--- /dev/null
+* Texas Instruments Keystone Navigator Queue Management SubSystem driver
+
+The QMSS (Queue Manager Sub System) found on Keystone SOCs is one of
+the main hardware sub system which forms the backbone of the Keystone
+multi-core Navigator. QMSS consist of queue managers, packed-data structure
+processors(PDSP), linking RAM, descriptor pools and infrastructure
+Packet DMA.
+The Queue Manager is a hardware module that is responsible for accelerating
+management of the packet queues. Packets are queued/de-queued by writing or
+reading descriptor address to a particular memory mapped location. The PDSPs
+perform QMSS related functions like accumulation, QoS, or event management.
+Linking RAM registers are used to link the descriptors which are stored in
+descriptor RAM. Descriptor RAM is configurable as internal or external memory.
+The QMSS driver manages the PDSP setups, linking RAM regions,
+queue pool management (allocation, push, pop and notify) and descriptor
+pool management.
+
+
+Required properties:
+- compatible : Must be "ti,keystone-navigator-qmss";
+- clocks : phandle to the reference clock for this device.
+- queue-range : <start number> total range of queue numbers for the device.
+- linkram0 : <address size> for internal link ram, where size is the total
+ link ram entries.
+- linkram1 : <address size> for external link ram, where size is the total
+ external link ram entries. If the address is specified as "0"
+ driver will allocate memory.
+- qmgrs : child node describing the individual queue managers on the
+ SoC. On keystone 1 devices there should be only one node.
+ On keystone 2 devices there can be more than 1 node.
+ -- managed-queues : the actual queues managed by each queue manager
+ instance, specified as <"base queue #" "# of queues">.
+ -- reg : Address and size of the register set for the device.
+ Register regions should be specified in the following
+ order
+ - Queue Peek region.
+ - Queue status RAM.
+ - Queue configuration region.
+ - Descriptor memory setup region.
+ - Queue Management/Queue Proxy region for queue Push.
+ - Queue Management/Queue Proxy region for queue Pop.
+- queue-pools : child node classifying the queue ranges into pools.
+ Queue ranges are grouped into 3 type of pools:
+ - qpend : pool of qpend(interruptible) queues
+ - general-purpose : pool of general queues, primarly used
+ as free descriptor queues or the
+ transmit DMA queues.
+ - accumulator : pool of queues on PDSP accumulator channel
+ Each range can have the following properties:
+ -- qrange : number of queues to use per queue range, specified as
+ <"base queue #" "# of queues">.
+ -- interrupts : Optional property to specify the interrupt mapping
+ for interruptible queues. The driver additionaly sets
+ the interrupt affinity hint based on the cpu mask.
+ -- qalloc-by-id : Optional property to specify that the queues in this
+ range can only be allocated by queue id.
+ -- accumulator : Accumulator channel specification. Any of the PDSPs in
+ QMSS can be loaded with the accumulator firmware. The
+ accumulator firmware’s job is to poll a select number of
+ queues looking for descriptors that have been pushed
+ into them. Descriptors are popped from the queue and
+ placed in a buffer provided by the host. When the list
+ becomes full or a programmed time period expires, the
+ accumulator triggers an interrupt to the host to read
+ the buffer for descriptor information. This firmware
+ comes in 16, 32, and 48 channel builds. Each of these
+ channels can be configured to monitor 32 contiguous
+ queues. Accumulator channel property is specified as:
+ <pdsp-id, channel, entries, pacing mode, latency>
+ pdsp-id : QMSS PDSP running accumulator firmware
+ on which the channel has to be
+ configured
+ channel : Accumulator channel number
+ entries : Size of the accumulator descriptor list
+ pacing mode : Interrupt pacing mode
+ 0 : None, i.e interrupt on list full only
+ 1 : Time delay since last interrupt
+ 2 : Time delay since first new packet
+ 3 : Time delay since last new packet
+ latency : time to delay the interrupt, specified
+ in microseconds.
+ -- multi-queue : Optional property to specify that the channel has to
+ monitor upto 32 queues starting at the base queue #.
+- descriptor-regions : child node describing the memory regions for keystone
+ navigator packet DMA descriptors. The memory for
+ descriptors will be allocated by the driver.
+ -- id : region number in QMSS.
+ -- region-spec : specifies the number of descriptors in the
+ region, specified as
+ <"# of descriptors" "descriptor size">.
+ -- link-index : start index, i.e. index of the first
+ descriptor in the region.
+
+Optional properties:
+- dma-coherent : Present if DMA operations are coherent.
+- pdsps : child node describing the PDSP configuration.
+ -- firmware : firmware to be loaded on the PDSP.
+ -- id : the qmss pdsp that will run the firmware.
