Add the rt linux 4.1.3-rt3 as base

[kvmfornfv.git] / kernel / drivers / net / can / softing / Kconfig

diff --git a/kernel/drivers/net/can/softing/Kconfig b/kernel/drivers/net/can/softing/Kconfig
new file mode 100644 (file)
index 0000000..96b6fe1
--- /dev/null
+++ b/kernel/drivers/net/can/softing/Kconfig
@@ -0,0 +1,30 @@
+config CAN_SOFTING
+       tristate "Softing Gmbh CAN generic support"
+       depends on HAS_IOMEM
+       ---help---
+         Support for CAN cards from Softing Gmbh & some cards
+         from Vector Gmbh.
+         Softing Gmbh CAN cards come with 1 or 2 physical busses.
+         Those cards typically use Dual Port RAM to communicate
+         with the host CPU. The interface is then identical for PCI
+         and PCMCIA cards. This driver operates on a platform device,
+         which has been created by softing_cs or softing_pci driver.
+         Warning:
+         The API of the card does not allow fine control per bus, but
+         controls the 2 busses on the card together.
+         As such, some actions (start/stop/busoff recovery) on 1 bus
+         must bring down the other bus too temporarily.
+
+config CAN_SOFTING_CS
+       tristate "Softing Gmbh CAN pcmcia cards"
+       depends on PCMCIA
+       depends on CAN_SOFTING
+       ---help---
+         Support for PCMCIA cards from Softing Gmbh & some cards
+         from Vector Gmbh.
+         You need firmware for these, which you can get at
+         http://developer.berlios.de/projects/socketcan/
+         This version of the driver is written against
+         firmware version 4.6 (softing-fw-4.6-binaries.tar.gz)
+         In order to use the card as CAN device, you need the Softing generic
+         support too.