--- /dev/null
+/******************************************************************************
+ *
+ * Name: hwsleep.c - ACPI Hardware Sleep/Wake Support functions for the
+ * original/legacy sleep/PM registers.
+ *
+ *****************************************************************************/
+
+/*
+ * Copyright (C) 2000 - 2015, Intel Corp.
+ * All rights reserved.
+ *
+ * Redistribution and use in source and binary forms, with or without
+ * modification, are permitted provided that the following conditions
+ * are met:
+ * 1. Redistributions of source code must retain the above copyright
+ * notice, this list of conditions, and the following disclaimer,
+ * without modification.
+ * 2. Redistributions in binary form must reproduce at minimum a disclaimer
+ * substantially similar to the "NO WARRANTY" disclaimer below
+ * ("Disclaimer") and any redistribution must be conditioned upon
+ * including a substantially similar Disclaimer requirement for further
+ * binary redistribution.
+ * 3. Neither the names of the above-listed copyright holders nor the names
+ * of any contributors may be used to endorse or promote products derived
+ * from this software without specific prior written permission.
+ *
+ * Alternatively, this software may be distributed under the terms of the
+ * GNU General Public License ("GPL") version 2 as published by the Free
+ * Software Foundation.
+ *
+ * NO WARRANTY
+ * THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS
+ * "AS IS" AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT
+ * LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTIBILITY AND FITNESS FOR
+ * A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT
+ * HOLDERS OR CONTRIBUTORS BE LIABLE FOR SPECIAL, EXEMPLARY, OR CONSEQUENTIAL
+ * DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS
+ * OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION)
+ * HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT,
+ * STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING
+ * IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE
+ * POSSIBILITY OF SUCH DAMAGES.
+ */
+
+#include <acpi/acpi.h>
+#include <linux/acpi.h>
+#include "accommon.h"
+
+#define _COMPONENT ACPI_HARDWARE
+ACPI_MODULE_NAME("hwsleep")
+
+#if (!ACPI_REDUCED_HARDWARE) /* Entire module */
+/*******************************************************************************
+ *
+ * FUNCTION: acpi_hw_legacy_sleep
+ *
+ * PARAMETERS: sleep_state - Which sleep state to enter
+ *
+ * RETURN: Status
+ *
+ * DESCRIPTION: Enter a system sleep state via the legacy FADT PM registers
+ * THIS FUNCTION MUST BE CALLED WITH INTERRUPTS DISABLED
+ *
+ ******************************************************************************/
+acpi_status acpi_hw_legacy_sleep(u8 sleep_state)
+{
+ struct acpi_bit_register_info *sleep_type_reg_info;
+ struct acpi_bit_register_info *sleep_enable_reg_info;
+ u32 pm1a_control;
+ u32 pm1b_control;
+ u32 in_value;
+ acpi_status status;
+
+ ACPI_FUNCTION_TRACE(hw_legacy_sleep);
+
+ sleep_type_reg_info =
+ acpi_hw_get_bit_register_info(ACPI_BITREG_SLEEP_TYPE);
+ sleep_enable_reg_info =
+ acpi_hw_get_bit_register_info(ACPI_BITREG_SLEEP_ENABLE);
+
+ /* Clear wake status */
+
+ status =
+ acpi_write_bit_register(ACPI_BITREG_WAKE_STATUS, ACPI_CLEAR_STATUS);
+ if (ACPI_FAILURE(status)) {
+ return_ACPI_STATUS(status);
+ }
+
+ /* Clear all fixed and general purpose status bits */
+
+ status = acpi_hw_clear_acpi_status();
+ if (ACPI_FAILURE(status)) {
+ return_ACPI_STATUS(status);
+ }
+
+ /*
+ * 1) Disable/Clear all GPEs
+ * 2) Enable all wakeup GPEs
+ */
+ status = acpi_hw_disable_all_gpes();
+ if (ACPI_FAILURE(status)) {
+ return_ACPI_STATUS(status);
+ }
+ acpi_gbl_system_awake_and_running = FALSE;
+
+ status = acpi_hw_enable_all_wakeup_gpes();
+ if (ACPI_FAILURE(status)) {
+ return_ACPI_STATUS(status);
+ }
+
+ /* Get current value of PM1A control */
+
+ status = acpi_hw_register_read(ACPI_REGISTER_PM1_CONTROL,
+ &pm1a_control);
+ if (ACPI_FAILURE(status)) {
+ return_ACPI_STATUS(status);
+ }
+ ACPI_DEBUG_PRINT((ACPI_DB_INIT,
+ "Entering sleep state [S%u]\n", sleep_state));
+
+ /* Clear the SLP_EN and SLP_TYP fields */
+
+ pm1a_control &= ~(sleep_type_reg_info->access_bit_mask |
+ sleep_enable_reg_info->access_bit_mask);
+ pm1b_control = pm1a_control;
+
+ /* Insert the SLP_TYP bits */
+
+ pm1a_control |=
+ (acpi_gbl_sleep_type_a << sleep_type_reg_info->bit_position);
+ pm1b_control |=
+ (acpi_gbl_sleep_type_b << sleep_type_reg_info->bit_position);
+
+ /*
+ * We split the writes of SLP_TYP and SLP_EN to workaround
+ * poorly implemented hardware.