+ -- reg : Address and size of the register set for the PDSP.
+ Register regions should be specified in the following
+ order
+ - PDSP internal RAM region.
+ - PDSP control/status region registers.
+ - QMSS interrupt distributor registers.
+ - PDSP command interface region.
+
+Example:
+
+qmss: qmss@2a40000 {
+ compatible = "ti,keystone-qmss";
+ dma-coherent;
+ #address-cells = <1>;
+ #size-cells = <1>;
+ clocks = <&chipclk13>;
+ ranges;
+ queue-range = <0 0x4000>;
+ linkram0 = <0x100000 0x8000>;
+ linkram1 = <0x0 0x10000>;
+
+ qmgrs {
+ #address-cells = <1>;
+ #size-cells = <1>;
+ ranges;
+ qmgr0 {
+ managed-queues = <0 0x2000>;
+ reg = <0x2a40000 0x20000>,
+ <0x2a06000 0x400>,
+ <0x2a02000 0x1000>,
+ <0x2a03000 0x1000>,
+ <0x23a80000 0x20000>,
+ <0x2a80000 0x20000>;
+ };
+
+ qmgr1 {
+ managed-queues = <0x2000 0x2000>;
+ reg = <0x2a60000 0x20000>,
+ <0x2a06400 0x400>,
+ <0x2a04000 0x1000>,
+ <0x2a05000 0x1000>,
+ <0x23aa0000 0x20000>,
+ <0x2aa0000 0x20000>;
+ };
+ };
+ queue-pools {
+ qpend {
+ qpend-0 {
+ qrange = <658 8>;
+ interrupts =<0 40 0xf04 0 41 0xf04 0 42 0xf04
+ 0 43 0xf04 0 44 0xf04 0 45 0xf04
+ 0 46 0xf04 0 47 0xf04>;
+ };
+ qpend-1 {
+ qrange = <8704 16>;
+ interrupts = <0 48 0xf04 0 49 0xf04 0 50 0xf04
+ 0 51 0xf04 0 52 0xf04 0 53 0xf04
+ 0 54 0xf04 0 55 0xf04 0 56 0xf04
+ 0 57 0xf04 0 58 0xf04 0 59 0xf04
+ 0 60 0xf04 0 61 0xf04 0 62 0xf04
+ 0 63 0xf04>;
+ qalloc-by-id;
+ };
+ qpend-2 {
+ qrange = <8720 16>;
+ interrupts = <0 64 0xf04 0 65 0xf04 0 66 0xf04
+ 0 59 0xf04 0 68 0xf04 0 69 0xf04
+ 0 70 0xf04 0 71 0xf04 0 72 0xf04
+ 0 73 0xf04 0 74 0xf04 0 75 0xf04
+ 0 76 0xf04 0 77 0xf04 0 78 0xf04
+ 0 79 0xf04>;
+ };
+ };
+ general-purpose {
+ gp-0 {
+ qrange = <4000 64>;
+ };
+ netcp-tx {
+ qrange = <640 9>;
+ qalloc-by-id;
+ };
+ };
+ accumulator {
+ acc-0 {
+ qrange = <128 32>;
+ accumulator = <0 36 16 2 50>;
+ interrupts = <0 215 0xf01>;
+ multi-queue;
+ qalloc-by-id;
+ };
+ acc-1 {
+ qrange = <160 32>;
+ accumulator = <0 37 16 2 50>;
+ interrupts = <0 216 0xf01>;
+ multi-queue;
+ };
+ acc-2 {
+ qrange = <192 32>;
+ accumulator = <0 38 16 2 50>;
+ interrupts = <0 217 0xf01>;
+ multi-queue;
+ };
+ acc-3 {
+ qrange = <224 32>;
+ accumulator = <0 39 16 2 50>;
+ interrupts = <0 218 0xf01>;
+ multi-queue;
+ };
+ };
+ };
+ descriptor-regions {
+ #address-cells = <1>;
+ #size-cells = <1>;
+ ranges;
+ region-12 {
+ id = <12>;
+ region-spec = <8192 128>; /* num_desc desc_size */
+ link-index = <0x4000>;
+ };
+ };
+ pdsps {
+ #address-cells = <1>;
+ #size-cells = <1>;
+ ranges;
+ pdsp0@0x2a10000 {
+ firmware = "keystone/qmss_pdsp_acc48_k2_le_1_0_0_8.fw";
+ reg = <0x2a10000 0x1000>,
+ <0x2a0f000 0x100>,
+ <0x2a0c000 0x3c8>,
+ <0x2a20000 0x4000>;
+ id = <0>;
+ };
+ };
+}; /* qmss */
Code Review / kvmfornfv.git / blobdiff