struct twl4030_usb *twl = dev_get_drvdata(dev);
dev_dbg(twl->dev, "%s\n", __func__);
- if (pm_runtime_suspended(dev))
- return 0;
__twl4030_phy_power(twl, 0);
regulator_disable(twl->usb1v5);
int res;
dev_dbg(twl->dev, "%s\n", __func__);
- if (pm_runtime_active(dev))
- return 0;
res = regulator_enable(twl->usb3v1);
if (res)
pm_runtime_use_autosuspend(&pdev->dev);
pm_runtime_set_autosuspend_delay(&pdev->dev, 2000);
pm_runtime_enable(&pdev->dev);
+ pm_runtime_get_sync(&pdev->dev);
/* Our job is to use irqs and status from the power module
* to keep the transceiver disabled when nothing's connected.
struct twl4030_usb *twl = platform_get_drvdata(pdev);
int val;
+ usb_remove_phy(&twl->phy);
pm_runtime_get_sync(twl->dev);
cancel_delayed_work(&twl->id_workaround_work);
device_remove_file(twl->dev, &dev_attr_vbus);
/* set transceiver mode to power on defaults */
twl4030_usb_set_mode(twl, -1);
+ /* idle ulpi before powering off */
+ if (cable_present(twl->linkstat))
+ pm_runtime_put_noidle(twl->dev);
+ pm_runtime_mark_last_busy(twl->dev);
+ pm_runtime_put_sync_suspend(twl->dev);
+ pm_runtime_disable(twl->dev);
+
/* autogate 60MHz ULPI clock,
* clear dpll clock request for i2c access,
* disable 32KHz
/* disable complete OTG block */
twl4030_usb_clear_bits(twl, POWER_CTRL, POWER_CTRL_OTG_ENAB);
- if (cable_present(twl->linkstat))
- pm_runtime_put_noidle(twl->dev);
- pm_runtime_mark_last_busy(twl->dev);
- pm_runtime_put(twl->dev);
-
return 0;
}