These changes are the raw update to linux-4.4.6-rt14. Kernel sources

[kvmfornfv.git] / kernel / Documentation / devicetree / bindings / leds / leds-ktd2692.txt

diff --git a/kernel/Documentation/devicetree/bindings/leds/leds-ktd2692.txt b/kernel/Documentation/devicetree/bindings/leds/leds-ktd2692.txt
new file mode 100644 (file)
index 0000000..8537374
--- /dev/null
+++ b/kernel/Documentation/devicetree/bindings/leds/leds-ktd2692.txt
@@ -0,0 +1,50 @@
+* Kinetic Technologies - KTD2692 Flash LED Driver
+
+KTD2692 is the ideal power solution for high-power flash LEDs.
+It uses ExpressWire single-wire programming for maximum flexibility.
+
+The ExpressWire interface through CTRL pin can control LED on/off and
+enable/disable the IC, Movie(max 1/3 of Flash current) / Flash mode current,
+Flash timeout, LVP(low voltage protection).
+
+Also, When the AUX pin is pulled high while CTRL pin is high,
+LED current will be ramped up to the flash-mode current level.
+
+Required properties:
+- compatible : Should be "kinetic,ktd2692".
+- ctrl-gpios : Specifier of the GPIO connected to CTRL pin.
+- aux-gpios : Specifier of the GPIO connected to AUX pin.
+
+Optional properties:
+- vin-supply : "vin" LED supply (2.7V to 5.5V).
+  See Documentation/devicetree/bindings/regulator/regulator.txt
+
+A discrete LED element connected to the device must be represented by a child
+node - See Documentation/devicetree/bindings/leds/common.txt
+
+Required properties for flash LED child nodes:
+  See Documentation/devicetree/bindings/leds/common.txt
+- led-max-microamp : Minimum Threshold for Timer protection
+  is defined internally (Maximum 300mA).
+- flash-max-microamp : Flash LED maximum current
+  Formula : I(mA) = 15000 / Rset.
+- flash-max-timeout-us : Flash LED maximum timeout.
+
+Optional properties for flash LED child nodes:
+- label : See Documentation/devicetree/bindings/leds/common.txt
+
+Example:
+
+ktd2692 {
+       compatible = "kinetic,ktd2692";
+       ctrl-gpios = <&gpc0 1 0>;
+       aux-gpios = <&gpc0 2 0>;
+       vin-supply = <&vbat>;
+
+       flash-led {
+               label = "ktd2692-flash";
+               led-max-microamp = <300000>;
+               flash-max-microamp = <1500000>;
+               flash-max-timeout-us = <1835000>;
+       };
+};