Add qemu 2.4.0

[kvmfornfv.git] / qemu / roms / u-boot / board / pcs440ep / init.S

diff --git a/qemu/roms/u-boot/board/pcs440ep/init.S b/qemu/roms/u-boot/board/pcs440ep/init.S
new file mode 100644 (file)
index 0000000..c0e83de
--- /dev/null
+++ b/qemu/roms/u-boot/board/pcs440ep/init.S
@@ -0,0 +1,56 @@
+/*
+ * (C) Copyright 2006
+ * Stefan Roese, DENX Software Engineering, sr@denx.de.
+ *
+ * SPDX-License-Identifier:    GPL-2.0+
+ */
+
+#include <asm-offsets.h>
+#include <ppc_asm.tmpl>
+#include <asm/mmu.h>
+#include <config.h>
+
+/**************************************************************************
+ * TLB TABLE
+ *
+ * This table is used by the cpu boot code to setup the initial tlb
+ * entries. Rather than make broad assumptions in the cpu source tree,
+ * this table lets each board set things up however they like.
+ *
+ *  Pointer to the table is returned in r1
+ *
+ *************************************************************************/
+
+    .section .bootpg,"ax"
+    .globl tlbtab
+
+tlbtab:
+       tlbtab_start
+
+       /*
+        * BOOT_CS (FLASH) must be first. Before relocation SA_I can be off to use the
+        * speed up boot process. It is patched after relocation to enable SA_I
+        */
+       tlbentry( CONFIG_SYS_BOOT_BASE_ADDR, SZ_256M, CONFIG_SYS_BOOT_BASE_ADDR, 0, AC_RWX | SA_G/*|SA_I*/)
+
+       /* TLB-entry for init-ram in dcache (SA_I must be turned off!) */
+       tlbentry( CONFIG_SYS_INIT_RAM_ADDR, SZ_64K, CONFIG_SYS_INIT_RAM_ADDR, 0, AC_RWX | SA_G )
+
+       /*
+        * TLB entries for SDRAM are not needed on this platform.
+        * They are dynamically generated in the SPD DDR detection
+        * routine.
+        */
+
+       tlbentry( CONFIG_SYS_PCI_BASE, SZ_256M, CONFIG_SYS_PCI_BASE, 0, AC_RW | SA_IG )
+
+       /* PCI */
+       tlbentry( CONFIG_SYS_PCI_MEMBASE, SZ_256M, CONFIG_SYS_PCI_MEMBASE, 0, AC_RW | SA_IG )
+       tlbentry( CONFIG_SYS_PCI_MEMBASE1, SZ_256M, CONFIG_SYS_PCI_MEMBASE1, 0, AC_RW | SA_IG )
+       tlbentry( CONFIG_SYS_PCI_MEMBASE2, SZ_256M, CONFIG_SYS_PCI_MEMBASE2, 0, AC_RW | SA_IG )
+       tlbentry( CONFIG_SYS_PCI_MEMBASE3, SZ_256M, CONFIG_SYS_PCI_MEMBASE3, 0, AC_RW | SA_IG )
+
+       /* USB 2.0 Device */
+       tlbentry( CONFIG_SYS_USB_DEVICE, SZ_1K, 0x50000000, 0, AC_RW | SA_IG )
+
+       tlbtab_end