--- /dev/null
+/*
+ * Copyright 2007-2011 Freescale Semiconductor, Inc.
+ *
+ * SPDX-License-Identifier: GPL-2.0+
+ */
+
+#include <common.h>
+#include <command.h>
+#include <pci.h>
+#include <asm/processor.h>
+#include <asm/mmu.h>
+#include <asm/cache.h>
+#include <asm/immap_85xx.h>
+#include <asm/fsl_pci.h>
+#include <fsl_ddr_sdram.h>
+#include <asm/io.h>
+#include <asm/fsl_serdes.h>
+#include <miiphy.h>
+#include <libfdt.h>
+#include <fdt_support.h>
+#include <tsec.h>
+#include <fsl_mdio.h>
+#include <netdev.h>
+
+#include "../common/sgmii_riser.h"
+
+int checkboard (void)
+{
+ u8 vboot;
+ u8 *pixis_base = (u8 *)PIXIS_BASE;
+
+ printf("Board: MPC8572DS Sys ID: 0x%02x, "
+ "Sys Ver: 0x%02x, FPGA Ver: 0x%02x, ",
+ in_8(pixis_base + PIXIS_ID), in_8(pixis_base + PIXIS_VER),
+ in_8(pixis_base + PIXIS_PVER));
+
+ vboot = in_8(pixis_base + PIXIS_VBOOT);
+ switch ((vboot & PIXIS_VBOOT_LBMAP) >> 6) {
+ case PIXIS_VBOOT_LBMAP_NOR0:
+ puts ("vBank: 0\n");
+ break;
+ case PIXIS_VBOOT_LBMAP_PJET:
+ puts ("Promjet\n");
+ break;
+ case PIXIS_VBOOT_LBMAP_NAND:
+ puts ("NAND\n");
+ break;
+ case PIXIS_VBOOT_LBMAP_NOR1:
+ puts ("vBank: 1\n");
+ break;
+ }
+
+ return 0;
+}
+
+
+#if !defined(CONFIG_SPD_EEPROM)
+/*
+ * Fixed sdram init -- doesn't use serial presence detect.
+ */
+
+phys_size_t fixed_sdram (void)
+{
+ volatile immap_t *immap = (immap_t *)CONFIG_SYS_IMMR;
+ struct ccsr_ddr __iomem *ddr = &immap->im_ddr;
+ uint d_init;
+
+ ddr->cs0_bnds = CONFIG_SYS_DDR_CS0_BNDS;
+ ddr->cs0_config = CONFIG_SYS_DDR_CS0_CONFIG;
+
+ ddr->timing_cfg_3 = CONFIG_SYS_DDR_TIMING_3;
+ ddr->timing_cfg_0 = CONFIG_SYS_DDR_TIMING_0;
+ ddr->timing_cfg_1 = CONFIG_SYS_DDR_TIMING_1;
+ ddr->timing_cfg_2 = CONFIG_SYS_DDR_TIMING_2;
+ ddr->sdram_mode = CONFIG_SYS_DDR_MODE_1;
+ ddr->sdram_mode_2 = CONFIG_SYS_DDR_MODE_2;
+ ddr->sdram_interval = CONFIG_SYS_DDR_INTERVAL;
+ ddr->sdram_data_init = CONFIG_SYS_DDR_DATA_INIT;
+ ddr->sdram_clk_cntl = CONFIG_SYS_DDR_CLK_CTRL;
+ ddr->sdram_cfg_2 = CONFIG_SYS_DDR_CONTROL2;
+
+#if defined (CONFIG_DDR_ECC)
+ ddr->err_int_en = CONFIG_SYS_DDR_ERR_INT_EN;
+ ddr->err_disable = CONFIG_SYS_DDR_ERR_DIS;
+ ddr->err_sbe = CONFIG_SYS_DDR_SBE;
+#endif
+ asm("sync;isync");
+
+ udelay(500);
+
+ ddr->sdram_cfg = CONFIG_SYS_DDR_CONTROL;
+
+#if defined(CONFIG_ECC_INIT_VIA_DDRCONTROLLER)
+ d_init = 1;
+ debug("DDR - 1st controller: memory initializing\n");
+ /*
+ * Poll until memory is initialized.
+ * 512 Meg at 400 might hit this 200 times or so.
+ */
+ while ((ddr->sdram_cfg_2 & (d_init << 4)) != 0) {
+ udelay(1000);
+ }
+ debug("DDR: memory initialized\n\n");
+ asm("sync; isync");
+ udelay(500);
+#endif
+
+ return 512 * 1024 * 1024;
+}
+
+#endif
+
+#ifdef CONFIG_PCI
+void pci_init_board(void)
+{
+ struct pci_controller *hose;
+
+ fsl_pcie_init_board(0);
+
+ hose = find_hose_by_cfg_addr((void *)(CONFIG_SYS_PCIE3_ADDR));
+
+ if (hose) {
+ u32 temp32;
+ u8 uli_busno = hose->first_busno + 2;
+
+ /*
+ * Activate ULI1575 legacy chip by performing a fake
+ * memory access. Needed to make ULI RTC work.
