Add the rt linux 4.1.3-rt3 as base

[kvmfornfv.git] / kernel / Documentation / devicetree / bindings / gpio / gpio-xgene-sb.txt

diff --git a/kernel/Documentation/devicetree/bindings/gpio/gpio-xgene-sb.txt b/kernel/Documentation/devicetree/bindings/gpio/gpio-xgene-sb.txt
new file mode 100644 (file)
index 0000000..dae1300
--- /dev/null
+++ b/kernel/Documentation/devicetree/bindings/gpio/gpio-xgene-sb.txt
@@ -0,0 +1,32 @@
+APM X-Gene Standby GPIO controller bindings
+
+This is a gpio controller in the standby domain.
+
+There are 20 GPIO pins from 0..21. There is no GPIO_DS14 or GPIO_DS15,
+only GPIO_DS8..GPIO_DS13 support interrupts. The IRQ mapping
+is currently 1-to-1 on interrupts 0x28 thru 0x2d.
+
+Required properties:
+- compatible: "apm,xgene-gpio-sb" for the X-Gene Standby GPIO controller
+- reg: Physical base address and size of the controller's registers
+- #gpio-cells: Should be two.
+       - first cell is the pin number
+       - second cell is used to specify the gpio polarity:
+               0 = active high
+               1 = active low
+- gpio-controller: Marks the device node as a GPIO controller.
+- interrupts: Shall contain exactly 6 interrupts.
+
+Example:
+       sbgpio: sbgpio@17001000 {
+               compatible = "apm,xgene-gpio-sb";
+               reg = <0x0 0x17001000 0x0 0x400>;
+               #gpio-cells = <2>;
+               gpio-controller;
+               interrupts =    <0x0 0x28 0x1>,
+                               <0x0 0x29 0x1>,
+                               <0x0 0x2a 0x1>,
+                               <0x0 0x2b 0x1>,
+                               <0x0 0x2c 0x1>,
+                               <0x0 0x2d 0x1>;
+       };