--- /dev/null
+/*
+ * Copyright 2007-2012 Freescale Semiconductor, Inc.
+ *
+ * SPDX-License-Identifier: GPL-2.0+
+ */
+
+#include <common.h>
+#include <command.h>
+#include <pci.h>
+#include <asm/processor.h>
+#include <asm/mmu.h>
+#include <asm/cache.h>
+#include <asm/immap_85xx.h>
+#include <asm/fsl_pci.h>
+#include <fsl_ddr_sdram.h>
+#include <asm/io.h>
+#include <asm/fsl_serdes.h>
+#include <miiphy.h>
+#include <libfdt.h>
+#include <fdt_support.h>
+#include <fsl_mdio.h>
+#include <tsec.h>
+#include <asm/fsl_law.h>
+#include <netdev.h>
+
+#include "../common/ngpixis.h"
+#include "../common/sgmii_riser.h"
+
+DECLARE_GLOBAL_DATA_PTR;
+
+int board_early_init_f(void)
+{
+#ifdef CONFIG_MMC
+ ccsr_gur_t *gur = (ccsr_gur_t *)(CONFIG_SYS_MPC85xx_GUTS_ADDR);
+
+ setbits_be32(&gur->pmuxcr,
+ (MPC85xx_PMUXCR_SDHC_CD |
+ MPC85xx_PMUXCR_SDHC_WP));
+#endif
+
+ return 0;
+}
+
+int checkboard(void)
+{
+ u8 sw;
+
+ printf("Board: P2020DS Sys ID: 0x%02x, "
+ "Sys Ver: 0x%02x, FPGA Ver: 0x%02x, ",
+ in_8(&pixis->id), in_8(&pixis->arch), in_8(&pixis->scver));
+
+ sw = in_8(&PIXIS_SW(PIXIS_LBMAP_SWITCH));
+ sw = (sw & PIXIS_LBMAP_MASK) >> PIXIS_LBMAP_SHIFT;
+
+ if (sw < 0x8)
+ /* The lower two bits are the actual vbank number */
+ printf("vBank: %d\n", sw & 3);
+ else
+ puts("Promjet\n");
+
+ return 0;
+}
+
+#if !defined(CONFIG_DDR_SPD)
+/*
+ * Fixed sdram init -- doesn't use serial presence detect.
+ */
+
+phys_size_t fixed_sdram(void)
+{
+ struct ccsr_ddr __iomem *ddr =
+ (struct ccsr_ddr __iomem *)CONFIG_SYS_FSL_DDR_ADDR;
+ uint d_init;
+
+ ddr->cs0_config = CONFIG_SYS_DDR_CS0_CONFIG;
+ ddr->timing_cfg_3 = CONFIG_SYS_DDR_TIMING_3;
+ ddr->timing_cfg_0 = CONFIG_SYS_DDR_TIMING_0;
+ ddr->sdram_mode = CONFIG_SYS_DDR_MODE_1;
+ ddr->sdram_mode_2 = CONFIG_SYS_DDR_MODE_2;
+ ddr->sdram_md_cntl = CONFIG_SYS_DDR_MODE_CTRL;
+ ddr->sdram_interval = CONFIG_SYS_DDR_INTERVAL;
+ ddr->sdram_data_init = CONFIG_SYS_DDR_DATA_INIT;
+ ddr->sdram_clk_cntl = CONFIG_SYS_DDR_CLK_CTRL;
+ ddr->sdram_cfg_2 = CONFIG_SYS_DDR_CONTROL2;
+ ddr->ddr_zq_cntl = CONFIG_SYS_DDR_ZQ_CNTL;
+ ddr->ddr_wrlvl_cntl = CONFIG_SYS_DDR_WRLVL_CNTL;
+ ddr->ddr_cdr1 = CONFIG_SYS_DDR_CDR1;
+ ddr->timing_cfg_4 = CONFIG_SYS_DDR_TIMING_4;
+ ddr->timing_cfg_5 = CONFIG_SYS_DDR_TIMING_5;
+
+ if (!strcmp("performance", getenv("perf_mode"))) {
+ /* Performance Mode Values */
+
+ ddr->cs1_config = CONFIG_SYS_DDR_CS1_CONFIG_PERF;
+ ddr->cs0_bnds = CONFIG_SYS_DDR_CS0_BNDS_PERF;
+ ddr->cs1_bnds = CONFIG_SYS_DDR_CS1_BNDS_PERF;
+ ddr->timing_cfg_1 = CONFIG_SYS_DDR_TIMING_1_PERF;
+ ddr->timing_cfg_2 = CONFIG_SYS_DDR_TIMING_2_PERF;
+
+ asm("sync;isync");
+
+ udelay(500);
+
+ ddr->sdram_cfg = CONFIG_SYS_DDR_CONTROL_PERF;
+ } else {
+ /* Stable Mode Values */
+
+ ddr->cs1_config = CONFIG_SYS_DDR_CS1_CONFIG;
+ ddr->cs0_bnds = CONFIG_SYS_DDR_CS0_BNDS;
+ ddr->cs1_bnds = CONFIG_SYS_DDR_CS1_BNDS;
+ ddr->timing_cfg_1 = CONFIG_SYS_DDR_TIMING_1;
+ ddr->timing_cfg_2 = CONFIG_SYS_DDR_TIMING_2;
+
+ /* ECC will be assumed in stable mode */
+ ddr->err_int_en = CONFIG_SYS_DDR_ERR_INT_EN;
+ ddr->err_disable = CONFIG_SYS_DDR_ERR_DIS;
+ ddr->err_sbe = CONFIG_SYS_DDR_SBE;
+
+ asm("sync;isync");
+
+ udelay(500);
+
+ ddr->sdram_cfg = CONFIG_SYS_DDR_CONTROL;
+ }
+
+#if defined(CONFIG_ECC_INIT_VIA_DDRCONTROLLER)
+ d_init = 1;
+ debug("DDR - 1st controller: memory initializing\n");
+ /*
+ * Poll until memory is initialized.
