--- /dev/null
+/*
+ * Startup Code for MIPS64 CPU-core
+ *
+ * Copyright (c) 2003 Wolfgang Denk <wd@denx.de>
+ *
+ * SPDX-License-Identifier: GPL-2.0+
+ */
+
+#include <asm-offsets.h>
+#include <config.h>
+#include <asm/regdef.h>
+#include <asm/mipsregs.h>
+
+#ifndef CONFIG_SYS_MIPS_CACHE_MODE
+#define CONFIG_SYS_MIPS_CACHE_MODE CONF_CM_CACHABLE_NONCOHERENT
+#endif
+
+#ifdef CONFIG_SYS_LITTLE_ENDIAN
+#define MIPS64_R_INFO(ssym, r_type3, r_type2, r_type) \
+ (((r_type) << 24) | ((r_type2) << 16) | ((r_type3) << 8) | (ssym))
+#else
+#define MIPS64_R_INFO(ssym, r_type3, r_type2, r_type) \
+ ((r_type) | ((r_type2) << 8) | ((r_type3) << 16) | (ssym) << 24)
+#endif
+
+ /*
+ * For the moment disable interrupts, mark the kernel mode and
+ * set ST0_KX so that the CPU does not spit fire when using
+ * 64-bit addresses.
+ */
+ .macro setup_c0_status set clr
+ .set push
+ mfc0 t0, CP0_STATUS
+ or t0, ST0_CU0 | \set | 0x1f | \clr
+ xor t0, 0x1f | \clr
+ mtc0 t0, CP0_STATUS
+ .set noreorder
+ sll zero, 3 # ehb
+ .set pop
+ .endm
+
+ .set noreorder
+
+ .globl _start
+ .text
+_start:
+ /* U-boot entry point */
+ b reset
+ nop
+
+ .org 0x200
+ /* TLB refill, 32 bit task */
+1: b 1b
+ nop
+
+ .org 0x280
+ /* XTLB refill, 64 bit task */
+1: b 1b
+ nop
+
+ .org 0x300
+ /* Cache error exception */
+1: b 1b
+ nop
+
+ .org 0x380
+ /* General exception */
+1: b 1b
+ nop
+
+ .org 0x400
+ /* Catch interrupt exceptions */
+1: b 1b
+ nop
+
+ .org 0x480
+ /* EJTAG debug exception */
+1: b 1b
+ nop
+
+ .align 4
+reset:
+
+ /* Clear watch registers */
+ dmtc0 zero, CP0_WATCHLO
+ dmtc0 zero, CP0_WATCHHI
+
+ /* WP(Watch Pending), SW0/1 should be cleared */
+ mtc0 zero, CP0_CAUSE
+
+ setup_c0_status ST0_KX 0
+
+ /* Init Timer */
+ mtc0 zero, CP0_COUNT
+ mtc0 zero, CP0_COMPARE
+
+#ifndef CONFIG_SKIP_LOWLEVEL_INIT
+ /* CONFIG0 register */
+ dli t0, CONF_CM_UNCACHED
+ mtc0 t0, CP0_CONFIG
+#endif
+
+ /*
+ * Initialize $gp, force 8 byte alignment of bal instruction to forbid
+ * the compiler to put nop's between bal and _gp. This is required to
+ * keep _gp and ra aligned to 8 byte.
+ */
+ .align 3
+ bal 1f
+ nop
+ .dword _gp
+1:
+ ld gp, 0(ra)
+
+#ifndef CONFIG_SKIP_LOWLEVEL_INIT
+ /* Initialize any external memory */
+ dla t9, lowlevel_init
+ jalr t9
+ nop
+
+ /* Initialize caches... */
+ dla t9, mips_cache_reset
+ jalr t9
+ nop
+
+ /* ... and enable them */
+ dli t0, CONFIG_SYS_MIPS_CACHE_MODE
+ mtc0 t0, CP0_CONFIG
+#endif
+
+ /* Set up temporary stack */
+ dli sp, CONFIG_SYS_SDRAM_BASE + CONFIG_SYS_INIT_SP_OFFSET
+
+ dla t9, board_init_f
+ jr t9
+ nop
+
+/*
+ * void relocate_code (addr_sp, gd, addr_moni)
+ *
+ * This "function" does not return, instead it continues in RAM
+ * after relocating the monitor code.
