These changes are the raw update to linux-4.4.6-rt14. Kernel sources

[kvmfornfv.git] / kernel / Documentation / devicetree / bindings / serial / nxp,sc16is7xx.txt

diff --git a/kernel/Documentation/devicetree/bindings/serial/nxp,sc16is7xx.txt b/kernel/Documentation/devicetree/bindings/serial/nxp,sc16is7xx.txt
index 246c795..fbfe536 100644 (file)
--- a/kernel/Documentation/devicetree/bindings/serial/nxp,sc16is7xx.txt
+++ b/kernel/Documentation/devicetree/bindings/serial/nxp,sc16is7xx.txt
@@ -1,4 +1,5 @@
 * NXP SC16IS7xx advanced Universal Asynchronous Receiver-Transmitter (UART)
+* i2c as bus
 
 Required properties:
 - compatible: Should be one of the following:
@@ -31,3 +32,39 @@ Example:
                 gpio-controller;
                 #gpio-cells = <2>;
         };
+
+* spi as bus
+
+Required properties:
+- compatible: Should be one of the following:
+  - "nxp,sc16is740" for NXP SC16IS740,
+  - "nxp,sc16is741" for NXP SC16IS741,
+  - "nxp,sc16is750" for NXP SC16IS750,
+  - "nxp,sc16is752" for NXP SC16IS752,
+  - "nxp,sc16is760" for NXP SC16IS760,
+  - "nxp,sc16is762" for NXP SC16IS762.
+- reg: SPI chip select number.
+- interrupt-parent: The phandle for the interrupt controller that
+  services interrupts for this IC.
+- interrupts: Specifies the interrupt source of the parent interrupt
+  controller. The format of the interrupt specifier depends on the
+  parent interrupt controller.
+- clocks: phandle to the IC source clock.
+
+Optional properties:
+- gpio-controller: Marks the device node as a GPIO controller.
+- #gpio-cells: Should be two. The first cell is the GPIO number and
+  the second cell is used to specify the GPIO polarity:
+    0 = active high,
+    1 = active low.
+
+Example:
+       sc16is750: sc16is750@0 {
+               compatible = "nxp,sc16is750";
+               reg = <0>;
+               clocks = <&clk20m>;
+               interrupt-parent = <&gpio3>;
+               interrupts = <7 IRQ_TYPE_EDGE_FALLING>;
+               gpio-controller;
+               #gpio-cells = <2>;
+       };