X-Git-Url: https://gerrit.opnfv.org/gerrit/gitweb?a=blobdiff_plain;f=qemu%2Froms%2Fu-boot%2Fboard%2Fgalaxy5200%2Fgalaxy5200.c;fp=qemu%2Froms%2Fu-boot%2Fboard%2Fgalaxy5200%2Fgalaxy5200.c;h=29e40eb58aafb78379913168cbe461216f7a04d3;hb=e44e3482bdb4d0ebde2d8b41830ac2cdb07948fb;hp=0000000000000000000000000000000000000000;hpb=9ca8dbcc65cfc63d6f5ef3312a33184e1d726e00;p=kvmfornfv.git

diff --git a/qemu/roms/u-boot/board/galaxy5200/galaxy5200.c b/qemu/roms/u-boot/board/galaxy5200/galaxy5200.c
new file mode 100644
index 000000000..29e40eb58
--- /dev/null
+++ b/qemu/roms/u-boot/board/galaxy5200/galaxy5200.c
@@ -0,0 +1,183 @@
+/*
+ * (C) Copyright 2003
+ * Wolfgang Denk, DENX Software Engineering, wd@denx.de.
+ *
+ * (C) Copyright 2004
+ * Mark Jonas, Freescale Semiconductor, mark.jonas@motorola.com.
+ *
+ * (C) Copyright 2006
+ * Eric Schumann, Phytec Messtechnik GmbH
+ *
+ * (C) Copyright 2009
+ * Eric Millbrandt, DEKA Research and Development Corporation
+ *
+ * SPDX-License-Identifier:	GPL-2.0+
+ */
+
+#include <common.h>
+#include <mpc5xxx.h>
+#include <pci.h>
+#include <asm/io.h>
+
+#ifndef CONFIG_SYS_RAMBOOT
+static void sdram_start(int hi_addr)
+{
+	volatile struct mpc5xxx_cdm *cdm =
+		(struct mpc5xxx_cdm *)MPC5XXX_CDM;
+	volatile struct mpc5xxx_sdram *sdram =
+		(struct mpc5xxx_sdram *)MPC5XXX_SDRAM;
+
+	long hi_addr_bit = hi_addr ? 0x01000000 : 0;
+
+	/* unlock mode register */
+	out_be32 (&sdram->ctrl,
+		(SDRAM_CONTROL | 0x80000000 | hi_addr_bit));
+
+	/* precharge all banks */
+	out_be32 (&sdram->ctrl,
+		(SDRAM_CONTROL | 0x80000002 | hi_addr_bit));
+
+#ifdef SDRAM_DDR
+	/* set mode register: extended mode */
+	out_be32 (&sdram->mode, (SDRAM_EMODE));
+
+	/* set mode register: reset DLL */
+	out_be32 (&sdram->mode, (SDRAM_MODE | 0x04000000));
+#endif
+
+	/* precharge all banks */
+	out_be32 (&sdram->ctrl,
+		(SDRAM_CONTROL | 0x80000002 | hi_addr_bit));
+
+	/* auto refresh */
+	out_be32 (&sdram->ctrl,
+		(SDRAM_CONTROL | 0x80000004 | hi_addr_bit));
+
+	/* set mode register */
+	out_be32 (&sdram->mode, (SDRAM_MODE));
+
+	/* normal operation */
+	out_be32 (&sdram->ctrl,
+		(SDRAM_CONTROL | hi_addr_bit));
+
+	/* set CDM clock enable register, set MPC5200B SDRAM bus */
+	/* to reduced driver strength */
+	out_be32 (&cdm->clock_enable, (0x00CFFFFF));
+}
+#endif
+
+/*
+ * ATTENTION: Although partially referenced initdram does NOT make
+ *	real use of CONFIG_SYS_SDRAM_BASE. The code does not
+ *	work if CONFIG_SYS_SDRAM_BASE
+ *	is something else than 0x00000000.
