Add the rt linux 4.1.3-rt3 as base

[kvmfornfv.git] / kernel / drivers / net / hippi / Kconfig

diff --git a/kernel/drivers/net/hippi/Kconfig b/kernel/drivers/net/hippi/Kconfig
new file mode 100644 (file)
index 0000000..f71515d
--- /dev/null
+++ b/kernel/drivers/net/hippi/Kconfig
@@ -0,0 +1,39 @@
+#
+# HIPPI network device configuration
+#
+
+config HIPPI
+       bool "HIPPI driver support"
+       depends on INET && PCI
+       ---help---
+         HIgh Performance Parallel Interface (HIPPI) is a 800Mbit/sec and
+         1600Mbit/sec dual-simplex switched or point-to-point network. HIPPI
+         can run over copper (25m) or fiber (300m on multi-mode or 10km on
+         single-mode). HIPPI networks are commonly used for clusters and to
+         connect to super computers. If you are connected to a HIPPI network
+         and have a HIPPI network card in your computer that you want to use
+         under Linux, say Y here (you must also remember to enable the driver
+         for your HIPPI card below). Most people will say N here.
+
+if HIPPI
+
+config ROADRUNNER
+       tristate "Essential RoadRunner HIPPI PCI adapter support"
+       depends on PCI
+       ---help---
+         Say Y here if this is your PCI HIPPI network card.
+
+         To compile this driver as a module, choose M here: the module
+         will be called rrunner.  If unsure, say N.
+
+config ROADRUNNER_LARGE_RINGS
+       bool "Use large TX/RX rings"
+       depends on ROADRUNNER
+       ---help---
+         If you say Y here, the RoadRunner driver will preallocate up to 2 MB
+         of additional memory to allow for fastest operation, both for
+         transmitting and receiving. This memory cannot be used by any other
+         kernel code or by user space programs. Say Y here only if you have
+         the memory.
+
+endif # HIPPI