These changes are the raw update to linux-4.4.6-rt14. Kernel sources

[kvmfornfv.git] / kernel / drivers / staging / ozwpan / README

diff --git a/kernel/drivers/staging/ozwpan/README b/kernel/drivers/staging/ozwpan/README
deleted file mode 100644 (file)
index 7c055ec..0000000
--- a/kernel/drivers/staging/ozwpan/README
+++ /dev/null
@@ -1,25 +0,0 @@
-OZWPAN USB Host Controller Driver
----------------------------------
-This driver is a USB HCD driver that does not have an associated a physical
-device but instead uses Wi-Fi to communicate with the wireless peripheral.
-The USB requests are converted into a layer 2 network protocol and transmitted
-on the network using an ethertype (0x892e) regestered to Ozmo Device Inc.
-This driver is compatible with existing wireless devices that use Ozmo Devices
-technology.
-
-To operate the driver must be bound to a suitable network interface. This can
-be done when the module is loaded (specifying the name of the network interface
-as a parameter - e.g. 'insmod ozwpan g_net_dev=go0') or can be bound after
-loading using an ioctl call. See the ozappif.h file and the ioctls
-OZ_IOCTL_ADD_BINDING and OZ_IOCTL_REMOVE_BINDING.
-
-The devices connect to the host use Wi-Fi Direct so a network card that supports
-Wi-Fi direct is required. A recent version (0.8.x or later) version of the
-wpa_supplicant can be used to setup the network interface to create a persistent
-autonomous group (for older pre-WFD peripherals) or put in a listen state to
-allow group negotiation to occur for more recent devices that support WFD.
-
-The protocol used over the network does not directly mimic the USB bus
-transactions as this would be rather busy and inefficient. Instead the chapter 9
-requests are converted into a request/response pair of messages. (See
-ozprotocol.h for data structures used in the protocol).