Add qemu 2.4.0

[kvmfornfv.git] / qemu / roms / u-boot / board / altera / socfpga / pinmux_config.h

diff --git a/qemu/roms/u-boot/board/altera/socfpga/pinmux_config.h b/qemu/roms/u-boot/board/altera/socfpga/pinmux_config.h
new file mode 100644 (file)
index 0000000..f278f2b
--- /dev/null
+++ b/qemu/roms/u-boot/board/altera/socfpga/pinmux_config.h
@@ -0,0 +1,54 @@
+/* This file is generated by Preloader Generator */
+
+#ifndef _PRELOADER_PINMUX_CONFIG_H_
+#define _PRELOADER_PINMUX_CONFIG_H_
+
+/*
+ * State of enabling for which IP connected out through the muxing.
+ * Value 1 mean the IP connection is muxed out
+ */
+#define CONFIG_HPS_EMAC0               (0)
+#define CONFIG_HPS_EMAC1               (1)
+#define CONFIG_HPS_USB0                        (0)
+#define CONFIG_HPS_USB1                        (1)
+#define CONFIG_HPS_NAND                        (0)
+#define CONFIG_HPS_SDMMC               (1)
+#define CONFIG_HPS_QSPI                        (1)
+#define CONFIG_HPS_UART0               (1)
+#define CONFIG_HPS_UART1               (0)
+#define CONFIG_HPS_TRACE               (1)
+#define CONFIG_HPS_I2C0                        (1)
+#define CONFIG_HPS_I2C1                        (0)
+#define CONFIG_HPS_I2C2                        (0)
+#define CONFIG_HPS_I2C3                        (0)
+#define CONFIG_HPS_SPIM0               (1)
+#define CONFIG_HPS_SPIM1               (0)
+#define CONFIG_HPS_SPIS0               (0)
+#define CONFIG_HPS_SPIS1               (0)
+#define CONFIG_HPS_CAN0                        (1)
+#define CONFIG_HPS_CAN1                        (0)
+
+/* IP attribute value (which affected by pin muxing configuration) */
+#define CONFIG_HPS_SDMMC_BUSWIDTH      (4)
+
+/* 1 if the pins are connected out */
+#define CONFIG_HPS_QSPI_CS0            (1)
+#define CONFIG_HPS_QSPI_CS1            (0)
+#define CONFIG_HPS_QSPI_CS2            (0)
+#define CONFIG_HPS_QSPI_CS3            (0)
+
+/* UART */
+/* 1 means the pin is mux out or available */
+#define CONFIG_HPS_UART0_TX            (1)
+#define CONFIG_HPS_UART0_RX            (1)
+#define CONFIG_HPS_UART0_CTS           (0)
+#define CONFIG_HPS_UART0_RTS           (0)
+#define CONFIG_HPS_UART1_TX            (0)
+#define CONFIG_HPS_UART1_RX            (0)
+#define CONFIG_HPS_UART1_CTS           (0)
+#define CONFIG_HPS_UART1_RTS           (0)
+
+/* Pin mux data */
+#define CONFIG_HPS_PINMUX_NUM          (207)
+
+#endif /* _PRELOADER_PINMUX_CONFIG_H_ */