config FSL_USB2_OTG
bool "Freescale USB OTG Transceiver Driver"
depends on USB_EHCI_FSL && USB_FSL_USB2 && USB_OTG_FSM && PM
- select USB_OTG
select USB_PHY
help
Enable this to support Freescale USB OTG transceiver.
config USB_GPIO_VBUS
tristate "GPIO based peripheral-only VBUS sensing 'transceiver'"
- depends on GPIOLIB
+ depends on GPIOLIB || COMPILE_TEST
select USB_PHY
help
Provides simple GPIO VBUS sensing for controllers with an
tristate "Qualcomm on-chip USB OTG controller support"
depends on (USB || USB_GADGET) && (ARCH_QCOM || COMPILE_TEST)
depends on RESET_CONTROLLER
+ depends on EXTCON
select USB_PHY
help
Enable this to support the USB OTG transceiver on Qualcomm chips. It
This driver is not supported on boards like trout which
has an external PHY.
+config USB_QCOM_8X16_PHY
+ tristate "Qualcomm APQ8016/MSM8916 on-chip USB PHY controller support"
+ depends on ARCH_QCOM || COMPILE_TEST
+ depends on RESET_CONTROLLER && EXTCON
+ select USB_PHY
+ select USB_ULPI_VIEWPORT
+ help
+ Enable this to support the USB transceiver on Qualcomm 8x16 chipsets.
+ It handles PHY initialization, clock management, power management,
+ and workarounds required after resetting the hardware.
+
+ To compile this driver as a module, choose M here: the
+ module will be called phy-qcom-8x16-usb.
+
config USB_MV_OTG
tristate "Marvell USB OTG support"
- depends on USB_EHCI_MV && USB_MV_UDC && PM
- select USB_OTG
+ depends on USB_EHCI_MV && USB_MV_UDC && PM && USB_OTG
select USB_PHY
help
Say Y here if you want to build Marvell USB OTG transciever
To compile this driver as a module, choose M here: the
module will be called phy-rcar-usb.
-config USB_RCAR_GEN2_PHY
- tristate "Renesas R-Car Gen2 USB PHY support"
- depends on ARCH_R8A7790 || ARCH_R8A7791 || COMPILE_TEST
- select USB_PHY
- help
- Say Y here to add support for the Renesas R-Car Gen2 USB PHY driver.
- It is typically used to control internal USB PHY for USBHS,
- and to configure shared USB channels 0 and 2.
- This driver supports R8A7790 and R8A7791.
-
- To compile this driver as a module, choose M here: the
- module will be called phy-rcar-gen2-usb.
-
config USB_ULPI
bool "Generic ULPI Transceiver Driver"
depends on ARM || ARM64