X-Git-Url: https://gerrit.opnfv.org/gerrit/gitweb?a=blobdiff_plain;f=qemu%2Froms%2Fu-boot%2Finclude%2Fata.h;fp=qemu%2Froms%2Fu-boot%2Finclude%2Fata.h;h=9d6f59c97bfaae7ea8482eb03468533465901d9c;hb=e44e3482bdb4d0ebde2d8b41830ac2cdb07948fb;hp=0000000000000000000000000000000000000000;hpb=9ca8dbcc65cfc63d6f5ef3312a33184e1d726e00;p=kvmfornfv.git diff --git a/qemu/roms/u-boot/include/ata.h b/qemu/roms/u-boot/include/ata.h new file mode 100644 index 000000000..9d6f59c97 --- /dev/null +++ b/qemu/roms/u-boot/include/ata.h @@ -0,0 +1,251 @@ +/* + * (C) Copyright 2000 + * Wolfgang Denk, DENX Software Engineering, wd@denx.de. + * + * SPDX-License-Identifier: GPL-2.0+ + */ + +/* + * Most of the following information was derived from the document + * "Information Technology - AT Attachment-3 Interface (ATA-3)" + * which can be found at: + * http://www.dt.wdc.com/ata/ata-3/ata3r5v.zip + * ftp://poctok.iae.nsk.su/pub/asm/Documents/IDE/ATA3R5V.ZIP + * ftp://ftp.fee.vutbr.cz/pub/doc/io/ata/ata-3/ata3r5v.zip + */ + +#ifndef _ATA_H +#define _ATA_H + +#include + +/* Register addressing depends on the hardware design; for instance, + * 8-bit (register) and 16-bit (data) accesses might use different + * address spaces. This is implemented by the following definitions. + */ +#ifndef CONFIG_SYS_ATA_STRIDE +#define CONFIG_SYS_ATA_STRIDE 1 +#endif + +#define ATA_IO_DATA(x) (CONFIG_SYS_ATA_DATA_OFFSET+((x) * CONFIG_SYS_ATA_STRIDE)) +#define ATA_IO_REG(x) (CONFIG_SYS_ATA_REG_OFFSET +((x) * CONFIG_SYS_ATA_STRIDE)) +#define ATA_IO_ALT(x) (CONFIG_SYS_ATA_ALT_OFFSET +((x) * CONFIG_SYS_ATA_STRIDE)) + +/* + * I/O Register Descriptions + */ +#define ATA_DATA_REG ATA_IO_DATA(0) +#define ATA_ERROR_REG ATA_IO_REG(1) +#define ATA_SECT_CNT ATA_IO_REG(2) +#define ATA_SECT_NUM ATA_IO_REG(3) +#define ATA_CYL_LOW ATA_IO_REG(4) +#define ATA_CYL_HIGH ATA_IO_REG(5) +#define ATA_DEV_HD ATA_IO_REG(6) +#define ATA_COMMAND ATA_IO_REG(7) +#define ATA_DATA_EVEN ATA_IO_REG(8) +#define ATA_DATA_ODD ATA_IO_REG(9) +#define ATA_STATUS ATA_COMMAND +#define ATA_DEV_CTL ATA_IO_ALT(6) +#define ATA_LBA_LOW ATA_SECT_NUM +#define ATA_LBA_MID ATA_CYL_LOW +#define ATA_LBA_HIGH ATA_CYL_HIGH +#define ATA_LBA_SEL ATA_DEV_CTL + +/* + * Status register bits + */ +#define ATA_STAT_BUSY 0x80 /* Device Busy */ +#define ATA_STAT_READY 0x40 /* Device Ready */ +#define ATA_STAT_FAULT 0x20 /* Device Fault */ +#define ATA_STAT_SEEK 0x10 /* Device Seek Complete */ +#define ATA_STAT_DRQ 0x08 /* Data Request (ready) */ +#define ATA_STAT_CORR 0x04 /* Corrected Data Error */ +#define ATA_STAT_INDEX 0x02 /* Vendor specific */ +#define ATA_STAT_ERR 0x01 /* Error */ + +/* + * Device / Head Register Bits + */ +#ifndef ATA_DEVICE +#define ATA_DEVICE(x) ((x & 1)<<4) +#endif /* ATA_DEVICE */ +#define ATA_LBA 0xE0 + +/* + * ATA Commands (only mandatory commands listed here) + */ +#define ATA_CMD_READ 0x20 /* Read Sectors (with retries) */ +#define ATA_CMD_READN 0x21 /* Read Sectors ( no retries) */ +#define ATA_CMD_WRITE 0x30 /* Write Sectores (with retries)*/ +#define ATA_CMD_WRITEN 0x31 /* Write Sectors ( no retries)*/ +#define ATA_CMD_VRFY 0x40 /* Read Verify (with retries) */ +#define ATA_CMD_VRFYN 0x41 /* Read verify ( no retries) */ +#define ATA_CMD_SEEK 0x70 /* Seek */ +#define ATA_CMD_DIAG 0x90 /* Execute Device Diagnostic */ +#define ATA_CMD_INIT 0x91 /* Initialize Device Parameters */ +#define ATA_CMD_RD_MULT 0xC4 /* Read Multiple */ +#define ATA_CMD_WR_MULT 0xC5 /* Write Multiple */ +#define ATA_CMD_SETMULT 0xC6 /* Set Multiple