Add the rt linux 4.1.3-rt3 as base

[kvmfornfv.git] / kernel / drivers / pps / clients / Kconfig

diff --git a/kernel/drivers/pps/clients/Kconfig b/kernel/drivers/pps/clients/Kconfig
new file mode 100644 (file)
index 0000000..0c9f280
--- /dev/null
+++ b/kernel/drivers/pps/clients/Kconfig
@@ -0,0 +1,41 @@
+#
+# PPS clients configuration
+#
+
+if PPS
+
+comment "PPS clients support"
+
+config PPS_CLIENT_KTIMER
+       tristate "Kernel timer client (Testing client, use for debug)"
+       help
+         If you say yes here you get support for a PPS debugging client
+         which uses a kernel timer to generate the PPS signal.
+
+         This driver can also be built as a module.  If so, the module
+         will be called pps-ktimer.
+
+config PPS_CLIENT_LDISC
+       tristate "PPS line discipline"
+       depends on PPS && TTY
+       help
+         If you say yes here you get support for a PPS source connected
+         with the CD (Carrier Detect) pin of your serial port.
+
+config PPS_CLIENT_PARPORT
+       tristate "Parallel port PPS client"
+       depends on PPS && PARPORT
+       help
+         If you say yes here you get support for a PPS source connected
+         with the interrupt pin of your parallel port.
+
+config PPS_CLIENT_GPIO
+       tristate "PPS client using GPIO"
+       depends on PPS
+       help
+         If you say yes here you get support for a PPS source using
+         GPIO. To be useful you must also register a platform device
+         specifying the GPIO pin and other options, usually in your board
+         setup.
+
+endif