#ifndef __ASM_ARCH_MSM_HSUSB_H
#define __ASM_ARCH_MSM_HSUSB_H
+#include <linux/extcon.h>
#include <linux/types.h>
#include <linux/usb/otg.h>
#include <linux/clk.h>
void (*setup_gpio)(enum usb_otg_state state);
};
+/**
+ * struct msm_usb_cable - structure for exteternal connector cable
+ * state tracking
+ * @nb: hold event notification callback
+ * @conn: used for notification registration
+ */
+struct msm_usb_cable {
+ struct notifier_block nb;
+ struct extcon_dev *extcon;
+};
+
/**
* struct msm_otg: OTG driver data. Shared by HCD and DCD.
* @otg: USB OTG Transceiver structure.
* @chg_type: The type of charger attached.
* @dcd_retires: The retry count used to track Data contact
* detection process.
+ * @manual_pullup: true if VBUS is not routed to USB controller/phy
+ * and controller driver therefore enables pull-up explicitly before
+ * starting controller using usbcmd run/stop bit.
+ * @vbus: VBUS signal state trakining, using extcon framework
+ * @id: ID signal state trakining, using extcon framework
+ * @switch_gpio: Descriptor for GPIO used to control external Dual
+ * SPDT USB Switch.
+ * @reboot: Used to inform the driver to route USB D+/D- line to Device
+ * connector
*/
struct msm_otg {
struct usb_phy phy;
struct reset_control *phy_rst;
struct reset_control *link_rst;
int vdd_levels[3];
+
+ bool manual_pullup;
+
+ struct msm_usb_cable vbus;
+ struct msm_usb_cable id;
+
+ struct gpio_desc *switch_gpio;
+ struct notifier_block reboot;
};
#endif