Note that DPDK must be built with 'enable_driver_sdk' option enabled,
in order to expose the PCI driver API, now marked as internal. See
http://doc.dpdk.org/guides-22.11/rel_notes/release_22_11.html#api-changes
for details. This is done by supplying the '-Denable_driver_sdk=true'
command line parameter, either to 'meson setup', or later on to 'meson
configure', before running 'ninja' and 'ninja install'.
Signed-off-by: Patrice Buriez <patrice.buriez@chenapan.org>
Change-Id: I5aa57cec851a68fa2a2d2fc63d4e12311e5742f9
plog_info("OUTER_IPV4_CKSUM | ");
if (port_cfg->dev_info.rx_offload_capa & RTE_ETH_RX_OFFLOAD_MACSEC_STRIP)
plog_info("MACSEC STRIP | ");
+#if defined(RTE_ETH_RX_OFFLOAD_HEADER_SPLIT)
if (port_cfg->dev_info.rx_offload_capa & RTE_ETH_RX_OFFLOAD_HEADER_SPLIT)
plog_info("HEADER SPLIT | ");
+#endif
if (port_cfg->dev_info.rx_offload_capa & RTE_ETH_RX_OFFLOAD_VLAN_FILTER)
plog_info("VLAN FILTER | ");
if (port_cfg->dev_info.rx_offload_capa & RTE_ETH_RX_OFFLOAD_VLAN_EXTEND)
#include <rte_ether.h>
#include <rte_ethdev.h>
#include <rte_version.h>
+#if RTE_VERSION >= RTE_VERSION_NUM(22,11,0,0)
+#include <bus_pci_driver.h> // Please configure DPDK with meson option -Denable_driver_sdk=true
+#else
#if RTE_VERSION >= RTE_VERSION_NUM(17,11,0,0)
#include <rte_bus_pci.h>
#endif
+#endif
#include <rte_pci.h>
#include "prox_compat.h"