--- /dev/null
+/*
+ * (C) Copyright 2002
+ * Sysgo Real-Time Solutions, GmbH <www.elinos.com>
+ * Marius Groeger <mgroeger@sysgo.de>
+ *
+ * (C) Copyright 2002
+ * David Mueller, ELSOFT AG, <d.mueller@elsoft.ch>
+ *
+ * (C) Copyright 2003
+ * Texas Instruments, <www.ti.com>
+ * Kshitij Gupta <Kshitij@ti.com>
+ *
+ * (C) Copyright 2004
+ * ARM Ltd.
+ * Philippe Robin, <philippe.robin@arm.com>
+ *
+ * SPDX-License-Identifier: GPL-2.0+
+ */
+
+#include <common.h>
+#include <netdev.h>
+#include <asm/io.h>
+#include "arm-ebi.h"
+#include "integrator-sc.h"
+
+DECLARE_GLOBAL_DATA_PTR;
+
+void peripheral_power_enable (void);
+
+#if defined(CONFIG_SHOW_BOOT_PROGRESS)
+void show_boot_progress(int progress)
+{
+ printf("Boot reached stage %d\n", progress);
+}
+#endif
+
+#define COMP_MODE_ENABLE ((unsigned int)0x0000EAEF)
+
+/*
+ * Miscellaneous platform dependent initialisations
+ */
+
+int board_init (void)
+{
+ u32 val;
+
+ /* arch number of Integrator Board */
+#ifdef CONFIG_ARCH_CINTEGRATOR
+ gd->bd->bi_arch_number = MACH_TYPE_CINTEGRATOR;
+#else
+ gd->bd->bi_arch_number = MACH_TYPE_INTEGRATOR;
+#endif
+
+ /* adress of boot parameters */
+ gd->bd->bi_boot_params = 0x00000100;
+
+ gd->flags = 0;
+
+#ifdef CONFIG_CM_REMAP
+extern void cm_remap(void);
+ cm_remap(); /* remaps writeable memory to 0x00000000 */
+#endif
+
+#ifdef CONFIG_ARCH_CINTEGRATOR
+ /*
+ * Flash protection on the Integrator/CP is in a simple register
+ */
+ val = readl(CP_FLASHPROG);
+ val |= (CP_FLASHPROG_FLVPPEN | CP_FLASHPROG_FLWREN);
+ writel(val, CP_FLASHPROG);
+#else
+ /*
+ * The Integrator/AP has some special protection mechanisms
+ * for the external memories, first the External Bus Interface (EBI)
+ * then the system controller (SC).
+ *
+ * The system comes up with the flash memory non-writable and
+ * configuration locked. If we want U-Boot to be used for flash
+ * access we cannot have the flash memory locked.
+ */
+ writel(EBI_UNLOCK_MAGIC, EBI_BASE + EBI_LOCK_REG);
+ val = readl(EBI_BASE + EBI_CSR1_REG);
+ val &= EBI_CSR_WREN_MASK;
+ val |= EBI_CSR_WREN_ENABLE;
+ writel(val, EBI_BASE + EBI_CSR1_REG);
+ writel(0, EBI_BASE + EBI_LOCK_REG);
+
+ /*
+ * Set up the system controller to remove write protection from
+ * the flash memory and enable Vpp
+ */
+ writel(SC_CTRL_FLASHVPP | SC_CTRL_FLASHWP, SC_CTRLS);
+#endif
+
+ icache_enable ();
+
+ return 0;
+}
+
+int misc_init_r (void)
+{
+ setenv("verify", "n");
+ return (0);
+}
+
+/*
+ * The Integrator remaps the Flash memory to 0x00000000 and executes U-Boot
+ * from there, which means we cannot test the RAM underneath the ROM at this
+ * point. It will be unmapped later on, when we are executing from the
+ * relocated in RAM U-Boot. We simply assume that this RAM is usable if the
+ * RAM on higher addresses works fine.
+ */
+#define REMAPPED_FLASH_SZ 0x40000
+
+int dram_init (void)
+{
+ gd->bd->bi_dram[0].start = CONFIG_SYS_SDRAM_BASE;
+#ifdef CONFIG_CM_SPD_DETECT
+ {
+extern void dram_query(void);
+ u32 cm_reg_sdram;
+ u32 sdram_shift;
+
+ dram_query(); /* Assembler accesses to CM registers */
+ /* Queries the SPD values */
+
+ /* Obtain the SDRAM size from the CM SDRAM register */
+
+ cm_reg_sdram = readl(CM_BASE + OS_SDRAM);
+ /* Register SDRAM size
+ *
+ * 0xXXXXXXbbb000bb 16 MB
+ * 0xXXXXXXbbb001bb 32 MB
+ * 0xXXXXXXbbb010bb 64 MB
+ * 0xXXXXXXbbb011bb 128 MB
+ * 0xXXXXXXbbb100bb 256 MB
+ *
+ */
+ sdram_shift = ((cm_reg_sdram & 0x0000001C)/4)%4;
+ gd->ram_size = get_ram_size((long *) CONFIG_SYS_SDRAM_BASE +
+ REMAPPED_FLASH_SZ,
+ 0x01000000 << sdram_shift);
+ }
+#else
+ gd->ram_size = get_ram_size((long *) CONFIG_SYS_SDRAM_BASE +
+ REMAPPED_FLASH_SZ,
+ PHYS_SDRAM_1_SIZE);
+#endif /* CM_SPD_DETECT */
+ /* We only have one bank of RAM, set it to whatever was detected */
+ gd->bd->bi_dram[0].size = gd->ram_size;
+
+ return 0;
+}
+
+#ifdef CONFIG_CMD_NET
+int board_eth_init(bd_t *bis)
+{
+ int rc = 0;
+#ifdef CONFIG_SMC91111
+ rc = smc91111_initialize(0, CONFIG_SMC91111_BASE);
+#endif
+ rc += pci_eth_init(bis);
+ return rc;
+}
+#endif
Code Review / kvmfornfv.git / blobdiff