--- /dev/null
+/*
+ * Definitions for TI EMIF device platform data
+ *
+ * Copyright (C) 2012 Texas Instruments, Inc.
+ *
+ * Aneesh V <aneesh@ti.com>
+ *
+ * This program is free software; you can redistribute it and/or modify
+ * it under the terms of the GNU General Public License version 2 as
+ * published by the Free Software Foundation.
+ */
+#ifndef __EMIF_PLAT_H
+#define __EMIF_PLAT_H
+
+/* Low power modes - EMIF_PWR_MGMT_CTRL */
+#define EMIF_LP_MODE_DISABLE 0
+#define EMIF_LP_MODE_CLOCK_STOP 1
+#define EMIF_LP_MODE_SELF_REFRESH 2
+#define EMIF_LP_MODE_PWR_DN 4
+
+/* Hardware capabilities */
+#define EMIF_HW_CAPS_LL_INTERFACE 0x00000001
+
+/*
+ * EMIF IP Revisions
+ * EMIF4D - Used in OMAP4
+ * EMIF4D5 - Used in OMAP5
+ */
+#define EMIF_4D 1
+#define EMIF_4D5 2
+
+/*
+ * PHY types
+ * ATTILAPHY - Used in OMAP4
+ * INTELLIPHY - Used in OMAP5
+ */
+#define EMIF_PHY_TYPE_ATTILAPHY 1
+#define EMIF_PHY_TYPE_INTELLIPHY 2
+
+/* Custom config requests */
+#define EMIF_CUSTOM_CONFIG_LPMODE 0x00000001
+#define EMIF_CUSTOM_CONFIG_TEMP_ALERT_POLL_INTERVAL 0x00000002
+#define EMIF_CUSTOM_CONFIG_EXTENDED_TEMP_PART 0x00000004
+
+#ifndef __ASSEMBLY__
+/**
+ * struct ddr_device_info - All information about the DDR device except AC
+ * timing parameters
+ * @type: Device type (LPDDR2-S4, LPDDR2-S2 etc)
+ * @density: Device density
+ * @io_width: Bus width
+ * @cs1_used: Whether there is a DDR device attached to the second
+ * chip-select(CS1) of this EMIF instance
+ * @cal_resistors_per_cs: Whether there is one calibration resistor per
+ * chip-select or whether it's a single one for both
+ * @manufacturer: Manufacturer name string
+ */
+struct ddr_device_info {
+ u32 type;
+ u32 density;
+ u32 io_width;
+ u32 cs1_used;
+ u32 cal_resistors_per_cs;
+ char manufacturer[10];
+};
+
+/**
+ * struct emif_custom_configs - Custom configuration parameters/policies
+ * passed from the platform layer
+ * @mask: Mask to indicate which configs are requested
+ * @lpmode: LPMODE to be used in PWR_MGMT_CTRL register
+ * @lpmode_timeout_performance: Timeout before LPMODE entry when higher
+ * performance is desired at the cost of power (typically
+ * at higher OPPs)
+ * @lpmode_timeout_power: Timeout before LPMODE entry when better power
+ * savings is desired and performance is not important
+ * (typically at lower loads indicated by lower OPPs)
+ * @lpmode_freq_threshold: The DDR frequency threshold to identify between
+ * the above two cases:
+ * timeout = (freq >= lpmode_freq_threshold) ?
+ * lpmode_timeout_performance :
+ * lpmode_timeout_power;
+ * @temp_alert_poll_interval_ms: LPDDR2 MR4 polling interval at nominal
+ * temperature(in milliseconds). When temperature is high
+ * polling is done 4 times as frequently.
+ */
+struct emif_custom_configs {
+ u32 mask;
+ u32 lpmode;
+ u32 lpmode_timeout_performance;
+ u32 lpmode_timeout_power;
+ u32 lpmode_freq_threshold;
+ u32 temp_alert_poll_interval_ms;
+};
+
+/**
+ * struct emif_platform_data - Platform data passed on EMIF platform
+ * device creation. Used by the driver.
+ * @hw_caps: Hw capabilities of the EMIF IP in the respective SoC
+ * @device_info: Device info structure containing information such
+ * as type, bus width, density etc
+ * @timings: Timings information from device datasheet passed
+ * as an array of 'struct lpddr2_timings'. Can be NULL
+ * if if default timings are ok
+ * @timings_arr_size: Size of the timings array. Depends on the number
+ * of different frequencies for which timings data
+ * is provided
+ * @min_tck: Minimum value of some timing parameters in terms
+ * of number of cycles. Can be NULL if default values
+ * are ok
+ * @custom_configs: Custom configurations requested by SoC or board
+ * code and the data for them. Can be NULL if default
+ * configurations done by the driver are ok. See
+ * documentation for 'struct emif_custom_configs' for
+ * more details
+ */
+struct emif_platform_data {
+ u32 hw_caps;
+ struct ddr_device_info *device_info;
+ const struct lpddr2_timings *timings;
+ u32 timings_arr_size;
+ const struct lpddr2_min_tck *min_tck;
+ struct emif_custom_configs *custom_configs;
+ u32 ip_rev;
+ u32 phy_type;
+};
+#endif /* __ASSEMBLY__ */
+
+#endif /* __LINUX_EMIF_H */
Code Review / kvmfornfv.git / blobdiff