--- /dev/null
+/*
+ * ip22-mc.c: Routines for manipulating SGI Memory Controller.
+ *
+ * Copyright (C) 1996 David S. Miller (davem@davemloft.net)
+ * Copyright (C) 1999 Andrew R. Baker (andrewb@uab.edu) - Indigo2 changes
+ * Copyright (C) 2003 Ladislav Michl (ladis@linux-mips.org)
+ * Copyright (C) 2004 Peter Fuerst (pf@net.alphadv.de) - IP28
+ */
+
+#include <linux/init.h>
+#include <linux/module.h>
+#include <linux/kernel.h>
+
+#include <asm/io.h>
+#include <asm/bootinfo.h>
+#include <asm/sgialib.h>
+#include <asm/sgi/mc.h>
+#include <asm/sgi/hpc3.h>
+#include <asm/sgi/ip22.h>
+
+struct sgimc_regs *sgimc;
+
+EXPORT_SYMBOL(sgimc);
+
+static inline unsigned long get_bank_addr(unsigned int memconfig)
+{
+ return (memconfig & SGIMC_MCONFIG_BASEADDR) << ((sgimc->systemid & SGIMC_SYSID_MASKREV) >= 5 ? 24 : 22);
+}
+
+static inline unsigned long get_bank_size(unsigned int memconfig)
+{
+ return ((memconfig & SGIMC_MCONFIG_RMASK) + 0x0100) << ((sgimc->systemid & SGIMC_SYSID_MASKREV) >= 5 ? 16 : 14);
+}
+
+static inline unsigned int get_bank_config(int bank)
+{
+ unsigned int res = bank > 1 ? sgimc->mconfig1 : sgimc->mconfig0;
+ return bank % 2 ? res & 0xffff : res >> 16;
+}
+
+struct mem {
+ unsigned long addr;
+ unsigned long size;
+};
+
+/*
+ * Detect installed memory, do some sanity checks and notify kernel about it
+ */
+static void __init probe_memory(void)
+{
+ int i, j, found, cnt = 0;
+ struct mem bank[4];
+ struct mem space[2] = {{SGIMC_SEG0_BADDR, 0}, {SGIMC_SEG1_BADDR, 0}};
+
+ printk(KERN_INFO "MC: Probing memory configuration:\n");
+ for (i = 0; i < ARRAY_SIZE(bank); i++) {
+ unsigned int tmp = get_bank_config(i);
+ if (!(tmp & SGIMC_MCONFIG_BVALID))
+ continue;
+
+ bank[cnt].size = get_bank_size(tmp);
+ bank[cnt].addr = get_bank_addr(tmp);
+ printk(KERN_INFO " bank%d: %3ldM @ %08lx\n",
+ i, bank[cnt].size / 1024 / 1024, bank[cnt].addr);
+ cnt++;
+ }
+
+ /* And you thought bubble sort is dead algorithm... */
+ do {
+ unsigned long addr, size;
+
+ found = 0;
+ for (i = 1; i < cnt; i++)
+ if (bank[i-1].addr > bank[i].addr) {
+ addr = bank[i].addr;
+ size = bank[i].size;
+ bank[i].addr = bank[i-1].addr;
+ bank[i].size = bank[i-1].size;
+ bank[i-1].addr = addr;
+ bank[i-1].size = size;
+ found = 1;
+ }
+ } while (found);
+
+ /* Figure out how are memory banks mapped into spaces */
+ for (i = 0; i < cnt; i++) {
+ found = 0;
+ for (j = 0; j < ARRAY_SIZE(space) && !found; j++)
+ if (space[j].addr + space[j].size == bank[i].addr) {
+ space[j].size += bank[i].size;
+ found = 1;
+ }
+ /* There is either hole or overlapping memory */
+ if (!found)
+ printk(KERN_CRIT "MC: Memory configuration mismatch "
+ "(%08lx), expect Bus Error soon\n",
+ bank[i].addr);
+ }
+
+ for (i = 0; i < ARRAY_SIZE(space); i++)
+ if (space[i].size)
+ add_memory_region(space[i].addr, space[i].size,
+ BOOT_MEM_RAM);
+}
+
+void __init sgimc_init(void)
+{
+ u32 tmp;
+
+ /* ioremap can't fail */
+ sgimc = (struct sgimc_regs *)
+ ioremap(SGIMC_BASE, sizeof(struct sgimc_regs));
+
+ printk(KERN_INFO "MC: SGI memory controller Revision %d\n",
+ (int) sgimc->systemid & SGIMC_SYSID_MASKREV);
+
+ /* Place the MC into a known state. This must be done before
+ * interrupts are first enabled etc.
+ */
+
+ /* Step 0: Make sure we turn off the watchdog in case it's
+ * still running (which might be the case after a
+ * soft reboot).
