Add qemu 2.4.0

[kvmfornfv.git] / qemu / roms / u-boot / doc / README.fsl-hwconfig

diff --git a/qemu/roms/u-boot/doc/README.fsl-hwconfig b/qemu/roms/u-boot/doc/README.fsl-hwconfig
new file mode 100644 (file)
index 0000000..e752505
--- /dev/null
+++ b/qemu/roms/u-boot/doc/README.fsl-hwconfig
@@ -0,0 +1,46 @@
+Freescale-specific 'hwconfig' options.
+
+This file documents Freescale-specific key:value pairs for the 'hwconfig'
+option.  See README.hwconfig for general information about 'hwconfig'.
+
+audclk
+       Specific to the P1022DS reference board.
+
+       This option specifies which of the two oscillator frequencies should be
+       routed to the Wolfson WM8776 codec.  The ngPIXIS can be programmed to
+       route either a 11.2896MHz or a 12.288MHz clock.  The default is
+       12.288MHz.  This option has two effects.  First, the MUX on the board
+       will be programmed accordingly.  Second, the clock-frequency property
+       in the codec node in the device tree will be updated to the correct
+       value.
+
+       'audclk:11'
+               Select the 11.2896MHz clock
+
+       'audclk:12'
+               Select the 12.288MHz clock
+
+usb
+       Specific to boards have USB controller
+
+       This option specifies the following for a USB controller:
+
+               - which controller mode to use
+               - which USB PHY to use
+
+       This is used by generic USB device-tree fixup function to update
+       modified values of phy type and controller mode.
+
+       Also used for configuring multiple USB controllers such that
+       'usbN' (where N is 1, 2, etc. refers to controller no.)
+
+       'phy_type'
+               Select USB phy type: 'utmi' OR 'ulpi'
+
+       'dr_mode'
+               Select USB controller mode: 'host', 'peripheral' OR 'otg'
+
+       Examples:
+               usb1:dr_mode=host;usb2:dr_mode=peripheral'
+
+               usb1:dr_mode=host,phy_type=utmi;usb2:dr_mode=host'