Add qemu 2.4.0

[kvmfornfv.git] / qemu / roms / u-boot / include / configs / mx23_olinuxino.h

diff --git a/qemu/roms/u-boot/include/configs/mx23_olinuxino.h b/qemu/roms/u-boot/include/configs/mx23_olinuxino.h
new file mode 100644 (file)
index 0000000..e377fea
--- /dev/null
+++ b/qemu/roms/u-boot/include/configs/mx23_olinuxino.h
@@ -0,0 +1,159 @@
+/*
+ * Copyright (C) 2013 Marek Vasut <marex@denx.de>
+ *
+ * SPDX-License-Identifier:    GPL-2.0+
+ */
+#ifndef __CONFIGS_MX23_OLINUXINO_H__
+#define __CONFIGS_MX23_OLINUXINO_H__
+
+/* System configurations */
+#define CONFIG_MX23                            /* i.MX23 SoC */
+#define CONFIG_MACH_TYPE       4105
+
+/* U-Boot Commands */
+#define CONFIG_SYS_NO_FLASH
+#include <config_cmd_default.h>
+#define CONFIG_DISPLAY_CPUINFO
+#define CONFIG_DOS_PARTITION
+
+#define CONFIG_CMD_CACHE
+#define CONFIG_CMD_DHCP
+#define CONFIG_CMD_EXT2
+#define CONFIG_CMD_FAT
+#define CONFIG_CMD_GPIO
+#define CONFIG_CMD_LED
+#define CONFIG_CMD_MMC
+#define CONFIG_CMD_NET
+#define CONFIG_CMD_USB
+
+/* Memory configuration */
+#define CONFIG_NR_DRAM_BANKS           1               /* 1 bank of DRAM */
+#define PHYS_SDRAM_1                   0x40000000      /* Base address */
+#define PHYS_SDRAM_1_SIZE              0x08000000      /* Max 128 MB RAM */
+#define CONFIG_SYS_SDRAM_BASE          PHYS_SDRAM_1
+
+/* Environment */
+#define CONFIG_ENV_IS_IN_MMC
+#define CONFIG_ENV_OVERWRITE
+
+/* Environment is in MMC */
+#if defined(CONFIG_CMD_MMC) && defined(CONFIG_ENV_IS_IN_MMC)
+#define CONFIG_ENV_OFFSET      (256 * 1024)
+#define CONFIG_ENV_SIZE                (16 * 1024)
+#define CONFIG_SYS_MMC_ENV_DEV 0
+#endif
+
+/* Status LED */
+#define CONFIG_STATUS_LED
+#define CONFIG_GPIO_LED
+#define CONFIG_BOARD_SPECIFIC_LED
+#define STATUS_LED_BOOT                0
+#define STATUS_LED_BIT         MX23_PAD_SSP1_DETECT__GPIO_2_1
+#define STATUS_LED_STATE       STATUS_LED_ON
+#define STATUS_LED_PERIOD      (CONFIG_SYS_HZ / 2)
+
+/* USB */
+#ifdef CONFIG_CMD_USB
+#define CONFIG_EHCI_MXS_PORT0
+#define CONFIG_USB_MAX_CONTROLLER_COUNT 1
+#define CONFIG_USB_STORAGE
+#endif
+
+/* Ethernet */
+#ifdef CONFIG_CMD_NET
+#define CONFIG_USB_HOST_ETHER
+#define CONFIG_USB_ETHER_SMSC95XX
+#endif
+
+/* Booting Linux */
+#define CONFIG_BOOTDELAY       3
+#define CONFIG_BOOTFILE                "uImage"
+#define CONFIG_LOADADDR                0x42000000
+#define CONFIG_SYS_LOAD_ADDR   CONFIG_LOADADDR
+
+/* Extra Environment */
+#define CONFIG_EXTRA_ENV_SETTINGS \
+       "update_sd_firmware_filename=u-boot.sd\0" \
+       "update_sd_firmware="           /* Update the SD firmware partition */ \
+               "if mmc rescan ; then " \
+               "if tftp ${update_sd_firmware_filename} ; then " \
+               "setexpr fw_sz ${filesize} / 0x200 ; "  /* SD block size */ \
+               "setexpr fw_sz ${fw_sz} + 1 ; " \
+               "mmc write ${loadaddr} 0x800 ${fw_sz} ; " \
+               "fi ; " \
+               "fi\0" \
+       "script=boot.scr\0"     \
+       "uimage=uImage\0" \
+       "console=ttyAMA0\0" \
+       "fdt_file=imx23-olinuxino.dtb\0" \
+       "fdt_addr=0x41000000\0" \
+       "boot_fdt=try\0" \
+       "ip_dyn=yes\0" \
+       "mmcdev=0\0" \
+       "mmcpart=2\0" \
+       "mmcroot=/dev/mmcblk0p3 rw rootwait\0" \
+       "mmcargs=setenv bootargs console=${console},${baudrate} " \
+               "root=${mmcroot}\0" \
+       "loadbootscript="  \
+               "fatload mmc ${mmcdev}:${mmcpart} ${loadaddr} ${script};\0" \
+       "bootscript=echo Running bootscript from mmc ...; "     \
+               "source\0" \
+       "loaduimage=fatload mmc ${mmcdev}:${mmcpart} ${loadaddr} ${uimage}\0" \
+       "loadfdt=fatload mmc ${mmcdev}:${mmcpart} ${fdt_addr} ${fdt_file}\0" \
+       "mmcboot=echo Booting from mmc ...; " \
+               "run mmcargs; " \
+               "if test ${boot_fdt} = yes || test ${boot_fdt} = try; then " \
+                       "if run loadfdt; then " \
+                               "bootm ${loadaddr} - ${fdt_addr}; " \
+                       "else " \
+                               "if test ${boot_fdt} = try; then " \
+                                       "bootm; " \
+                               "else " \
+                                       "echo WARN: Cannot load the DT; " \
+                               "fi; " \
+                       "fi; " \
+               "else " \
+                       "bootm; " \
+               "fi;\0" \
+       "netargs=setenv bootargs console=${console},${baudrate} " \
+               "root=/dev/nfs " \
+               "ip=dhcp nfsroot=${serverip}:${nfsroot},v3,tcp\0" \
+       "netboot=echo Booting from net ...; " \
+               "usb start; " \
+               "run netargs; " \
+               "if test ${ip_dyn} = yes; then " \
+                       "setenv get_cmd dhcp; " \
+               "else " \
+                       "setenv get_cmd tftp; " \
+               "fi; " \
+               "${get_cmd} ${uimage}; " \
+               "if test ${boot_fdt} = yes; then " \
+                       "if ${get_cmd} ${fdt_addr} ${fdt_file}; then " \
+                               "bootm ${loadaddr} - ${fdt_addr}; " \
+                       "else " \
+                               "if test ${boot_fdt} = try; then " \
+                                       "bootm; " \
+                               "else " \
+                                       "echo WARN: Cannot load the DT; " \
+                               "fi;" \
+                       "fi; " \
+               "else " \
+                       "bootm; " \
+               "fi;\0"
+
+#define CONFIG_BOOTCOMMAND \
+       "mmc dev ${mmcdev}; if mmc rescan; then " \
+               "if run loadbootscript; then " \
+                       "run bootscript; " \
+               "else " \
+                       "if run loaduimage; then " \
+                               "run mmcboot; " \
+                       "else run netboot; " \
+                       "fi; " \
+               "fi; " \
+       "else run netboot; fi"
+
+/* The rest of the configuration is shared */
+#include <configs/mxs.h>
+
+#endif /* __CONFIGS_MX23_OLINUXINO_H__ */