+ * 512 Meg at 400 might hit this 200 times or so.
+ */
+ while ((ddr->sdram_cfg_2 & (d_init << 4)) != 0)
+ udelay(1000);
+ debug("DDR: memory initialized\n\n");
+ asm("sync; isync");
+ udelay(500);
+#endif
+
+ if (set_ddr_laws(CONFIG_SYS_DDR_SDRAM_BASE,
+ CONFIG_SYS_SDRAM_SIZE * 1024 * 1024,
+ LAW_TRGT_IF_DDR) < 0) {
+ printf("ERROR setting Local Access Windows for DDR\n");
+ return 0;
+ };
+
+ return CONFIG_SYS_SDRAM_SIZE * 1024 * 1024;
+}
+
+#endif
+
+#ifdef CONFIG_PCI
+void pci_init_board(void)
+{
+ fsl_pcie_init_board(0);
+}
+#endif
+
+int board_early_init_r(void)
+{
+ const unsigned int flashbase = CONFIG_SYS_FLASH_BASE;
+ const u8 flash_esel = find_tlb_idx((void *)flashbase, 1);
+
+ /*
+ * Remap Boot flash + PROMJET region to caching-inhibited
+ * so that flash can be erased properly.
+ */
+
+ /* Flush d-cache and invalidate i-cache of any FLASH data */
+ flush_dcache();
+ invalidate_icache();
+
+ /* invalidate existing TLB entry for flash + promjet */
+ disable_tlb(flash_esel);
+
+ set_tlb(1, flashbase, CONFIG_SYS_FLASH_BASE_PHYS,
+ MAS3_SX|MAS3_SW|MAS3_SR, MAS2_I|MAS2_G,
+ 0, flash_esel, BOOKE_PAGESZ_256M, 1);
+
+ return 0;
+}
+
+#ifdef CONFIG_TSEC_ENET
+int board_eth_init(bd_t *bis)
+{
+ struct fsl_pq_mdio_info mdio_info;
+ struct tsec_info_struct tsec_info[4];
+ int num = 0;
+
+#ifdef CONFIG_TSEC1
+ SET_STD_TSEC_INFO(tsec_info[num], 1);
+ num++;
+#endif
+#ifdef CONFIG_TSEC2
+ SET_STD_TSEC_INFO(tsec_info[num], 2);
+ if (is_serdes_configured(SGMII_TSEC2)) {
+ puts("eTSEC2 is in sgmii mode.\n");
+ tsec_info[num].flags |= TSEC_SGMII;
+ }
+ num++;
+#endif
+#ifdef CONFIG_TSEC3
+ SET_STD_TSEC_INFO(tsec_info[num], 3);
+ if (is_serdes_configured(SGMII_TSEC3)) {
+ puts("eTSEC3 is in sgmii mode.\n");
+ tsec_info[num].flags |= TSEC_SGMII;
+}
+ num++;
+#endif
+
+ if (!num) {
+ printf("No TSECs initialized\n");
+
+ return 0;
+ }
+
+#ifdef CONFIG_FSL_SGMII_RISER
+ fsl_sgmii_riser_init(tsec_info, num);
+#endif
+
+ mdio_info.regs = (struct tsec_mii_mng *)CONFIG_SYS_MDIO_BASE_ADDR;
+ mdio_info.name = DEFAULT_MII_NAME;
+
+ fsl_pq_mdio_init(bis, &mdio_info);
+
+ tsec_eth_init(bis, tsec_info, num);
+
+ return pci_eth_init(bis);
+}
+#endif
+
+#if defined(CONFIG_OF_BOARD_SETUP)
+void ft_board_setup(void *blob, bd_t *bd)
+{
+ phys_addr_t base;
+ phys_size_t size;
+
+ ft_cpu_setup(blob, bd);
+
+ base = getenv_bootm_low();
+ size = getenv_bootm_size();
+
+ fdt_fixup_memory(blob, (u64)base, (u64)size);
+
+#ifdef CONFIG_HAS_FSL_DR_USB
+ fdt_fixup_dr_usb(blob, bd);
+#endif
+
+ FT_FSL_PCI_SETUP;
+
+#ifdef CONFIG_FSL_SGMII_RISER
+ fsl_sgmii_riser_fdt_fixup(blob);
+#endif
+}
+#endif
Code Review / kvmfornfv.git / blobdiff