Add the rt linux 4.1.3-rt3 as base

[kvmfornfv.git] / kernel / Documentation / devicetree / bindings / video / ssd1307fb.txt

diff --git a/kernel/Documentation/devicetree/bindings/video/ssd1307fb.txt b/kernel/Documentation/devicetree/bindings/video/ssd1307fb.txt
new file mode 100644 (file)
index 0000000..7a12542
--- /dev/null
+++ b/kernel/Documentation/devicetree/bindings/video/ssd1307fb.txt
@@ -0,0 +1,28 @@
+* Solomon SSD1307 Framebuffer Driver
+
+Required properties:
+  - compatible: Should be "solomon,<chip>fb-<bus>". The only supported bus for
+    now is i2c, and the supported chips are ssd1306 and ssd1307.
+  - reg: Should contain address of the controller on the I2C bus. Most likely
+         0x3c or 0x3d
+  - pwm: Should contain the pwm to use according to the OF device tree PWM
+         specification [0]. Only required for the ssd1307.
+  - reset-gpios: Should contain the GPIO used to reset the OLED display
+  - solomon,height: Height in pixel of the screen driven by the controller
+  - solomon,width: Width in pixel of the screen driven by the controller
+  - solomon,page-offset: Offset of pages (band of 8 pixels) that the screen is
+    mapped to.
+
+Optional properties:
+  - reset-active-low: Is the reset gpio is active on physical low?
+
+[0]: Documentation/devicetree/bindings/pwm/pwm.txt
+
+Examples:
+ssd1307: oled@3c {
+        compatible = "solomon,ssd1307fb-i2c";
+        reg = <0x3c>;
+        pwms = <&pwm 4 3000>;
+        reset-gpios = <&gpio2 7>;
+        reset-active-low;
+};