--- /dev/null
+/*
+ * Bitbanged MDIO support.
+ *
+ * Author: Scott Wood <scottwood@freescale.com>
+ * Copyright (c) 2007 Freescale Semiconductor
+ *
+ * Based on CPM2 MDIO code which is:
+ *
+ * Copyright (c) 2003 Intracom S.A.
+ * by Pantelis Antoniou <panto@intracom.gr>
+ *
+ * 2005 (c) MontaVista Software, Inc.
+ * Vitaly Bordug <vbordug@ru.mvista.com>
+ *
+ * This file is licensed under the terms of the GNU General Public License
+ * version 2. This program is licensed "as is" without any warranty of any
+ * kind, whether express or implied.
+ */
+
+#include <linux/module.h>
+#include <linux/mdio-bitbang.h>
+#include <linux/types.h>
+#include <linux/delay.h>
+
+#define MDIO_READ 2
+#define MDIO_WRITE 1
+
+#define MDIO_C45 (1<<15)
+#define MDIO_C45_ADDR (MDIO_C45 | 0)
+#define MDIO_C45_READ (MDIO_C45 | 3)
+#define MDIO_C45_WRITE (MDIO_C45 | 1)
+
+#define MDIO_SETUP_TIME 10
+#define MDIO_HOLD_TIME 10
+
+/* Minimum MDC period is 400 ns, plus some margin for error. MDIO_DELAY
+ * is done twice per period.
+ */
+#define MDIO_DELAY 250
+
+/* The PHY may take up to 300 ns to produce data, plus some margin
+ * for error.
+ */
+#define MDIO_READ_DELAY 350
+
+/* MDIO must already be configured as output. */
+static void mdiobb_send_bit(struct mdiobb_ctrl *ctrl, int val)
+{
+ const struct mdiobb_ops *ops = ctrl->ops;
+
+ ops->set_mdio_data(ctrl, val);
+ ndelay(MDIO_DELAY);
+ ops->set_mdc(ctrl, 1);
+ ndelay(MDIO_DELAY);
+ ops->set_mdc(ctrl, 0);
+}
+
+/* MDIO must already be configured as input. */
+static int mdiobb_get_bit(struct mdiobb_ctrl *ctrl)
+{
+ const struct mdiobb_ops *ops = ctrl->ops;
+
+ ndelay(MDIO_DELAY);
+ ops->set_mdc(ctrl, 1);
+ ndelay(MDIO_READ_DELAY);
+ ops->set_mdc(ctrl, 0);
+
+ return ops->get_mdio_data(ctrl);
+}
+
+/* MDIO must already be configured as output. */
+static void mdiobb_send_num(struct mdiobb_ctrl *ctrl, u16 val, int bits)
+{
+ int i;
+
+ for (i = bits - 1; i >= 0; i--)
+ mdiobb_send_bit(ctrl, (val >> i) & 1);
+}
+
+/* MDIO must already be configured as input. */
+static u16 mdiobb_get_num(struct mdiobb_ctrl *ctrl, int bits)
+{
+ int i;
+ u16 ret = 0;
+
+ for (i = bits - 1; i >= 0; i--) {
+ ret <<= 1;
+ ret |= mdiobb_get_bit(ctrl);
+ }
+
+ return ret;
+}
+
+/* Utility to send the preamble, address, and
+ * register (common to read and write).
+ */
+static void mdiobb_cmd(struct mdiobb_ctrl *ctrl, int op, u8 phy, u8 reg)
+{
+ const struct mdiobb_ops *ops = ctrl->ops;
+ int i;
+
+ ops->set_mdio_dir(ctrl, 1);
+
+ /*
+ * Send a 32 bit preamble ('1's) with an extra '1' bit for good
+ * measure. The IEEE spec says this is a PHY optional
+ * requirement. The AMD 79C874 requires one after power up and
+ * one after a MII communications error. This means that we are
+ * doing more preambles than we need, but it is safer and will be
+ * much more robust.
+ */
+
+ for (i = 0; i < 32; i++)
+ mdiobb_send_bit(ctrl, 1);
+
+ /* send the start bit (01) and the read opcode (10) or write (10).