Mode */ +#define ATA_CMD_RD_DMA 0xC8 /* Read DMA (with retries) */ +#define ATA_CMD_RD_DMAN 0xC9 /* Read DMS ( no retries) */ +#define ATA_CMD_WR_DMA 0xCA /* Write DMA (with retries) */ +#define ATA_CMD_WR_DMAN 0xCB /* Write DMA ( no retires) */ +#define ATA_CMD_IDENT 0xEC /* Identify Device */ +#define ATA_CMD_SETF 0xEF /* Set Features */ +#define ATA_CMD_CHK_PWR 0xE5 /* Check Power Mode */ + +#define ATA_CMD_READ_EXT 0x24 /* Read Sectors (with retries) with 48bit addressing */ +#define ATA_CMD_WRITE_EXT 0x34 /* Write Sectores (with retries) with 48bit addressing */ +#define ATA_CMD_VRFY_EXT 0x42 /* Read Verify (with retries) with 48bit addressing */ + +#define ATA_CMD_FLUSH 0xE7 /* Flush drive cache */ +#define ATA_CMD_FLUSH_EXT 0xEA /* Flush drive cache, with 48bit addressing */ + +/* + * ATAPI Commands + */ +#define ATAPI_CMD_IDENT 0xA1 /* Identify AT Atachment Packed Interface Device */ +#define ATAPI_CMD_PACKET 0xA0 /* Packed Command */ + + +#define ATAPI_CMD_INQUIRY 0x12 +#define ATAPI_CMD_REQ_SENSE 0x03 +#define ATAPI_CMD_READ_CAP 0x25 +#define ATAPI_CMD_START_STOP 0x1B +#define ATAPI_CMD_READ_12 0xA8 + + +#define ATA_GET_ERR() inb(ATA_STATUS) +#define ATA_GET_STAT() inb(ATA_STATUS) +#define ATA_OK_STAT(stat,good,bad) (((stat)&((good)|(bad)))==(good)) +#define ATA_BAD_R_STAT (ATA_STAT_BUSY | ATA_STAT_ERR) +#define ATA_BAD_W_STAT (ATA_BAD_R_STAT | ATA_STAT_FAULT) +#define ATA_BAD_STAT (ATA_BAD_R_STAT | ATA_STAT_DRQ) +#define ATA_DRIVE_READY (ATA_READY_STAT | ATA_STAT_SEEK) +#define ATA_DATA_READY (ATA_STAT_DRQ) + +#define ATA_BLOCKSIZE 512 /* bytes */ +#define ATA_BLOCKSHIFT 9 /* 2 ^ ATA_BLOCKSIZESHIFT = 512 */ +#define ATA_SECTORWORDS (512 / sizeof(unsigned long)) + +#ifndef ATA_RESET_TIME +#define ATA_RESET_TIME 60 /* spec allows up to 31 seconds */ +#endif + +/* ------------------------------------------------------------------------- */ + +/* + * structure returned by ATA_CMD_IDENT, as per ANSI ATA2 rev.2f spec + */ +typedef struct hd_driveid { + unsigned short config; /* lots of obsolete bit flags */ + unsigned short cyls; /* "physical" cyls */ + unsigned short reserved2; /* reserved (word 2) */ + unsigned short heads; /* "physical" heads */ + unsigned short track_bytes; /* unformatted bytes per track */ + unsigned short sector_bytes; /* unformatted bytes per sector */ + unsigned short sectors; /* "physical" sectors per track */ + unsigned short vendor0; /* vendor unique */ + unsigned short vendor1; /* vendor unique */ + unsigned short vendor2; /* vendor unique */ + unsigned char serial_no[20]; /* 0 = not_specified */ + unsigned short buf_type; + unsigned short buf_size; /* 512 byte increments; 0 = not_specified */ + unsigned short ecc_bytes; /* for r/w long cmds; 0 = not_specified */ + unsigned char fw_rev[8]; /* 0 = not_specified */ + unsigned char model[40]; /* 0 = not_specified */ + unsigned char max_multsect; /* 0=not_implemented */ + unsigned char vendor3; /* vendor unique */ + unsigned short dword_io; /* 0=not_implemented; 1=implemented */ + unsigned char vendor4; /* vendor unique */ + unsigned char capability; /* bits 0:DMA 1:LBA 2:IORDYsw 3:IORDYsup*/ + unsigned short reserved50; /* reserved (word 50) */ + unsigned char vendor5; /* vendor unique */ + unsigned char tPIO; /* 0=slow, 1=medium, 2=fast */ + unsigned char vendor6; /* vendor unique */ + unsigned char tDMA; /* 0=slow, 1=medium, 2=fast */ + unsigned short field_valid; /* bits 0:cur_ok 1:eide_ok */ + unsigned short cur_cyls; /* logical cylinders */ + unsigned short