Add the rt linux 4.1.3-rt3 as base
[kvmfornfv.git] / kernel / drivers / ide / tx4938ide.c
diff --git a/kernel/drivers/ide/tx4938ide.c b/kernel/drivers/ide/tx4938ide.c
new file mode 100644 (file)
index 0000000..40a3f55
--- /dev/null
@@ -0,0 +1,209 @@
+/*
+ * TX4938 internal IDE driver
+ * Based on tx4939ide.c.
+ *
+ * This file is subject to the terms and conditions of the GNU General Public
+ * License.  See the file "COPYING" in the main directory of this archive
+ * for more details.
+ *
+ * (C) Copyright TOSHIBA CORPORATION 2005-2007
+ */
+
+#include <linux/module.h>
+#include <linux/types.h>
+#include <linux/ide.h>
+#include <linux/init.h>
+#include <linux/platform_device.h>
+#include <linux/io.h>
+
+#include <asm/ide.h>
+#include <asm/txx9/tx4938.h>
+
+static void tx4938ide_tune_ebusc(unsigned int ebus_ch,
+                                unsigned int gbus_clock,
+                                u8 pio)
+{
+       struct ide_timing *t = ide_timing_find_mode(XFER_PIO_0 + pio);
+       u64 cr = __raw_readq(&tx4938_ebuscptr->cr[ebus_ch]);
+       unsigned int sp = (cr >> 4) & 3;
+       unsigned int clock = gbus_clock / (4 - sp);
+       unsigned int cycle = 1000000000 / clock;
+       unsigned int shwt;
+       int wt;
+
+       /* Minimum DIOx- active time */
+       wt = DIV_ROUND_UP(t->act8b, cycle) - 2;
+       /* IORDY setup time: 35ns */
+       wt = max_t(int, wt, DIV_ROUND_UP(35, cycle));
+       /* actual wait-cycle is max(wt & ~1, 1) */
+       if (wt > 2 && (wt & 1))
+               wt++;
+       wt &= ~1;
+       /* Address-valid to DIOR/DIOW setup */
+       shwt = DIV_ROUND_UP(t->setup, cycle);
+
+       /* -DIOx recovery time (SHWT * 4) and cycle time requirement */
+       while ((shwt * 4 + wt + (wt ? 2 : 3)) * cycle < t->cycle)
+               shwt++;
+       if (shwt > 7) {
+               pr_warning("tx4938ide: SHWT violation (%d)\n", shwt);
+               shwt = 7;
+       }
+       pr_debug("tx4938ide: ebus %d, bus cycle %dns, WT %d, SHWT %d\n",
+                ebus_ch, cycle, wt, shwt);
+
+       __raw_writeq((cr & ~0x3f007ull) | (wt << 12) | shwt,
+                    &tx4938_ebuscptr->cr[ebus_ch]);
+}
+
+static void tx4938ide_set_pio_mode(ide_hwif_t *hwif, ide_drive_t *drive)
+{
+       struct tx4938ide_platform_info *pdata = dev_get_platdata(hwif->dev);
+       u8 safe = drive->pio_mode - XFER_PIO_0;
+       ide_drive_t *pair;
+
+       pair = ide_get_pair_dev(drive);
+       if (pair)
+               safe = min_t(u8, safe, pair->pio_mode - XFER_PIO_0);
+       tx4938ide_tune_ebusc(pdata->ebus_ch, pdata->gbus_clock, safe);
+}
+
+#ifdef __BIG_ENDIAN
+
+/* custom iops (independent from SWAP_IO_SPACE) */
+static void tx4938ide_input_data_swap(ide_drive_t *drive, struct ide_cmd *cmd,
+                               void *buf, unsigned int len)
+{
+       unsigned long port = drive->hwif->io_ports.data_addr;
+       unsigned short *ptr = buf;
+       unsigned int count = (len + 1) / 2;
+
+       while (count--)
+               *ptr++ = cpu_to_le16(__raw_readw((void __iomem *)port));
+       __ide_flush_dcache_range((unsigned long)buf, roundup(len, 2));
+}
+
+static void tx4938ide_output_data_swap(ide_drive_t *drive, struct ide_cmd *cmd,
+                               void *buf, unsigned int len)
+{
+       unsigned long port = drive->hwif->io_ports.data_addr;
+       unsigned short *ptr = buf;
+       unsigned int count = (len + 1) / 2;
+
+       while (count--) {
+               __raw_writew(le16_to_cpu(*ptr), (void __iomem *)port);
+               ptr++;
+       }
+       __ide_flush_dcache_range((unsigned long)buf, roundup(len, 2));
+}
+
+static const struct ide_tp_ops tx4938ide_tp_ops = {
+       .exec_command           = ide_exec_command,
