--- /dev/null
+#ifndef __AHCI_H
+#define __AHCI_H
+
+#include "block.h" // struct drive_s
+#include "types.h" // u32
+
+struct sata_cmd_fis {
+ u8 reg;
+ u8 pmp_type;
+ u8 command;
+ u8 feature;
+
+ u8 lba_low;
+ u8 lba_mid;
+ u8 lba_high;
+ u8 device;
+
+ u8 lba_low2;
+ u8 lba_mid2;
+ u8 lba_high2;
+ u8 feature2;
+
+ u8 sector_count;
+ u8 sector_count2;
+ u8 res_1;
+ u8 control;
+
+ u8 res_2[64 - 16];
+};
+
+struct ahci_ctrl_s {
+ struct pci_device *pci_tmp;
+ u16 pci_bdf;
+ u8 irq;
+ u32 iobase;
+ u32 caps;
+ u32 ports;
+};
+
+struct ahci_cmd_s {
+ struct sata_cmd_fis fis;
+ u8 atapi[0x20];
+ u8 res[0x20];
+ struct {
+ u32 base;
+ u32 baseu;
+ u32 res;
+ u32 flags;
+ } prdt[];
+};
+
+/* command list */
+struct ahci_list_s {
+ u32 flags;
+ u32 bytes;
+ u32 base;
+ u32 baseu;
+ u32 res[4];
+};
+
+struct ahci_fis_s {
+ u8 dsfis[0x1c]; /* dma setup */
+ u8 res_1[0x04];
+ u8 psfis[0x14]; /* pio setup */
+ u8 res_2[0x0c];
+ u8 rfis[0x14]; /* d2h register */
+ u8 res_3[0x04];
+ u8 sdbfis[0x08]; /* set device bits */
+ u8 ufis[0x40]; /* unknown */
+ u8 res_4[0x60];
+};
+
+struct ahci_port_s {
+ struct drive_s drive;
+ struct ahci_ctrl_s *ctrl;
+ struct ahci_list_s *list;
+ struct ahci_fis_s *fis;
+ struct ahci_cmd_s *cmd;
+ u32 pnr;
+ u32 atapi;
+ char *desc;
+ int prio;
+};
+
+void ahci_setup(void);
+int process_ahci_op(struct disk_op_s *op);
+int ahci_cmd_data(struct disk_op_s *op, void *cdbcmd, u16 blocksize);
+
+#define AHCI_IRQ_ON_SG (1 << 31)
+#define AHCI_CMD_ATAPI (1 << 5)
+#define AHCI_CMD_WRITE (1 << 6)
+#define AHCI_CMD_PREFETCH (1 << 7)
+#define AHCI_CMD_RESET (1 << 8)
+#define AHCI_CMD_CLR_BUSY (1 << 10)
+
+#define RX_FIS_D2H_REG 0x40 /* offset of D2H Register FIS data */
+#define RX_FIS_SDB 0x58 /* offset of SDB FIS data */
+#define RX_FIS_UNK 0x60 /* offset of Unknown FIS data */
+
+/* global controller registers */
+#define HOST_CAP 0x00 /* host capabilities */
+#define HOST_CTL 0x04 /* global host control */
+#define HOST_IRQ_STAT 0x08 /* interrupt status */
+#define HOST_PORTS_IMPL 0x0c /* bitmap of implemented ports */
+#define HOST_VERSION 0x10 /* AHCI spec. version compliancy */
+
+/* HOST_CTL bits */
+#define HOST_CTL_RESET (1 << 0) /* reset controller; self-clear */
+#define HOST_CTL_IRQ_EN (1 << 1) /* global IRQ enable */
+#define HOST_CTL_AHCI_EN (1 << 31) /* AHCI enabled */
+
+/* HOST_CAP bits */
+#define HOST_CAP_SSC (1 << 14) /* Slumber capable */
+#define HOST_CAP_AHCI (1 << 18) /* AHCI only */
+#define HOST_CAP_CLO (1 << 24) /* Command List Override support */
+#define HOST_CAP_SSS (1 << 27) /* Staggered Spin-up */
+#define HOST_CAP_NCQ (1 << 30) /* Native Command Queueing */
+#define HOST_CAP_64 (1 << 31) /* PCI DAC (64-bit DMA) support */
+
+/* registers for each SATA port */
+#define PORT_LST_ADDR 0x00 /* command list DMA addr */
+#define PORT_LST_ADDR_HI 0x04 /* command list DMA addr hi */
+#define PORT_FIS_ADDR 0x08 /* FIS rx buf addr */
+#define PORT_FIS_ADDR_HI 0x0c /* FIS rx buf addr hi */
+#define PORT_IRQ_STAT 0x10 /* interrupt status */
+#define PORT_IRQ_MASK 0x14 /* interrupt enable/disable mask */
+#define PORT_CMD 0x18 /* port command */
+#define PORT_TFDATA 0x20 /* taskfile data */
+#define PORT_SIG 0x24 /* device TF signature */
+#define PORT_SCR_STAT 0x28 /* SATA phy register: SStatus */
+#define PORT_SCR_CTL 0x2c /* SATA phy register: SControl */
+#define PORT_SCR_ERR 0x30 /* SATA phy register: SError */
+#define PORT_SCR_ACT 0x34 /* SATA phy register: SActive */
+#define PORT_CMD_ISSUE 0x38 /* command issue */
