Add the rt linux 4.1.3-rt3 as base
[kvmfornfv.git] / kernel / include / linux / usb / isp1362.h
diff --git a/kernel/include/linux/usb/isp1362.h b/kernel/include/linux/usb/isp1362.h
new file mode 100644 (file)
index 0000000..642684b
--- /dev/null
@@ -0,0 +1,46 @@
+/*
+ * board initialization code should put one of these into dev->platform_data
+ * and place the isp1362 onto platform_bus.
+ */
+
+#ifndef __LINUX_USB_ISP1362_H__
+#define __LINUX_USB_ISP1362_H__
+
+struct isp1362_platform_data {
+       /* Enable internal pulldown resistors on downstream ports */
+       unsigned sel15Kres:1;
+       /* Clock cannot be stopped */
+       unsigned clknotstop:1;
+       /* On-chip overcurrent protection */
+       unsigned oc_enable:1;
+       /* INT output polarity */
+       unsigned int_act_high:1;
+       /* INT edge or level triggered */
+       unsigned int_edge_triggered:1;
+       /* DREQ output polarity */
+       unsigned dreq_act_high:1;
+       /* DACK input polarity */
+       unsigned dack_act_high:1;
+       /* chip can be resumed via H_WAKEUP pin */
+       unsigned remote_wakeup_connected:1;
+       /* Switch or not to switch (keep always powered) */
+       unsigned no_power_switching:1;
+       /* Ganged port power switching (0) or individual port power switching (1) */
+       unsigned power_switching_mode:1;
+       /* Given port_power, msec/2 after power on till power good */
+       u8 potpg;
+       /* Hardware reset set/clear */
+       void (*reset) (struct device *dev, int set);
+       /* Clock start/stop */
+       void (*clock) (struct device *dev, int start);
+       /* Inter-io delay (ns). The chip is picky about access timings; it
+        * expects at least:
+        * 110ns delay between consecutive accesses to DATA_REG,
+        * 300ns delay between access to ADDR_REG and DATA_REG (registers)
+        * 462ns delay between access to ADDR_REG and DATA_REG (buffer memory)
+        * WE MUST NOT be activated during these intervals (even without CS!)
+        */
+       void (*delay) (struct device *dev, unsigned int delay);
+};
+
+#endif