+ * Device 1d has the first on-board memory BAR.
+ */
+ pci_hose_read_config_dword(hose, PCI_BDF(uli_busno, 0x1d, 0),
+ PCI_BASE_ADDRESS_1, &temp32);
+
+ if (temp32 >= CONFIG_SYS_PCIE3_MEM_BUS) {
+ void *p = pci_mem_to_virt(PCI_BDF(uli_busno, 0x1d, 0),
+ temp32, 4, 0);
+ debug(" uli1572 read to %p\n", p);
+ in_be32(p);
+ }
+ }
+}
+#endif
+
+int board_early_init_r(void)
+{
+ const unsigned int flashbase = CONFIG_SYS_FLASH_BASE;
+ const u8 flash_esel = find_tlb_idx((void *)flashbase, 1);
+
+ /*
+ * Remap Boot flash + PROMJET region to caching-inhibited
+ * so that flash can be erased properly.
+ */
+
+ /* Flush d-cache and invalidate i-cache of any FLASH data */
+ flush_dcache();
+ invalidate_icache();
+
+ /* invalidate existing TLB entry for flash + promjet */
+ disable_tlb(flash_esel);
+
+ set_tlb(1, flashbase, CONFIG_SYS_FLASH_BASE_PHYS, /* tlb, epn, rpn */
+ MAS3_SX|MAS3_SW|MAS3_SR, MAS2_I|MAS2_G, /* perms, wimge */
+ 0, flash_esel, BOOKE_PAGESZ_256M, 1); /* ts, esel, tsize, iprot */
+
+ return 0;
+}
+
+#ifdef CONFIG_TSEC_ENET
+int board_eth_init(bd_t *bis)
+{
+ struct fsl_pq_mdio_info mdio_info;
+ struct tsec_info_struct tsec_info[4];
+ int num = 0;
+
+#ifdef CONFIG_TSEC1
+ SET_STD_TSEC_INFO(tsec_info[num], 1);
+ if (is_serdes_configured(SGMII_TSEC1)) {
+ puts("eTSEC1 is in sgmii mode.\n");
+ tsec_info[num].flags |= TSEC_SGMII;
+ }
+ num++;
+#endif
+#ifdef CONFIG_TSEC2
+ SET_STD_TSEC_INFO(tsec_info[num], 2);
+ if (is_serdes_configured(SGMII_TSEC2)) {
+ puts("eTSEC2 is in sgmii mode.\n");
+ tsec_info[num].flags |= TSEC_SGMII;
+ }
+ num++;
+#endif
+#ifdef CONFIG_TSEC3
+ SET_STD_TSEC_INFO(tsec_info[num], 3);
+ if (is_serdes_configured(SGMII_TSEC3)) {
+ puts("eTSEC3 is in sgmii mode.\n");
+ tsec_info[num].flags |= TSEC_SGMII;
+ }
+ num++;
+#endif
+#ifdef CONFIG_TSEC4
+ SET_STD_TSEC_INFO(tsec_info[num], 4);
+ if (is_serdes_configured(SGMII_TSEC4)) {
+ puts("eTSEC4 is in sgmii mode.\n");
+ tsec_info[num].flags |= TSEC_SGMII;
+ }
+ num++;
+#endif
+
+ if (!num) {
+ printf("No TSECs initialized\n");
+
+ return 0;
+ }
+
+#ifdef CONFIG_FSL_SGMII_RISER
+ fsl_sgmii_riser_init(tsec_info, num);
+#endif
+
+ mdio_info.regs = (struct tsec_mii_mng *)CONFIG_SYS_MDIO_BASE_ADDR;
+ mdio_info.name = DEFAULT_MII_NAME;
+ fsl_pq_mdio_init(bis, &mdio_info);
+
+ tsec_eth_init(bis, tsec_info, num);
+
+ return pci_eth_init(bis);
+}
+#endif
+
+#if defined(CONFIG_OF_BOARD_SETUP)
+void ft_board_setup(void *blob, bd_t *bd)
+{
+ phys_addr_t base;
+ phys_size_t size;
+
+ ft_cpu_setup(blob, bd);
+
+ base = getenv_bootm_low();
+ size = getenv_bootm_size();
+
+ fdt_fixup_memory(blob, (u64)base, (u64)size);
+
+ FT_FSL_PCI_SETUP;
+
+#ifdef CONFIG_FSL_SGMII_RISER
+ fsl_sgmii_riser_fdt_fixup(blob);
+#endif
+}
+#endif
Code Review / kvmfornfv.git / blobdiff