/compat.h>
+#endif
+
+#include <linux/compiler.h>
+
+struct erase_info_user {
+ uint32_t start;
+ uint32_t length;
+};
+
+struct mtd_oob_buf {
+ uint32_t start;
+ uint32_t length;
+ unsigned char __user *ptr;
+};
+
+/*
+ * MTD operation modes
+ *
+ * @MTD_OPS_PLACE_OOB: OOB data are placed at the given offset (default)
+ * @MTD_OPS_AUTO_OOB: OOB data are automatically placed at the free areas
+ * which are defined by the internal ecclayout
+ * @MTD_OPS_RAW: data are transferred as-is, with no error correction;
+ * this mode implies %MTD_OPS_PLACE_OOB
+ *
+ * These modes can be passed to ioctl(MEMWRITE) and are also used internally.
+ * See notes on "MTD file modes" for discussion on %MTD_OPS_RAW vs.
+ * %MTD_FILE_MODE_RAW.
+ */
+enum {
+ MTD_OPS_PLACE_OOB = 0,
+ MTD_OPS_AUTO_OOB = 1,
+ MTD_OPS_RAW = 2,
+};
+
+#define MTD_ABSENT 0
+#define MTD_RAM 1
+#define MTD_ROM 2
+#define MTD_NORFLASH 3
+#define MTD_NANDFLASH 4
+#define MTD_DATAFLASH 6
+#define MTD_UBIVOLUME 7
+
+#define MTD_WRITEABLE 0x400 /* Device is writeable */
+#define MTD_BIT_WRITEABLE 0x800 /* Single bits can be flipped */
+#define MTD_NO_ERASE 0x1000 /* No erase necessary */
+#define MTD_STUPID_LOCK 0x2000 /* Always locked after reset */
+
+/* Some common devices / combinations of capabilities */
+#define MTD_CAP_ROM 0
+#define MTD_CAP_RAM (MTD_WRITEABLE | MTD_BIT_WRITEABLE | MTD_NO_ERASE)
+#define MTD_CAP_NORFLASH (MTD_WRITEABLE | MTD_BIT_WRITEABLE)
+#define MTD_CAP_NANDFLASH (MTD_WRITEABLE)
+
+/* ECC byte placement */
+#define MTD_NANDECC_OFF 0 /* Switch off ECC (Not recommended) */
+#define MTD_NANDECC_PLACE 1 /* Use the given placement in the structure (YAFFS1 legacy mode) */
+#define MTD_NANDECC_AUTOPLACE 2 /* Use the default placement scheme */
+#define MTD_NANDECC_PLACEONLY 3 /* Use the given placement in the structure (Do not store ecc result on read) */
+#define MTD_NANDECC_AUTOPL_USR 4 /* Use the given autoplacement scheme rather than using the default */
+
+/* OTP mode selection */
+#define MTD_OTP_OFF 0
+#define MTD_OTP_FACTORY 1
+#define MTD_OTP_USER 2
+
+struct mtd_info_user {
+ uint8_t type;
+ uint32_t flags;
+ uint32_t size; /* Total size of the MTD */
+ uint32_t erasesize;
+ uint32_t writesize;
+ uint32_t oobsize; /* Amount of OOB data per block (e.g. 16) */
+ /* The below two fields are obsolete and broken, do not use them
+ * (TODO: remove at some point) */
+ uint32_t ecctype;
+ uint32_t eccsize;
+};
+
+struct region_info_user {
+ uint32_t offset; /* At which this region starts,
+ * from the beginning of the MTD */
+ uint32_t erasesize; /* For this region */
+ uint32_t numblocks; /* Number of blocks in this region */
+ uint32_t regionindex;
+};
+
+struct otp_info {
+ uint32_t start;
+ uint32_t length;
+ uint32_t locked;
+};
+
+/* Get basic MTD characteristics info (better to use sysfs) */
+#define MEMGETINFO _IOR('M', 1, struct mtd_info_user)
+/* Erase segment of MTD */
+#define MEMERASE _IOW('M', 2, struct erase_info_user)
+/* Write out-of-band data from MTD */
+#define MEMWRITEOOB _IOWR('M', 3, struct mtd_oob_buf)
+/* Read out-of-band data from MTD */
+#define MEMREADOOB _IOWR('M', 4, struct mtd_oob_buf)
+/* Lock a chip (for MTD that supports it) */