+ */
+
+ /* Write #1: write the SLP_TYP data to the PM1 Control registers */
+
+ status = acpi_hw_write_pm1_control(pm1a_control, pm1b_control);
+ if (ACPI_FAILURE(status)) {
+ return_ACPI_STATUS(status);
+ }
+
+ /* Insert the sleep enable (SLP_EN) bit */
+
+ pm1a_control |= sleep_enable_reg_info->access_bit_mask;
+ pm1b_control |= sleep_enable_reg_info->access_bit_mask;
+
+ /* Flush caches, as per ACPI specification */
+
+ ACPI_FLUSH_CPU_CACHE();
+
+ status = acpi_os_prepare_sleep(sleep_state, pm1a_control,
+ pm1b_control);
+ if (ACPI_SKIP(status))
+ return_ACPI_STATUS(AE_OK);
+ if (ACPI_FAILURE(status))
+ return_ACPI_STATUS(status);
+ /* Write #2: Write both SLP_TYP + SLP_EN */
+
+ status = acpi_hw_write_pm1_control(pm1a_control, pm1b_control);
+ if (ACPI_FAILURE(status)) {
+ return_ACPI_STATUS(status);
+ }
+
+ if (sleep_state > ACPI_STATE_S3) {
+ /*
+ * We wanted to sleep > S3, but it didn't happen (by virtue of the
+ * fact that we are still executing!)
+ *
+ * Wait ten seconds, then try again. This is to get S4/S5 to work on
+ * all machines.
+ *
+ * We wait so long to allow chipsets that poll this reg very slowly
+ * to still read the right value. Ideally, this block would go
+ * away entirely.
+ */
+ acpi_os_stall(10 * ACPI_USEC_PER_SEC);
+
+ status = acpi_hw_register_write(ACPI_REGISTER_PM1_CONTROL,
+ sleep_enable_reg_info->
+ access_bit_mask);
+ if (ACPI_FAILURE(status)) {
+ return_ACPI_STATUS(status);
+ }
+ }
+
+ /* Wait for transition back to Working State */
+
+ do {
+ status =
+ acpi_read_bit_register(ACPI_BITREG_WAKE_STATUS, &in_value);
+ if (ACPI_FAILURE(status)) {
+ return_ACPI_STATUS(status);
+ }
+
+ } while (!in_value);
+
+ return_ACPI_STATUS(AE_OK);
+}
+
+/*******************************************************************************
+ *
+ * FUNCTION: acpi_hw_legacy_wake_prep
+ *
+ * PARAMETERS: sleep_state - Which sleep state we just exited
+ *
+ * RETURN: Status
+ *
+ * DESCRIPTION: Perform the first state of OS-independent ACPI cleanup after a
+ * sleep.
+ * Called with interrupts ENABLED.
+ *
+ ******************************************************************************/
+
+acpi_status acpi_hw_legacy_wake_prep(u8 sleep_state)
+{
+ acpi_status status;
+ struct acpi_bit_register_info *sleep_type_reg_info;
+ struct acpi_bit_register_info *sleep_enable_reg_info;
+ u32 pm1a_control;
+ u32 pm1b_control;
+
+ ACPI_FUNCTION_TRACE(hw_legacy_wake_prep);
+
+ /*
+ * Set SLP_TYPE and SLP_EN to state S0.
+ * This is unclear from the ACPI Spec, but it is required
+ * by some machines.