+       .read_status            = ide_read_status,
+       .read_altstatus         = ide_read_altstatus,
+       .write_devctl           = ide_write_devctl,
+
+       .dev_select             = ide_dev_select,
+       .tf_load                = ide_tf_load,
+       .tf_read                = ide_tf_read,
+
+       .input_data             = tx4938ide_input_data_swap,
+       .output_data            = tx4938ide_output_data_swap,
+};
+
+#endif /* __BIG_ENDIAN */
+
+static const struct ide_port_ops tx4938ide_port_ops = {
+       .set_pio_mode           = tx4938ide_set_pio_mode,
+};
+
+static const struct ide_port_info tx4938ide_port_info __initconst = {
+       .port_ops               = &tx4938ide_port_ops,
+#ifdef __BIG_ENDIAN
+       .tp_ops                 = &tx4938ide_tp_ops,
+#endif
+       .host_flags             = IDE_HFLAG_MMIO | IDE_HFLAG_NO_DMA,
+       .pio_mask               = ATA_PIO5,
+       .chipset                = ide_generic,
+};
+
+static int __init tx4938ide_probe(struct platform_device *pdev)
+{
+       struct ide_hw hw, *hws[] = { &hw };
+       struct ide_host *host;
+       struct resource *res;
+       struct tx4938ide_platform_info *pdata = dev_get_platdata(&pdev->dev);
+       int irq, ret, i;
+       unsigned long mapbase, mapctl;
+       struct ide_port_info d = tx4938ide_port_info;
+
+       irq = platform_get_irq(pdev, 0);
+       if (irq < 0)
+               return -ENODEV;
+       res = platform_get_resource(pdev, IORESOURCE_MEM, 0);
+       if (!res)
+               return -ENODEV;
+
+       if (!devm_request_mem_region(&pdev->dev, res->start,
+                                    resource_size(res), "tx4938ide"))
+               return -EBUSY;
+       mapbase = (unsigned long)devm_ioremap(&pdev->dev, res->start,
+                                             8 << pdata->ioport_shift);
+       mapctl = (unsigned long)devm_ioremap(&pdev->dev,
+                                            res->start + 0x10000 +
+                                            (6 << pdata->ioport_shift),
+                                            1 << pdata->ioport_shift);
+       if (!mapbase || !mapctl)
+               return -EBUSY;
+
+       memset(&hw, 0, sizeof(hw));
+       if (pdata->ioport_shift) {
+               unsigned long port = mapbase;
+               unsigned long ctl = mapctl;
+
+               hw.io_ports_array[0] = port;
+#ifdef __BIG_ENDIAN
+               port++;
+               ctl++;
+#endif
+               for (i = 1; i <= 7; i++)
+                       hw.io_ports_array[i] =
+                               port + (i << pdata->ioport_shift);
+               hw.io_ports.ctl_addr = ctl;
+       } else
+               ide_std_init_ports(&hw, mapbase, mapctl);
+       hw.irq = irq;
+       hw.dev = &pdev->dev;
+
+       pr_info("TX4938 IDE interface (base %#lx, ctl %#lx, irq %d)\n",
+               mapbase, mapctl, hw.irq);
+       if (pdata->gbus_clock)
+               tx4938ide_tune_ebusc(pdata->ebus_ch, pdata->gbus_clock, 0);
+       else
+               d.port_ops = NULL;
+       ret = ide_host_add(&d, hws, 1, &host);
+       if (!ret)
+               platform_set_drvdata(pdev, host);
+       return ret;
+}
+
+static int __exit tx4938ide_remove(struct platform_device *pdev)
+{
+       struct ide_host *host = platform_get_drvdata(pdev);
+
+       ide_host_remove(host);
+       return 0;
+}
+
+static struct platform_driver tx4938ide_driver = {
+       .driver         = {
+               .name   = "tx4938ide",
+       },
+       .remove = __exit_p(tx4938ide_remove),
+};
+
+module_platform_driver_probe(tx4938ide_driver, tx4938ide_probe);
+
+MODULE_DESCRIPTION("TX4938 internal IDE driver");
+MODULE_LICENSE("GPL");
+MODULE_ALIAS("platform:tx4938ide");