Add the rt linux 4.1.3-rt3 as base

[kvmfornfv.git] / kernel / Documentation / devicetree / bindings / spi / spi-img-spfi.txt

diff --git a/kernel/Documentation/devicetree/bindings/spi/spi-img-spfi.txt b/kernel/Documentation/devicetree/bindings/spi/spi-img-spfi.txt
new file mode 100644 (file)
index 0000000..e02fbf1
--- /dev/null
+++ b/kernel/Documentation/devicetree/bindings/spi/spi-img-spfi.txt
@@ -0,0 +1,38 @@
+IMG Synchronous Peripheral Flash Interface (SPFI) controller
+
+Required properties:
+- compatible: Must be "img,spfi".
+- reg: Must contain the base address and length of the SPFI registers.
+- interrupts: Must contain the SPFI interrupt.
+- clocks: Must contain an entry for each entry in clock-names.
+  See ../clock/clock-bindings.txt for details.
+- clock-names: Must include the following entries:
+  - spfi: SPI operating clock
+  - sys: SPI system interface clock
+- dmas: Must contain an entry for each entry in dma-names.
+  See ../dma/dma.txt for details.
+- dma-names: Must include the following entries:
+  - rx
+  - tx
+- cs-gpios: Must specify the GPIOs used for chipselect lines.
+- #address-cells: Must be 1.
+- #size-cells: Must be 0.
+
+Optional properties:
+- img,supports-quad-mode: Should be set if the interface supports quad mode
+  SPI transfers.
+
+Example:
+
+spi@18100f00 {
+       compatible = "img,spfi";
+       reg = <0x18100f00 0x100>;
+       interrupts = <GIC_SHARED 22 IRQ_TYPE_LEVEL_HIGH>;
+       clocks = <&spi_clk>, <&system_clk>;
+       clock-names = "spfi", "sys";
+       dmas = <&mdc 9 0xffffffff 0>, <&mdc 10 0xffffffff 0>;
+       dma-names = "rx", "tx";
+
+       #address-cells = <1>;
+       #size-cells = <0>;
+};