cur_heads; /* logical heads */ + unsigned short cur_sectors; /* logical sectors per track */ + unsigned short cur_capacity0; /* logical total sectors on drive */ + unsigned short cur_capacity1; /* (2 words, misaligned int) */ + unsigned char multsect; /* current multiple sector count */ + unsigned char multsect_valid; /* when (bit0==1) multsect is ok */ + unsigned int lba_capacity; /* total number of sectors */ + unsigned short dma_1word; /* single-word dma info */ + unsigned short dma_mword; /* multiple-word dma info */ + unsigned short eide_pio_modes; /* bits 0:mode3 1:mode4 */ + unsigned short eide_dma_min; /* min mword dma cycle time (ns) */ + unsigned short eide_dma_time; /* recommended mword dma cycle time (ns) */ + unsigned short eide_pio; /* min cycle time (ns), no IORDY */ + unsigned short eide_pio_iordy; /* min cycle time (ns), with IORDY */ + unsigned short words69_70[2]; /* reserved words 69-70 */ + unsigned short words71_74[4]; /* reserved words 71-74 */ + unsigned short queue_depth; /* */ + unsigned short words76_79[4]; /* reserved words 76-79 */ + unsigned short major_rev_num; /* */ + unsigned short minor_rev_num; /* */ + unsigned short command_set_1; /* bits 0:Smart 1:Security 2:Removable 3:PM */ + unsigned short command_set_2; /* bits 14:Smart Enabled 13:0 zero 10:lba48 support*/ + unsigned short cfsse; /* command set-feature supported extensions */ + unsigned short cfs_enable_1; /* command set-feature enabled */ + unsigned short cfs_enable_2; /* command set-feature enabled */ + unsigned short csf_default; /* command set-feature default */ + unsigned short dma_ultra; /* */ + unsigned short word89; /* reserved (word 89) */ + unsigned short word90; /* reserved (word 90) */ + unsigned short CurAPMvalues; /* current APM values */ + unsigned short word92; /* reserved (word 92) */ + unsigned short hw_config; /* hardware config */ + unsigned short words94_99[6];/* reserved words 94-99 */ + /*unsigned long long lba48_capacity; /--* 4 16bit values containing lba 48 total number of sectors */ + unsigned short lba48_capacity[4]; /* 4 16bit values containing lba 48 total number of sectors */ + unsigned short words104_125[22];/* reserved words 104-125 */ + unsigned short last_lun; /* reserved (word 126) */ + unsigned short word127; /* reserved (word 127) */ + unsigned short dlf; /* device lock function + * 15:9 reserved + * 8 security level 1:max 0:high + * 7:6 reserved + * 5 enhanced erase + * 4 expire + * 3 frozen + * 2 locked + * 1 en/disabled + * 0 capability + */ + unsigned short csfo; /* current set features options + * 15:4 reserved + * 3 auto reassign + * 2 reverting + * 1 read-look-ahead + * 0 write cache + */ + unsigned short words130_155[26];/* reserved vendor words 130-155 */ + unsigned short word156; + unsigned short words157_159[3];/* reserved vendor words 157-159 */ + unsigned short words160_162[3];/* reserved words 160-162 */ + unsigned short cf_advanced_caps; + unsigned short words164_255[92];/* reserved words 164-255 */ +} hd_driveid_t; + + +/* + * PIO Mode Configuration + * + * See ATA-3 (AT Attachment-3 Interface) documentation, Figure 14 / Table 21 + */ + +typedef struct { + unsigned int t_setup; /* Setup Time in [ns] or clocks */ + unsigned int t_length; /* Length Time in [ns] or clocks */ + unsigned int t_hold; /* Hold Time in [ns] or clocks */ +} +pio_config_t; + +#define IDE_MAX_PIO_MODE 4 /* max suppurted PIO mode */ + +/* ------------------------------------------------------------------------- */ + +#endif /* _ATA_H */