Add the rt linux 4.1.3-rt3 as base

[kvmfornfv.git] / kernel / drivers / usb / image / Kconfig

diff --git a/kernel/drivers/usb/image/Kconfig b/kernel/drivers/usb/image/Kconfig
new file mode 100644 (file)
index 0000000..320d368
--- /dev/null
+++ b/kernel/drivers/usb/image/Kconfig
@@ -0,0 +1,28 @@
+#
+# USB Imaging devices configuration
+#
+comment "USB Imaging devices"
+
+config USB_MDC800
+       tristate "USB Mustek MDC800 Digital Camera support"
+       ---help---
+         Say Y here if you want to connect this type of still camera to
+         your computer's USB port. This driver can be used with gphoto 0.4.3
+         and higher (look at <http://www.gphoto.org/>).
+         To use it create a device node with "mknod /dev/mustek c 180 32" and
+         configure it in your software.
+
+         To compile this driver as a module, choose M here: the
+         module will be called mdc800.
+
+config USB_MICROTEK
+       tristate "Microtek X6USB scanner support"
+       depends on SCSI
+       help
+         Say Y here if you want support for the Microtek X6USB and
+         possibly the Phantom 336CX, Phantom C6 and ScanMaker V6U(S)L.
+         Support for anything but the X6 is experimental.
+         Please report failures and successes.
+         The scanner will appear as a scsi generic device to the rest
+         of the system. Scsi support is required.
+         This driver can be compiled as a module, called microtek.