--- /dev/null
+/* Addresses, interrupt numbers, register sizes */
+
+#define SLAVIO_ZS 0x00000000ULL
+#define SLAVIO_ZS1 0x00100000ULL
+#define ZS_INTR 0x2c
+
+#define SLAVIO_NVRAM 0x00200000ULL
+#define NVRAM_SIZE 0x2000
+#define NVRAM_IDPROM 0x1fd8
+
+#define SLAVIO_FD 0x00400000ULL
+#define FD_REGS 15
+#define FD_INTR 0x2b
+
+#define SLAVIO_SCONFIG 0x00800000ULL
+#define SCONFIG_REGS 1
+
+#define AUXIO_REGS 1
+
+#define AUXIO2_REGS 1
+#define AUXIO2_INTR 0x22
+
+#define SLAVIO_COUNTER 0x00d00000ULL
+#define COUNTER_REGS 0x10
+
+#define SLAVIO_INTERRUPT 0x00e00000ULL
+#define INTERRUPT_REGS 0x10
+
+#define SLAVIO_RESET 0x00f00000ULL
+#define RESET_REGS 1
+
+#define ECC_BASE 0xf00000000ULL
+#define ECC_SIZE 0x20
+
+#define SLAVIO_SIZE 0x01000000
+
+#define SUN4M_NCPUS 16
+
+#define CFG_ADDR 0xd00000510ULL
+#define CFG_SIZE 3
+
+/* linux/include/asm-sparc/timer.h */
+
+/* A sun4m has two blocks of registers which are probably of the same
+ * structure. LSI Logic's L64851 is told to _decrement_ from the limit
+ * value. Aurora behaves similarly but its limit value is compacted in
+ * other fashion (it's wider). Documented fields are defined here.
+ */
+
+/* As with the interrupt register, we have two classes of timer registers
+ * which are per-cpu and master. Per-cpu timers only hit that cpu and are
+ * only level 14 ticks, master timer hits all cpus and is level 10.
+ */
+
+#define SUN4M_PRM_CNT_L 0x80000000
+#define SUN4M_PRM_CNT_LVALUE 0x7FFFFC00
+
+struct sun4m_timer_percpu_info {
+ __volatile__ unsigned int l14_timer_limit; /* Initial value is 0x009c4000 */
+ __volatile__ unsigned int l14_cur_count;
+
+ /* This register appears to be write only and/or inaccessible
+ * on Uni-Processor sun4m machines.
+ */
+ __volatile__ unsigned int l14_limit_noclear; /* Data access error is here */
+
+ __volatile__ unsigned int cntrl; /* =1 after POST on Aurora */
+ __volatile__ unsigned char space[PAGE_SIZE - 16];
+};
+
+struct sun4m_timer_regs {
+ struct sun4m_timer_percpu_info cpu_timers[SUN4M_NCPUS];
+ volatile unsigned int l10_timer_limit;
+ volatile unsigned int l10_cur_count;
+
+ /* Again, this appears to be write only and/or inaccessible
+ * on uni-processor sun4m machines.
+ */
+ volatile unsigned int l10_limit_noclear;
+
+ /* This register too, it must be magic. */
+ volatile unsigned int foobar;
+
+ volatile unsigned int cfg; /* equals zero at boot time... */
+};
+
+/*
+ * Registers of hardware timer in sun4m.
+ */
+struct sun4m_timer_percpu {
+ volatile unsigned int l14_timer_limit; /* Initial value is 0x009c4000 = 10ms period*/
+ volatile unsigned int l14_cur_count;
+};
+
+struct sun4m_timer_global {
+ volatile unsigned int l10_timer_limit;
+ volatile unsigned int l10_cur_count;
+};
+
+/* linux/include/asm-sparc/irq.h */
+
+/* These registers are used for sending/receiving irqs from/to
+ * different cpu's.
+ */
+struct sun4m_intreg_percpu {
+ unsigned int tbt; /* Interrupts still pending for this cpu. */
+
+ /* These next two registers are WRITE-ONLY and are only
+ * "on bit" sensitive, "off bits" written have NO affect.
+ */
+ unsigned int clear; /* Clear this cpus irqs here. */
+ unsigned int set; /* Set this cpus irqs here. */
+ unsigned char space[PAGE_SIZE - 12];
+};
+
+/*
+ * djhr
+ * Actually the clear and set fields in this struct are misleading..
+ * according to the SLAVIO manual (and the same applies for the SEC)
+ * the clear field clears bits in the mask which will ENABLE that IRQ
+ * the set field sets bits in the mask to DISABLE the IRQ.
+ *
+ * Also the undirected_xx address in the SLAVIO is defined as
+ * RESERVED and write only..
+ *
+ * DAVEM_NOTE: The SLAVIO only specifies behavior on uniprocessor
+ * sun4m machines, for MP the layout makes more sense.
+ */
+struct sun4m_intregs {
+ struct sun4m_intreg_percpu cpu_intregs[SUN4M_NCPUS];
+ unsigned int tbt; /* IRQ's that are still pending. */
+ unsigned int irqs; /* Master IRQ bits. */
+
+ /* Again, like the above, two these registers are WRITE-ONLY. */
+ unsigned int clear; /* Clear master IRQ's by setting bits here. */
+ unsigned int set; /* Set master IRQ's by setting bits here. */
+
+ /* This register is both READ and WRITE. */
+ unsigned int undirected_target; /* Which cpu gets undirected irqs. */
+};
+
+/* Dave Redman (djhr@tadpole.co.uk)
+ * The sun4m interrupt registers.
+ */
+#define SUN4M_INT_ENABLE 0x80000000
+#define SUN4M_INT_E14 0x00000080
+#define SUN4M_INT_E10 0x00080000
+
+#define SUN4M_HARD_INT(x) (0x000000001 << (x))
+#define SUN4M_SOFT_INT(x) (0x000010000 << (x))
+
+#define SUN4M_INT_MASKALL 0x80000000 /* mask all interrupts */
+#define SUN4M_INT_MODULE_ERR 0x40000000 /* module error */
+#define SUN4M_INT_M2S_WRITE 0x20000000 /* write buffer error */
+#define SUN4M_INT_ECC 0x10000000 /* ecc memory error */
+#define SUN4M_INT_FLOPPY 0x00400000 /* floppy disk */
+#define SUN4M_INT_MODULE 0x00200000 /* module interrupt */
+#define SUN4M_INT_VIDEO 0x00100000 /* onboard video */
+#define SUN4M_INT_REALTIME 0x00080000 /* system timer */
+#define SUN4M_INT_SCSI 0x00040000 /* onboard scsi */
+#define SUN4M_INT_AUDIO 0x00020000 /* audio/isdn */
+#define SUN4M_INT_ETHERNET 0x00010000 /* onboard ethernet */
+#define SUN4M_INT_SERIAL 0x00008000 /* serial ports */
+#define SUN4M_INT_KBDMS 0x00004000 /* keyboard/mouse */
+#define SUN4M_INT_SBUSBITS 0x00003F80 /* sbus int bits */
Code Review / kvmfornfv.git / blobdiff