Add the rt linux 4.1.3-rt3 as base
[kvmfornfv.git] / kernel / include / scsi / fc / fc_fcp.h
diff --git a/kernel/include/scsi/fc/fc_fcp.h b/kernel/include/scsi/fc/fc_fcp.h
new file mode 100644 (file)
index 0000000..9c87029
--- /dev/null
@@ -0,0 +1,216 @@
+/*
+ * Copyright(c) 2007 Intel Corporation. All rights reserved.
+ *
+ * This program is free software; you can redistribute it and/or modify it
+ * under the terms and conditions of the GNU General Public License,
+ * version 2, as published by the Free Software Foundation.
+ *
+ * This program is distributed in the hope it will be useful, but WITHOUT
+ * ANY WARRANTY; without even the implied warranty of MERCHANTABILITY or
+ * FITNESS FOR A PARTICULAR PURPOSE.  See the GNU General Public License for
+ * more details.
+ *
+ * You should have received a copy of the GNU General Public License along with
+ * this program; if not, write to the Free Software Foundation, Inc.,
+ * 51 Franklin St - Fifth Floor, Boston, MA 02110-1301 USA.
+ *
+ * Maintained at www.Open-FCoE.org
+ */
+
+#ifndef _FC_FCP_H_
+#define        _FC_FCP_H_
+
+#include <scsi/scsi.h>
+
+/*
+ * Fibre Channel Protocol for SCSI.
+ * From T10 FCP-3, T10 project 1560-D Rev 4, Sept. 13, 2005.
+ */
+
+/*
+ * fc/fs.h defines FC_TYPE_FCP.
+ */
+
+/*
+ * Service parameter page parameters (word 3 bits) for Process Login.
+ */
+#define        FCP_SPPF_TASK_RETRY_ID  0x0200  /* task retry ID requested */
+#define        FCP_SPPF_RETRY          0x0100  /* retry supported */
+#define        FCP_SPPF_CONF_COMPL     0x0080  /* confirmed completion allowed */
+#define        FCP_SPPF_OVLY_ALLOW     0x0040  /* data overlay allowed */
+#define        FCP_SPPF_INIT_FCN       0x0020  /* initiator function */
+#define        FCP_SPPF_TARG_FCN       0x0010  /* target function */
+#define        FCP_SPPF_RD_XRDY_DIS    0x0002  /* disable XFER_RDY for reads */
+#define        FCP_SPPF_WR_XRDY_DIS    0x0001  /* disable XFER_RDY for writes */
+
+/*
+ * FCP_CMND IU Payload.
+ */
+struct fcp_cmnd {
+       struct scsi_lun fc_lun;         /* logical unit number */
+       __u8            fc_cmdref;      /* command reference number */
+       __u8            fc_pri_ta;      /* priority and task attribute */
+       __u8            fc_tm_flags;    /* task management flags */
+       __u8            fc_flags;       /* additional len & flags */
+       __u8            fc_cdb[16];     /* base CDB */
+       __be32          fc_dl;          /* data length (must follow fc_cdb) */
+};
+
+#define        FCP_CMND_LEN    32      /* expected length of structure */
+
+struct fcp_cmnd32 {
+       struct scsi_lun fc_lun;         /* logical unit number */
+       __u8            fc_cmdref;      /* command reference number */
+       __u8            fc_pri_ta;      /* priority and task attribute */
+       __u8            fc_tm_flags;    /* task management flags */
+       __u8            fc_flags;       /* additional len & flags */
+       __u8            fc_cdb[32];     /* base CDB */
+       __be32          fc_dl;          /* data length (must follow fc_cdb) */
+};
+
+#define        FCP_CMND32_LEN      48  /* expected length of structure */
+#define        FCP_CMND32_ADD_LEN  (16 / 4)    /* Additional cdb length */
+
+/*
+ * fc_pri_ta.
+ */
+#define        FCP_PTA_SIMPLE      0   /* simple task attribute */
+#define        FCP_PTA_HEADQ       1   /* head of queue task attribute */
+#define        FCP_PTA_ORDERED     2   /* ordered task attribute */
+#define        FCP_PTA_ACA         4   /* auto. contingent allegiance */
+#define        FCP_PTA_MASK        7   /* mask for task attribute field */
+#define        FCP_PRI_SHIFT       3   /* priority field starts in bit 3 */
+#define        FCP_PRI_RESVD_MASK  0x80        /* reserved bits in priority field */
+
+/*
+ * fc_tm_flags - task management flags field.
+ */
+#define        FCP_TMF_CLR_ACA         0x40    /* clear ACA condition */
+#define        FCP_TMF_TGT_RESET       0x20    /* target reset task management,
+                                          deprecated as of FCP-3 */
+#define        FCP_TMF_LUN_RESET       0x10    /* logical unit reset task management */
+#define        FCP_TMF_CLR_TASK_SET    0x04    /* clear task set */
+#define        FCP_TMF_ABT_TASK_SET    0x02    /* abort task set */
+
+/*
+ * fc_flags.
+ *  Bits 7:2 are the additional FCP_CDB length / 4.