+#define MEMLOCK _IOW('M', 5, struct erase_info_user)
+/* Unlock a chip (for MTD that supports it) */
+#define MEMUNLOCK _IOW('M', 6, struct erase_info_user)
+/* Get the number of different erase regions */
+#define MEMGETREGIONCOUNT _IOR('M', 7, int)
+/* Get information about the erase region for a specific index */
+#define MEMGETREGIONINFO _IOWR('M', 8, struct region_info_user)
+/* Get info about OOB modes (e.g., RAW, PLACE, AUTO) - legacy interface */
+#define MEMSETOOBSEL _IOW('M', 9, struct nand_oobinfo)
+#define MEMGETOOBSEL _IOR('M', 10, struct nand_oobinfo)
+/* Check if an eraseblock is bad */
+#define MEMGETBADBLOCK _IOW('M', 11, loff_t)
+/* Mark an eraseblock as bad */
+#define MEMSETBADBLOCK _IOW('M', 12, loff_t)
+/* Set OTP (One-Time Programmable) mode (factory vs. user) */
+#define OTPSELECT _IOR('M', 13, int)
+/* Get number of OTP (One-Time Programmable) regions */
+#define OTPGETREGIONCOUNT _IOW('M', 14, int)
+/* Get all OTP (One-Time Programmable) info about MTD */
+#define OTPGETREGIONINFO _IOW('M', 15, struct otp_info)
+/* Lock a given range of user data (must be in mode %MTD_FILE_MODE_OTP_USER) */
+#define OTPLOCK _IOR('M', 16, struct otp_info)
+/* Get ECC layout (deprecated) */
+#define ECCGETLAYOUT _IOR('M', 17, struct nand_ecclayout)
+/* Get statistics about corrected/uncorrected errors */
+#define ECCGETSTATS _IOR('M', 18, struct mtd_ecc_stats)
+/* Set MTD mode on a per-file-descriptor basis (see "MTD file modes") */
+#define MTDFILEMODE _IO('M', 19)
+
+/*
+ * Obsolete legacy interface. Keep it in order not to break userspace
+ * interfaces
+ */
+struct nand_oobinfo {
+ uint32_t useecc;
+ uint32_t eccbytes;
+ uint32_t oobfree[8][2];
+ uint32_t eccpos[48];
+};
+
+struct nand_oobfree {
+ uint32_t offset;
+ uint32_t length;
+};
+
+/**
+ * struct mtd_ecc_stats - error correction stats
+ *
+ * @corrected: number of corrected bits
+ * @failed: number of uncorrectable errors
+ * @badblocks: number of bad blocks in this partition
+ * @bbtblocks: number of blocks reserved for bad block tables
+ */
+struct mtd_ecc_stats {
+ uint32_t corrected;
+ uint32_t failed;
+ uint32_t badblocks;
+ uint32_t bbtblocks;
+};
+
+/*
+ * MTD file modes - for read/write access to MTD
+ *
+ * @MTD_FILE_MODE_NORMAL: OTP disabled, ECC enabled
+ * @MTD_FILE_MODE_OTP_FACTORY: OTP enabled in factory mode
+ * @MTD_FILE_MODE_OTP_USER: OTP enabled in user mode
+ * @MTD_FILE_MODE_RAW: OTP disabled, ECC disabled
+ *
+ * These modes can be set via ioctl(MTDFILEMODE). The mode mode will be retained
+ * separately for each open file descriptor.
+ *
+ * Note: %MTD_FILE_MODE_RAW provides the same functionality as %MTD_OPS_RAW -
+ * raw access to the flash, without error correction or autoplacement schemes.
+ * Wherever possible, the MTD_OPS_* mode will override the MTD_FILE_MODE_* mode
+ * (e.g., when using ioctl(MEMWRITE)), but in some cases, the MTD_FILE_MODE is
+ * used out of necessity (e.g., `write()', ioctl(MEMWRITEOOB64)).
+ */
+enum mtd_file_modes {
+ MTD_MODE_NORMAL = MTD_OTP_OFF,
+ MTD_MODE_OTP_FACTORY = MTD_OTP_FACTORY,
+ MTD_MODE_OTP_USER = MTD_OTP_USER,
+ MTD_MODE_RAW,
+};
+
+#endif /* __MTD_ABI_H__ */
Code Review / kvmfornfv.git / blobdiff