the different fan speeds possible. Cooling states are referred to by
single unsigned integers, where larger numbers mean greater heat
dissipation. The precise set of cooling states associated with a device
-(as referred to be the cooling-min-state and cooling-max-state
+(as referred to by the cooling-min-level and cooling-max-level
properties) should be defined in a particular device's binding.
For more examples of cooling devices, refer to the example sections below.
Required properties:
-- cooling-min-state: An integer indicating the smallest
- Type: unsigned cooling state accepted. Typically 0.
- Size: one cell
-
-- cooling-max-state: An integer indicating the largest
- Type: unsigned cooling state accepted.
- Size: one cell
-
- #cooling-cells: Used to provide cooling device specific information
Type: unsigned while referring to it. Must be at least 2, in order
Size: one cell to specify minimum and maximum cooling state used
See Cooling device maps section below for more details
on how consumers refer to cooling devices.
+Optional properties:
+- cooling-min-level: An integer indicating the smallest
+ Type: unsigned cooling state accepted. Typically 0.
+ Size: one cell
+
+- cooling-max-level: An integer indicating the largest
+ Type: unsigned cooling state accepted.
+ Size: one cell
+
* Trip points
The trip node is a node to describe a point in the temperature domain
by means of sensor ID. Additional coefficients are
interpreted as constant offset.
+- sustainable-power: An estimate of the sustainable power (in mW) that the
+ Type: unsigned thermal zone can dissipate at the desired
+ Size: one cell control temperature. For reference, the
+ sustainable power of a 4'' phone is typically
+ 2000mW, while on a 10'' tablet is around
+ 4500mW.
+
Note: The delay properties are bound to the maximum dT/dt (temperature
derivative over time) in two situations for a thermal zone:
(i) - when passive cooling is activated (polling-delay-passive); and
396000 950000
198000 850000
>;
- cooling-min-state = <0>;
- cooling-max-state = <3>;
+ cooling-min-level = <0>;
+ cooling-max-level = <3>;
#cooling-cells = <2>; /* min followed by max */
};
...
*/
fan0: fan@0x48 {
...
- cooling-min-state = <0>;
- cooling-max-state = <9>;
+ cooling-min-level = <0>;
+ cooling-max-level = <9>;
#cooling-cells = <2>; /* min followed by max */
};
};
*/
coefficients = <1200 -345 890>;
+ sustainable-power = <2500>;
+
trips {
/* Trips are based on resulting linear equation */
cpu_trip: cpu-trip {