+#define PORT_RESERVED 0x3c /* reserved */
+
+/* PORT_IRQ_{STAT,MASK} bits */
+#define PORT_IRQ_COLD_PRES (1 << 31) /* cold presence detect */
+#define PORT_IRQ_TF_ERR (1 << 30) /* task file error */
+#define PORT_IRQ_HBUS_ERR (1 << 29) /* host bus fatal error */
+#define PORT_IRQ_HBUS_DATA_ERR (1 << 28) /* host bus data error */
+#define PORT_IRQ_IF_ERR (1 << 27) /* interface fatal error */
+#define PORT_IRQ_IF_NONFATAL (1 << 26) /* interface non-fatal error */
+#define PORT_IRQ_OVERFLOW (1 << 24) /* xfer exhausted available S/G */
+#define PORT_IRQ_BAD_PMP (1 << 23) /* incorrect port multiplier */
+
+#define PORT_IRQ_PHYRDY (1 << 22) /* PhyRdy changed */
+#define PORT_IRQ_DEV_ILCK (1 << 7) /* device interlock */
+#define PORT_IRQ_CONNECT (1 << 6) /* port connect change status */
+#define PORT_IRQ_SG_DONE (1 << 5) /* descriptor processed */
+#define PORT_IRQ_UNK_FIS (1 << 4) /* unknown FIS rx'd */
+#define PORT_IRQ_SDB_FIS (1 << 3) /* Set Device Bits FIS rx'd */
+#define PORT_IRQ_DMAS_FIS (1 << 2) /* DMA Setup FIS rx'd */
+#define PORT_IRQ_PIOS_FIS (1 << 1) /* PIO Setup FIS rx'd */
+#define PORT_IRQ_D2H_REG_FIS (1 << 0) /* D2H Register FIS rx'd */
+
+#define PORT_IRQ_FREEZE (PORT_IRQ_HBUS_ERR | PORT_IRQ_IF_ERR | \
+ PORT_IRQ_CONNECT | PORT_IRQ_PHYRDY | \
+ PORT_IRQ_UNK_FIS)
+#define PORT_IRQ_ERROR (PORT_IRQ_FREEZE | PORT_IRQ_TF_ERR | \
+ PORT_IRQ_HBUS_DATA_ERR)
+#define DEF_PORT_IRQ (PORT_IRQ_ERROR | PORT_IRQ_SG_DONE | \
+ PORT_IRQ_SDB_FIS | PORT_IRQ_DMAS_FIS | \
+ PORT_IRQ_PIOS_FIS | PORT_IRQ_D2H_REG_FIS)
+
+/* PORT_CMD bits */
+#define PORT_CMD_ATAPI (1 << 24) /* Device is ATAPI */
+#define PORT_CMD_LIST_ON (1 << 15) /* cmd list DMA engine running */
+#define PORT_CMD_FIS_ON (1 << 14) /* FIS DMA engine running */
+#define PORT_CMD_FIS_RX (1 << 4) /* Enable FIS receive DMA engine */
+#define PORT_CMD_CLO (1 << 3) /* Command list override */
+#define PORT_CMD_POWER_ON (1 << 2) /* Power up device */
+#define PORT_CMD_SPIN_UP (1 << 1) /* Spin up device */
+#define PORT_CMD_START (1 << 0) /* Enable port DMA engine */
+
+#define PORT_CMD_ICC_MASK (0xf << 28) /* i/f ICC state mask */
+#define PORT_CMD_ICC_ACTIVE (0x1 << 28) /* Put i/f in active state */
+#define PORT_CMD_ICC_PARTIAL (0x2 << 28) /* Put i/f in partial state */
+#define PORT_CMD_ICC_SLUMBER (0x6 << 28) /* Put i/f in slumber state */
+
+#define PORT_IRQ_STAT_DHRS (1 << 0) /* Device to Host Register FIS */
+#define PORT_IRQ_STAT_PSS (1 << 1) /* PIO Setup FIS */
+#define PORT_IRQ_STAT_DSS (1 << 2) /* DMA Setup FIS */
+#define PORT_IRQ_STAT_SDBS (1 << 3) /* Set Device Bits */
+#define PORT_IRQ_STAT_UFS (1 << 4) /* Unknown FIS */
+#define PORT_IRQ_STAT_DPS (1 << 5) /* Descriptor Processed */
+#define PORT_IRQ_STAT_PCS (1 << 6) /* Port Connect Change Status */
+#define PORT_IRQ_STAT_DMPS (1 << 7) /* Device Mechanical Presence
+ Status */
+#define PORT_IRQ_STAT_PRCS (1 << 22) /* File Ready Status */
+#define PORT_IRQ_STAT_IPMS (1 << 23) /* Incorrect Port Multiplier
+ Status */
+#define PORT_IRQ_STAT_OFS (1 << 24) /* Overflow Status */
+#define PORT_IRQ_STAT_INFS (1 << 26) /* Interface Non-Fatal Error
+ Status */
+#define PORT_IRQ_STAT_IFS (1 << 27) /* Interface Fatal Error */
+#define PORT_IRQ_STAT_HBDS (1 << 28) /* Host Bus Data Error Status */
+#define PORT_IRQ_STAT_HBFS (1 << 29) /* Host Bus Fatal Error Status */
+#define PORT_IRQ_STAT_TFES (1 << 30) /* Task File Error Status */
+#define PORT_IRQ_STAT_CPDS (1 << 31) /* Code Port Detect Status */
+
+#endif // ahci.h
Code Review / kvmfornfv.git / blobdiff