+ */
+#define        FCP_CFL_LEN_MASK        0xfc    /* mask for additional length */
+#define        FCP_CFL_LEN_SHIFT       2       /* shift bits for additional length */
+#define        FCP_CFL_RDDATA          0x02    /* read data */
+#define        FCP_CFL_WRDATA          0x01    /* write data */
+
+/*
+ * FCP_TXRDY IU - transfer ready payload.
+ */
+struct fcp_txrdy {
+       __be32          ft_data_ro;     /* data relative offset */
+       __be32          ft_burst_len;   /* burst length */
+       __u8            _ft_resvd[4];   /* reserved */
+};
+
+#define        FCP_TXRDY_LEN   12      /* expected length of structure */
+
+/*
+ * FCP_RESP IU - response payload.
+ *
+ * The response payload comes in three parts: the flags/status, the
+ * sense/response lengths and the sense data/response info section.
+ *
+ * From FCP3r04, note 6 of section 9.5.13:
+ *
+ * Some early implementations presented the FCP_RSP IU without the FCP_RESID,
+ * FCP_SNS_LEN, and FCP_RSP_LEN fields if the FCP_RESID_UNDER, FCP_RESID_OVER,
+ * FCP_SNS_LEN_VALID, and FCP_RSP_LEN_VALID bits were all set to zero. This
+ * non-standard behavior should be tolerated.
+ *
+ * All response frames will always contain the fcp_resp template.  Some
+ * will also include the fcp_resp_len template.
+ *
+ * From Table 23, the FCP_RSP_INFO can either be 4 bytes or 8 bytes, both
+ * are valid length.
+ */
+struct fcp_resp {
+       __u8            _fr_resvd[8];   /* reserved */
+       __be16          fr_retry_delay; /* retry delay timer */
+       __u8            fr_flags;       /* flags */
+       __u8            fr_status;      /* SCSI status code */
+};
+
+#define        FCP_RESP_LEN    12      /* expected length of structure */
+
+struct fcp_resp_ext {
+       __be32          fr_resid;       /* Residual value */
+       __be32          fr_sns_len;     /* SCSI Sense length */
+       __be32          fr_rsp_len;     /* Response Info length */
+
+       /*
+        * Optionally followed by RSP info and/or SNS info and/or
+        * bidirectional read residual length, if any.
+        */
+};
+
+#define FCP_RESP_EXT_LEN    12  /* expected length of the structure */
+
+struct fcp_resp_rsp_info {
+    __u8      _fr_resvd[3];       /* reserved */
+    __u8      rsp_code;           /* Response Info Code */
+    __u8      _fr_resvd2[4];      /* reserved */
+};
+
+#define FCP_RESP_RSP_INFO_LEN4    4 /* without reserved field */
+#define FCP_RESP_RSP_INFO_LEN8    8 /* with reserved field */
+
+struct fcp_resp_with_ext {
+       struct fcp_resp resp;
+       struct fcp_resp_ext ext;
+};
+
+#define        FCP_RESP_WITH_EXT   (FCP_RESP_LEN + FCP_RESP_EXT_LEN)
+
+/*
+ * fr_flags.
+ */
+#define        FCP_BIDI_RSP        0x80        /* bidirectional read response */
+#define        FCP_BIDI_READ_UNDER 0x40        /* bidir. read less than requested */
+#define        FCP_BIDI_READ_OVER  0x20        /* DL insufficient for full transfer */
+#define        FCP_CONF_REQ        0x10        /* confirmation requested */
+#define        FCP_RESID_UNDER     0x08        /* transfer shorter than expected */
+#define        FCP_RESID_OVER      0x04        /* DL insufficient for full transfer */
+#define        FCP_SNS_LEN_VAL     0x02        /* SNS_LEN field is valid */
+#define        FCP_RSP_LEN_VAL     0x01        /* RSP_LEN field is valid */
+
+/*
+ * rsp_codes
+ */
+enum fcp_resp_rsp_codes {
+       FCP_TMF_CMPL = 0,
+       FCP_DATA_LEN_INVALID = 1,
+       FCP_CMND_FIELDS_INVALID = 2,
+       FCP_DATA_PARAM_MISMATCH = 3,
+       FCP_TMF_REJECTED = 4,
+       FCP_TMF_FAILED = 5,
+       FCP_TMF_INVALID_LUN = 9,
+};
+
+/*
+ * FCP SRR Link Service request - Sequence Retransmission Request.
+ */
+struct fcp_srr {
+       __u8            srr_op;         /* opcode ELS_SRR */
+       __u8            srr_resvd[3];   /* opcode / reserved - must be zero */
+       __be16          srr_ox_id;      /* OX_ID of failed command */
+       __be16          srr_rx_id;      /* RX_ID of failed command */
+       __be32          srr_rel_off;    /* relative offset */
+       __u8            srr_r_ctl;      /* r_ctl for the information unit */
+       __u8            srr_resvd2[3];  /* reserved */
+};
+
+/*
+ * Feature bits in name server FC-4 Features object.
+ */
+#define        FCP_FEAT_TARG   (1 << 0)        /* target function supported */
+#define        FCP_FEAT_INIT   (1 << 1)        /* initiator function supported */
+
+#endif /* _FC_FCP_H_ */