+ Clause 45 operation uses 00 for the start and 11, 10 for
+ read/write */
+ mdiobb_send_bit(ctrl, 0);
+ if (op & MDIO_C45)
+ mdiobb_send_bit(ctrl, 0);
+ else
+ mdiobb_send_bit(ctrl, 1);
+ mdiobb_send_bit(ctrl, (op >> 1) & 1);
+ mdiobb_send_bit(ctrl, (op >> 0) & 1);
+
+ mdiobb_send_num(ctrl, phy, 5);
+ mdiobb_send_num(ctrl, reg, 5);
+}
+
+/* In clause 45 mode all commands are prefixed by MDIO_ADDR to specify the
+ lower 16 bits of the 21 bit address. This transfer is done identically to a
+ MDIO_WRITE except for a different code. To enable clause 45 mode or
+ MII_ADDR_C45 into the address. Theoretically clause 45 and normal devices
+ can exist on the same bus. Normal devices should ignore the MDIO_ADDR
+ phase. */
+static int mdiobb_cmd_addr(struct mdiobb_ctrl *ctrl, int phy, u32 addr)
+{
+ unsigned int dev_addr = (addr >> 16) & 0x1F;
+ unsigned int reg = addr & 0xFFFF;
+ mdiobb_cmd(ctrl, MDIO_C45_ADDR, phy, dev_addr);
+
+ /* send the turnaround (10) */
+ mdiobb_send_bit(ctrl, 1);
+ mdiobb_send_bit(ctrl, 0);
+
+ mdiobb_send_num(ctrl, reg, 16);
+
+ ctrl->ops->set_mdio_dir(ctrl, 0);
+ mdiobb_get_bit(ctrl);
+
+ return dev_addr;
+}
+
+static int mdiobb_read(struct mii_bus *bus, int phy, int reg)
+{
+ struct mdiobb_ctrl *ctrl = bus->priv;
+ int ret, i;
+
+ if (reg & MII_ADDR_C45) {
+ reg = mdiobb_cmd_addr(ctrl, phy, reg);
+ mdiobb_cmd(ctrl, MDIO_C45_READ, phy, reg);
+ } else
+ mdiobb_cmd(ctrl, MDIO_READ, phy, reg);
+
+ ctrl->ops->set_mdio_dir(ctrl, 0);
+
+ /* check the turnaround bit: the PHY should be driving it to zero */
+ if (mdiobb_get_bit(ctrl) != 0) {
+ /* PHY didn't drive TA low -- flush any bits it
+ * may be trying to send.
+ */
+ for (i = 0; i < 32; i++)
+ mdiobb_get_bit(ctrl);
+
+ return 0xffff;
+ }
+
+ ret = mdiobb_get_num(ctrl, 16);
+ mdiobb_get_bit(ctrl);
+ return ret;
+}
+
+static int mdiobb_write(struct mii_bus *bus, int phy, int reg, u16 val)
+{
+ struct mdiobb_ctrl *ctrl = bus->priv;
+
+ if (reg & MII_ADDR_C45) {
+ reg = mdiobb_cmd_addr(ctrl, phy, reg);
+ mdiobb_cmd(ctrl, MDIO_C45_WRITE, phy, reg);
+ } else
+ mdiobb_cmd(ctrl, MDIO_WRITE, phy, reg);
+
+ /* send the turnaround (10) */
+ mdiobb_send_bit(ctrl, 1);
+ mdiobb_send_bit(ctrl, 0);
+
+ mdiobb_send_num(ctrl, val, 16);
+
+ ctrl->ops->set_mdio_dir(ctrl, 0);
+ mdiobb_get_bit(ctrl);
+ return 0;
+}
+
+static int mdiobb_reset(struct mii_bus *bus)
+{
+ struct mdiobb_ctrl *ctrl = bus->priv;
+ if (ctrl->reset)
+ ctrl->reset(bus);
+ return 0;
+}
+
+struct mii_bus *alloc_mdio_bitbang(struct mdiobb_ctrl *ctrl)
+{
+ struct mii_bus *bus;
+
+ bus = mdiobus_alloc();
+ if (!bus)
+ return NULL;
+
+ __module_get(ctrl->ops->owner);
+
+ bus->read = mdiobb_read;
+ bus->write = mdiobb_write;
+ bus->reset = mdiobb_reset;
+ bus->priv = ctrl;
+
+ return bus;
+}
+EXPORT_SYMBOL(alloc_mdio_bitbang);
+
+void free_mdio_bitbang(struct mii_bus *bus)
+{
+ struct mdiobb_ctrl *ctrl = bus->priv;
+
+ module_put(ctrl->ops->owner);
+ mdiobus_free(bus);
+}
+EXPORT_SYMBOL(free_mdio_bitbang);
+
+MODULE_LICENSE("GPL");
Code Review / kvmfornfv.git / blobdiff