Add the live migration docuement

[kvmfornfv.git] / docs / all / live_migration.rst

diff --git a/docs/all/live_migration.rst b/docs/all/live_migration.rst
new file mode 100644 (file)
index 0000000..51265cc
--- /dev/null
+++ b/docs/all/live_migration.rst
@@ -0,0 +1,108 @@
+Fast Live Migration
+===================
+
+The NFV project requires fast live migration. The specific requirement is total
+live migration time < 2Sec, while keeping the VM down time < 10ms when running
+DPDK L2 forwarding workload.
+
+We measured the baseline data of migrating an idle 8GiB guest running a DPDK L2
+forwarding work load and observed that the total live migration time was 2271ms
+while the VM downtime was 26ms. Both of these two indicators failed to satisfy
+the requirements.
+
+Current Challenges
+------------------
+
+The following 4 features have been developed over the years to make the live
+migration process faster.
+
++ XBZRLE:
+        Helps to reduce the network traffic by just sending the
+        compressed data.
++ RDMA:
+        Uses a specific NIC to increase the efficiency of data
+        transmission.
++ Multi thread compression:
+        Compresses the data before transmission.
++ Auto convergence:
+        Reduces the data rate of dirty pages.
+
+Tests show none of the above features can satisfy the requirement of NFV.
+XBZRLE and Multi thread compression do the compression entirely in software and
+they are not fast enough in a 10Gbps network environment. RDMA is not flexible
+because it has to transport all the guest memory to the destination without zero
+page optimization. Auto convergence is not appropriate for NFV because it will
+impact guest’s performance.
+
+So we need to find other ways for optimization.
+
+Optimizations
+-------------------------
+a. Delay non-emergency operations
+   By profiling, it was discovered that some of the cleanup operations during
+   the stop and copy stage are the main reason for the long VM down time. The
+   cleanup operation includes stopping the dirty page logging, which is a time
+   consuming operation. By deferring these operations until the data transmission
+   is completed the VM down time is reduced to about 5-7ms.
+b. Optimize zero page checking
+   Currently QEMU uses the SSE2 instruction to optimize the zero pages
+   checking.  The SSE2 instruction can process 16 bytes per instruction. By using
+   the AVX2 instruction, we can process 32 bytes per instruction. Testingt shows
+   that using AVX2 can speed up the zero pages checking process by about 25%.
+c. Remove unnecessary context synchronization.
+   The CPU context was being synchronized twice during live migration. Removing
+   this unnecessary synchronization shortened the VM downtime by about 100us.
+
+Test Environment
+----------------
+
+The source and destination host have the same hardware and OS:
+::
+Host: HSW-EP
+CPU: Intel(R) Xeon(R) CPU E5-2699 v3 @ 2.30GHz
+RAM: 64G
+OS: RHEL 7.1
+Kernel: 4.2
+QEMU v2.4.0
+
+Ethernet controller: Intel Corporation Ethernet Controller 10-Gigabit X540-AT2 (rev 01)
+QEMU parameters:
+::
+  /root/qemu.git/x86_64-softmmu/qemu-system-x86_64-enable-kvm -cpu host -smp 4 –device virtio-net-pci,netdev=net1,mac=52:54:00:12:34:56 –netdev type=tap,id=net1,script=/etc/kvm/qemu-ifup,downscript=no,vhost=on–device virtio-net-pci,netdev=net2,mac=54:54:00:12:34:56 –netdevtype=tap,id=net2,script=/etc/kvm/qemu-ifup2,downscript=no,vhost=on  -balloon virtio -m 8192-monitor stdio  /mnt/liang/ia32e_rhel6u5.qcow
+
+Network connection
+
+.. figure:: lmnetwork.jpg
+   :align: center
+   :alt: live migration network connection
+   :figwidth: 80%
+
+
+Test Result
+-----------
+The down time is set to 10ms when doing the test. We use pktgen to send the
+packages to guest, the package size is 64 bytes, and the line rate is 2013
+Mbps.
+
+a. Total live migration time
+
+   The total live migration time before and after optimization is shown in the
+   chart below. For an idle guest, we can reduce the total live migration time
+   from 2070ms to 401ms. For a guest running the DPDK L2 forwarding workload,
+   the total live migration time is reduced from 2271ms to 654ms.
+
+.. figure:: lmtotaltime.jpg
+   :align: center
+   :alt: total live migration time
+
+b. VM downtime
+
+   The VM down time before and after optimization is shown in the chart below.
+   For an idle guest, we can reduce the VM down time from 29ms to 9ms. For a guest
+   running the DPDK L2 forwarding workload, the VM down time is reduced from 26ms to
+   5ms.
+
+.. figure:: lmdowntime.jpg
+   :align: center
+   :alt: vm downtime
+   :figwidth: 80%