+ *
+ * a0 = addr_sp
+ * a1 = gd
+ * a2 = destination address
+ */
+ .globl relocate_code
+ .ent relocate_code
+relocate_code:
+ move sp, a0 # set new stack pointer
+
+ move s0, a1 # save gd in s0
+ move s2, a2 # save destination address in s2
+
+ dli t0, CONFIG_SYS_MONITOR_BASE
+ dsub s1, s2, t0 # s1 <-- relocation offset
+
+ dla t3, in_ram
+ ld t2, -24(t3) # t2 <-- __image_copy_end
+ move t1, a2
+
+ dadd gp, s1 # adjust gp
+
+ /*
+ * t0 = source address
+ * t1 = target address
+ * t2 = source end address
+ */
+1:
+ lw t3, 0(t0)
+ sw t3, 0(t1)
+ daddu t0, 4
+ blt t0, t2, 1b
+ daddu t1, 4
+
+ /* If caches were enabled, we would have to flush them here. */
+ dsub a1, t1, s2 # a1 <-- size
+ dla t9, flush_cache
+ jalr t9
+ move a0, s2 # a0 <-- destination address
+
+ /* Jump to where we've relocated ourselves */
+ daddi t0, s2, in_ram - _start
+ jr t0
+ nop
+
+ .dword __rel_dyn_end
+ .dword __rel_dyn_start
+ .dword __image_copy_end
+ .dword _GLOBAL_OFFSET_TABLE_
+ .dword num_got_entries
+
+in_ram:
+ /*
+ * Now we want to update GOT.
+ *
+ * GOT[0] is reserved. GOT[1] is also reserved for the dynamic object
+ * generated by GNU ld. Skip these reserved entries from relocation.
+ */
+ ld t3, -8(t0) # t3 <-- num_got_entries
+ ld t8, -16(t0) # t8 <-- _GLOBAL_OFFSET_TABLE_
+ dadd t8, s1 # t8 now holds relocated _G_O_T_
+ daddi t8, t8, 16 # skipping first two entries
+ dli t2, 2
+1:
+ ld t1, 0(t8)
+ beqz t1, 2f
+ dadd t1, s1
+ sd t1, 0(t8)
+2:
+ daddi t2, 1
+ blt t2, t3, 1b
+ daddi t8, 8
+
+ /* Update dynamic relocations */
+ ld t1, -32(t0) # t1 <-- __rel_dyn_start
+ ld t2, -40(t0) # t2 <-- __rel_dyn_end
+
+ b 2f # skip first reserved entry
+ daddi t1, 16
+
+1:
+ lw t8, -4(t1) # t8 <-- relocation info
+
+ dli t3, MIPS64_R_INFO(0x00, 0x00, 0x12, 0x03)
+ bne t8, t3, 2f # skip non R_MIPS_REL32 entries
+ nop
+
+ ld t3, -16(t1) # t3 <-- location to fix up in FLASH
+
+ ld t8, 0(t3) # t8 <-- original pointer
+ dadd t8, s1 # t8 <-- adjusted pointer
+
+ dadd t3, s1 # t3 <-- location to fix up in RAM
+ sd t8, 0(t3)
+
+2:
+ blt t1, t2, 1b
+ daddi t1, 16 # each rel.dyn entry is 16 bytes
+
+ /*
+ * Clear BSS
+ *
+ * GOT is now relocated. Thus __bss_start and __bss_end can be
+ * accessed directly via $gp.
+ */
+ dla t1, __bss_start # t1 <-- __bss_start
+ dla t2, __bss_end # t2 <-- __bss_end
+
+1:
+ sd zero, 0(t1)
+ blt t1, t2, 1b
+ daddi t1, 8
+
+ move a0, s0 # a0 <-- gd
+ dla t9, board_init_r
+ jr t9
+ move a1, s2
+
+ .end relocate_code
Code Review / kvmfornfv.git / blobdiff