Add the rt linux 4.1.3-rt3 as base

[kvmfornfv.git] / kernel / Documentation / devicetree / bindings / media / samsung-s5k6a3.txt

diff --git a/kernel/Documentation/devicetree/bindings/media/samsung-s5k6a3.txt b/kernel/Documentation/devicetree/bindings/media/samsung-s5k6a3.txt
new file mode 100644 (file)
index 0000000..cce01e8
--- /dev/null
+++ b/kernel/Documentation/devicetree/bindings/media/samsung-s5k6a3.txt
@@ -0,0 +1,33 @@
+Samsung S5K6A3(YX) raw image sensor
+---------------------------------
+
+S5K6A3(YX) is a raw image sensor with MIPI CSI-2 and CCP2 image data interfaces
+and CCI (I2C compatible) control bus.
+
+Required properties:
+
+- compatible   : "samsung,s5k6a3";
+- reg          : I2C slave address of the sensor;
+- svdda-supply : core voltage supply;
+- svddio-supply        : I/O voltage supply;
+- afvdd-supply : AF (actuator) voltage supply;
+- gpios                : specifier of a GPIO connected to the RESET pin;
+- clocks       : should contain list of phandle and clock specifier pairs
+                 according to common clock bindings for the clocks described
+                 in the clock-names property;
+- clock-names  : should contain "extclk" entry for the sensor's EXTCLK clock;
+
+Optional properties:
+
+- clock-frequency : the frequency at which the "extclk" clock should be
+                   configured to operate, in Hz; if this property is not
+                   specified default 24 MHz value will be used.
+
+The common video interfaces bindings (see video-interfaces.txt) should be
+used to specify link to the image data receiver. The S5K6A3(YX) device
+node should contain one 'port' child node with an 'endpoint' subnode.
+
+Following properties are valid for the endpoint node:
+
+- data-lanes : (optional) specifies MIPI CSI-2 data lanes as covered in
+  video-interfaces.txt.  The sensor supports only one data lane.