Add qemu 2.4.0

[kvmfornfv.git] / qemu / roms / u-boot / board / wandboard / README

diff --git a/qemu/roms/u-boot/board/wandboard/README b/qemu/roms/u-boot/board/wandboard/README
new file mode 100644 (file)
index 0000000..1f678e1
--- /dev/null
+++ b/qemu/roms/u-boot/board/wandboard/README
@@ -0,0 +1,45 @@
+U-Boot for Wandboard
+--------------------
+
+This file contains information for the port of U-Boot to the Wandboard.
+
+Wandboard is a development board that has three variants based on the following
+SoCs: mx6 quad, mx6 dual lite and mx6 solo.
+
+For more details about Wandboard, please refer to:
+http://www.wandboard.org/
+
+Building U-boot for Wandboard
+-----------------------------
+
+To build U-Boot for the Wandboard Dual Lite version:
+
+$ make wandboard_dl_config
+$ make
+
+To build U-Boot for the Wandboard Solo version:
+
+$ make wandboard_solo_config
+$ make
+
+To build U-Boot for the Wandboard Quad version:
+
+$ make wandboard_quad_config
+$ make
+
+Flashing U-boot into the SD card
+--------------------------------
+
+- After the 'make' command completes, the generated 'u-boot.imx' binary must be
+flashed into the SD card;
+
+$ sudo dd if=u-boot.imx of=/dev/mmcblk0 bs=512 seek=2; sync
+
+(Note - the SD card node may vary, so adjust this as needed).
+
+- Insert the SD card into the slot located in the bottom of the board (same side
+as the mx6 processor)
+
+- Connect the serial cable to the host PC
+
+- Power up the board and U-boot messages will appear in the serial console.