+ */
+ status = acpi_get_sleep_type_data(ACPI_STATE_S0,
+ &acpi_gbl_sleep_type_a,
+ &acpi_gbl_sleep_type_b);
+ if (ACPI_SUCCESS(status)) {
+ sleep_type_reg_info =
+ acpi_hw_get_bit_register_info(ACPI_BITREG_SLEEP_TYPE);
+ sleep_enable_reg_info =
+ acpi_hw_get_bit_register_info(ACPI_BITREG_SLEEP_ENABLE);
+
+ /* Get current value of PM1A control */
+
+ status = acpi_hw_register_read(ACPI_REGISTER_PM1_CONTROL,
+ &pm1a_control);
+ if (ACPI_SUCCESS(status)) {
+
+ /* Clear the SLP_EN and SLP_TYP fields */
+
+ pm1a_control &= ~(sleep_type_reg_info->access_bit_mask |
+ sleep_enable_reg_info->
+ access_bit_mask);
+ pm1b_control = pm1a_control;
+
+ /* Insert the SLP_TYP bits */
+
+ pm1a_control |= (acpi_gbl_sleep_type_a <<
+ sleep_type_reg_info->bit_position);
+ pm1b_control |= (acpi_gbl_sleep_type_b <<
+ sleep_type_reg_info->bit_position);
+
+ /* Write the control registers and ignore any errors */
+
+ (void)acpi_hw_write_pm1_control(pm1a_control,
+ pm1b_control);
+ }
+ }
+
+ return_ACPI_STATUS(status);
+}
+
+/*******************************************************************************
+ *
+ * FUNCTION: acpi_hw_legacy_wake
+ *
+ * PARAMETERS: sleep_state - Which sleep state we just exited
+ *
+ * RETURN: Status
+ *
+ * DESCRIPTION: Perform OS-independent ACPI cleanup after a sleep
+ * Called with interrupts ENABLED.
+ *
+ ******************************************************************************/
+
+acpi_status acpi_hw_legacy_wake(u8 sleep_state)
+{
+ acpi_status status;
+
+ ACPI_FUNCTION_TRACE(hw_legacy_wake);
+
+ /* Ensure enter_sleep_state_prep -> enter_sleep_state ordering */
+
+ acpi_gbl_sleep_type_a = ACPI_SLEEP_TYPE_INVALID;
+ acpi_hw_execute_sleep_method(METHOD_PATHNAME__SST, ACPI_SST_WAKING);
+
+ /*
+ * GPEs must be enabled before _WAK is called as GPEs
+ * might get fired there
+ *
+ * Restore the GPEs:
+ * 1) Disable/Clear all GPEs
+ * 2) Enable all runtime GPEs
+ */
+ status = acpi_hw_disable_all_gpes();
+ if (ACPI_FAILURE(status)) {
+ return_ACPI_STATUS(status);
+ }
+
+ status = acpi_hw_enable_all_runtime_gpes();
+ if (ACPI_FAILURE(status)) {
+ return_ACPI_STATUS(status);
+ }
+
+ /*
+ * Now we can execute _WAK, etc. Some machines require that the GPEs
+ * are enabled before the wake methods are executed.
+ */
+ acpi_hw_execute_sleep_method(METHOD_PATHNAME__WAK, sleep_state);
+
+ /*
+ * Some BIOS code assumes that WAK_STS will be cleared on resume
+ * and use it to determine whether the system is rebooting or
+ * resuming. Clear WAK_STS for compatibility.
+ */
+ (void)acpi_write_bit_register(ACPI_BITREG_WAKE_STATUS,
+ ACPI_CLEAR_STATUS);
+ acpi_gbl_system_awake_and_running = TRUE;
+
+ /* Enable power button */
+
+ (void)
+ acpi_write_bit_register(acpi_gbl_fixed_event_info
+ [ACPI_EVENT_POWER_BUTTON].
+ enable_register_id, ACPI_ENABLE_EVENT);
+
+ (void)
+ acpi_write_bit_register(acpi_gbl_fixed_event_info
+ [ACPI_EVENT_POWER_BUTTON].
+ status_register_id, ACPI_CLEAR_STATUS);
+
+ acpi_hw_execute_sleep_method(METHOD_PATHNAME__SST, ACPI_SST_WORKING);
+ return_ACPI_STATUS(status);
+}
+
+#endif /* !ACPI_REDUCED_HARDWARE */
Code Review / kvmfornfv.git / blobdiff