+ */
+
+phys_size_t initdram(int board_type)
+{
+	volatile struct mpc5xxx_mmap_ctl *mm =
+		(struct mpc5xxx_mmap_ctl *)CONFIG_SYS_MBAR;
+	volatile struct mpc5xxx_sdram *sdram =
+		(struct mpc5xxx_sdram *)MPC5XXX_SDRAM;
+	ulong dramsize = 0;
+	ulong dramsize2 = 0;
+#ifndef CONFIG_SYS_RAMBOOT
+	ulong test1, test2;
+
+	/* setup SDRAM chip selects */
+							 /* 256MB at 0x0 */
+	out_be32 (&mm->sdram0, 0x0000001b);
+							 /* disabled */
+	out_be32 (&mm->sdram1, 0x10000000);
+
+	/* setup config registers */
+	out_be32 (&sdram->config1, SDRAM_CONFIG1);
+	out_be32 (&sdram->config2, SDRAM_CONFIG2);
+
+	/* find RAM size using SDRAM CS0 only */
+	sdram_start(0);
+	test1 = get_ram_size((long *) CONFIG_SYS_SDRAM_BASE, 0x10000000);
+	sdram_start(1);
+	test2 = get_ram_size((long *) CONFIG_SYS_SDRAM_BASE, 0x10000000);
+	if (test1 > test2) {
+		sdram_start(0);
+		dramsize = test1;
+	} else
+		dramsize = test2;
+
+	/* memory smaller than 1MB is impossible */
+	if (dramsize < (1 << 20))
+		dramsize = 0;
+
+	/* set SDRAM CS0 size according to the amount of RAM found */
+	if (dramsize > 0) {
+		out_be32 (&mm->sdram0,
+			(0x13 + __builtin_ffs(dramsize >> 20) - 1));
+	} else {
+							/* disabled */
+		out_be32 (&mm->sdram0, 0);
+	}
+
+#else /* CONFIG_SYS_RAMBOOT */
+
+	/* retrieve size of memory connected to SDRAM CS0 */
+	dramsize = in_be32(&mm->sdram0) & 0xFF;
+	if (dramsize >= 0x13)
+		dramsize = (1 << (dramsize - 0x13)) << 20;
+	else
+		dramsize = 0;
+
+	/* retrieve size of memory connected to SDRAM CS1 */
+	dramsize2 = in_be32(&mm->sdram1) & 0xFF;
+	if (dramsize2 >= 0x13)
+		dramsize2 = (1 << (dramsize2 - 0x13)) << 20;
+	else
+		dramsize2 = 0;
+
+#endif /* CONFIG_SYS_RAMBOOT */
+
+	return dramsize + dramsize2;
+}
+
+int checkboard(void)
+{
+	puts("Board: galaxy5200\n");
+	return 0;
+}
+
+#if defined(CONFIG_OF_LIBFDT) && defined(CONFIG_OF_BOARD_SETUP)
+void ft_board_setup(void *blob, bd_t * bd)
+{
+	ft_cpu_setup(blob, bd);
+}
+#endif /* defined(CONFIG_OF_LIBFDT) && defined(CONFIG_OF_BOARD_SETUP) */
+
+#if defined(CONFIG_CMD_IDE) && defined(CONFIG_IDE_RESET)
+
+void init_ide_reset (void)
+{
+	volatile struct mpc5xxx_gpt *gpt = (struct mpc5xxx_gpt *)MPC5XXX_GPT;
+	debug ("init_ide_reset\n");
+
+	/* Configure TIMER_5 as GPIO output for ATA reset */
+	/* Deassert reset */
+	gpt[5].emsr = MPC5XXX_GPT_GPIO_OUT1 | MPC5XXX_GPT_TMS_GPIO;
+}
+
+void ide_set_reset (int idereset)
+{
+	volatile struct mpc5xxx_gpt *gpt = (struct mpc5xxx_gpt *)MPC5XXX_GPT;
+	debug ("ide_reset(%d)\n", idereset);
+
+	/* Configure TIMER_5 as GPIO output for ATA reset */
+	if (idereset) {
+		gpt[5].emsr = MPC5XXX_GPT_GPIO_OUT0 | MPC5XXX_GPT_TMS_GPIO;
+
+		/* Make a delay. MPC5200 spec says 25 usec min */
+		udelay(50);
+	} else {
+		gpt[5].emsr = MPC5XXX_GPT_GPIO_OUT1 | MPC5XXX_GPT_TMS_GPIO;
+		udelay(50);
+	}
+}
+#endif /* defined(CONFIG_CMD_IDE) && defined(CONFIG_IDE_RESET) */