+ */
+ tmp = sgimc->cpuctrl0;
+ tmp &= ~SGIMC_CCTRL0_WDOG;
+ sgimc->cpuctrl0 = tmp;
+
+ /* Step 1: The CPU/GIO error status registers will not latch
+ * up a new error status until the register has been
+ * cleared by the cpu. These status registers are
+ * cleared by writing any value to them.
+ */
+ sgimc->cstat = sgimc->gstat = 0;
+
+ /* Step 2: Enable all parity checking in cpu control register
+ * zero.
+ */
+ /* don't touch parity settings for IP28 */
+ tmp = sgimc->cpuctrl0;
+#ifndef CONFIG_SGI_IP28
+ tmp |= SGIMC_CCTRL0_EPERRGIO | SGIMC_CCTRL0_EPERRMEM;
+#endif
+ tmp |= SGIMC_CCTRL0_R4KNOCHKPARR;
+ sgimc->cpuctrl0 = tmp;
+
+ /* Step 3: Setup the MC write buffer depth, this is controlled
+ * in cpu control register 1 in the lower 4 bits.
+ */
+ tmp = sgimc->cpuctrl1;
+ tmp &= ~0xf;
+ tmp |= 0xd;
+ sgimc->cpuctrl1 = tmp;
+
+ /* Step 4: Initialize the RPSS divider register to run as fast
+ * as it can correctly operate. The register is laid
+ * out as follows:
+ *
+ * ----------------------------------------
+ * | RESERVED | INCREMENT | DIVIDER |
+ * ----------------------------------------
+ * 31 16 15 8 7 0
+ *
+ * DIVIDER determines how often a 'tick' happens,
+ * INCREMENT determines by how the RPSS increment
+ * registers value increases at each 'tick'. Thus,
+ * for IP22 we get INCREMENT=1, DIVIDER=1 == 0x101
+ */
+ sgimc->divider = 0x101;
+
+ /* Step 5: Initialize GIO64 arbitrator configuration register.
+ *
+ * NOTE: HPC init code in sgihpc_init() must run before us because
+ * we need to know Guiness vs. FullHouse and the board
+ * revision on this machine. You have been warned.
+ */
+
+ /* First the basic invariants across all GIO64 implementations. */
+ tmp = sgimc->giopar & SGIMC_GIOPAR_GFX64; /* keep gfx 64bit settings */
+ tmp |= SGIMC_GIOPAR_HPC64; /* All 1st HPC's interface at 64bits */
+ tmp |= SGIMC_GIOPAR_ONEBUS; /* Only one physical GIO bus exists */
+
+ if (ip22_is_fullhouse()) {
+ /* Fullhouse specific settings. */
+ if (SGIOC_SYSID_BOARDREV(sgioc->sysid) < 2) {
+ tmp |= SGIMC_GIOPAR_HPC264; /* 2nd HPC at 64bits */
+ tmp |= SGIMC_GIOPAR_PLINEEXP0; /* exp0 pipelines */
+ tmp |= SGIMC_GIOPAR_MASTEREXP1; /* exp1 masters */
+ tmp |= SGIMC_GIOPAR_RTIMEEXP0; /* exp0 is realtime */
+ } else {
+ tmp |= SGIMC_GIOPAR_HPC264; /* 2nd HPC 64bits */
+ tmp |= SGIMC_GIOPAR_PLINEEXP0; /* exp[01] pipelined */
+ tmp |= SGIMC_GIOPAR_PLINEEXP1;
+ tmp |= SGIMC_GIOPAR_MASTEREISA; /* EISA masters */
+ }
+ } else {
+ /* Guiness specific settings. */
+ tmp |= SGIMC_GIOPAR_EISA64; /* MC talks to EISA at 64bits */
+ tmp |= SGIMC_GIOPAR_MASTEREISA; /* EISA bus can act as master */
+ }
+ sgimc->giopar = tmp; /* poof */
+
+ probe_memory();
+}
+
+void __init prom_meminit(void) {}
+void __init prom_free_prom_memory(void)
+{
+#ifdef CONFIG_SGI_IP28
+ u32 mconfig1;
+ unsigned long flags;
+ spinlock_t lock;
+
+ /*
+ * because ARCS accesses memory uncached we wait until ARCS
+ * isn't needed any longer, before we switch from slow to
+ * normal mode
+ */
+ spin_lock_irqsave(&lock, flags);
+ mconfig1 = sgimc->mconfig1;
+ /* map ECC register */
+ sgimc->mconfig1 = (mconfig1 & 0xffff0000) | 0x2060;
+ iob();
+ /* switch to normal mode */
+ *(unsigned long *)PHYS_TO_XKSEG_UNCACHED(0x60000000) = 0;
+ iob();
+ /* reduce WR_COL */
+ sgimc->cmacc = (sgimc->cmacc & ~0xf) | 4;
+ iob();
+ /* restore old config */
+ sgimc->mconfig1 = mconfig1;
+ iob();
+ spin_unlock_irqrestore(&lock, flags);
+#endif
+}
Code Review / kvmfornfv.git / blobdiff