Add the rt linux 4.1.3-rt3 as base

[kvmfornfv.git] / kernel / drivers / net / ethernet / micrel / Kconfig

diff --git a/kernel/drivers/net/ethernet/micrel/Kconfig b/kernel/drivers/net/ethernet/micrel/Kconfig
new file mode 100644 (file)
index 0000000..d16b11e
--- /dev/null
+++ b/kernel/drivers/net/ethernet/micrel/Kconfig
@@ -0,0 +1,66 @@
+#
+# Micrel device configuration
+#
+
+config NET_VENDOR_MICREL
+       bool "Micrel devices"
+       default y
+       depends on (HAS_IOMEM && DMA_ENGINE) || SPI || PCI || HAS_IOMEM || \
+                  (ARM && ARCH_KS8695)
+       ---help---
+         If you have a network (Ethernet) card belonging to this class, say Y
+         and read the Ethernet-HOWTO, available from
+         <http://www.tldp.org/docs.html#howto>.
+
+         Note that the answer to this question doesn't directly affect the
+         kernel: saying N will just cause the configurator to skip all
+         the questions about Micrel devices. If you say Y, you will be asked
+         for your specific card in the following questions.
+
+if NET_VENDOR_MICREL
+
+config ARM_KS8695_ETHER
+       tristate "KS8695 Ethernet support"
+       depends on ARM && ARCH_KS8695
+       select MII
+       ---help---
+         If you wish to compile a kernel for the KS8695 and want to
+         use the internal ethernet then you should answer Y to this.
+
+config KS8842
+       tristate "Micrel KSZ8841/42 with generic bus interface"
+       depends on HAS_IOMEM && DMA_ENGINE
+       ---help---
+         This platform driver is for KSZ8841(1-port) / KS8842(2-port)
+         ethernet switch chip (managed, VLAN, QoS) from Micrel or
+         Timberdale(FPGA).
+
+config KS8851
+       tristate "Micrel KS8851 SPI"
+       depends on SPI
+       select MII
+       select CRC32
+       select EEPROM_93CX6
+       ---help---
+         SPI driver for Micrel KS8851 SPI attached network chip.
+
+config KS8851_MLL
+       tristate "Micrel KS8851 MLL"
+       depends on HAS_IOMEM
+       select MII
+       ---help---
+         This platform driver is for Micrel KS8851 Address/data bus
+         multiplexed network chip.
+
+config KSZ884X_PCI
+       tristate "Micrel KSZ8841/2 PCI"
+       depends on PCI
+       select MII
+       select CRC32
+       ---help---
+         This PCI driver is for Micrel KSZ8841/KSZ8842 PCI Ethernet chip.
+
+         To compile this driver as a module, choose M here. The module
+         will be called ksz884x.
+
+endif # NET_VENDOR_MICREL