Add the rt linux 4.1.3-rt3 as base

[kvmfornfv.git] / kernel / Documentation / devicetree / bindings / dma / sun6i-dma.txt

diff --git a/kernel/Documentation/devicetree/bindings/dma/sun6i-dma.txt b/kernel/Documentation/devicetree/bindings/dma/sun6i-dma.txt
new file mode 100644 (file)
index 0000000..9cdcba2
--- /dev/null
+++ b/kernel/Documentation/devicetree/bindings/dma/sun6i-dma.txt
@@ -0,0 +1,45 @@
+Allwinner A31 DMA Controller
+
+This driver follows the generic DMA bindings defined in dma.txt.
+
+Required properties:
+
+- compatible:  Must be "allwinner,sun6i-a31-dma" or "allwinner,sun8i-a23-dma"
+- reg:         Should contain the registers base address and length
+- interrupts:  Should contain a reference to the interrupt used by this device
+- clocks:      Should contain a reference to the parent AHB clock
+- resets:      Should contain a reference to the reset controller asserting
+               this device in reset
+- #dma-cells : Should be 1, a single cell holding a line request number
+
+Example:
+       dma: dma-controller@01c02000 {
+               compatible = "allwinner,sun6i-a31-dma";
+               reg = <0x01c02000 0x1000>;
+               interrupts = <0 50 4>;
+               clocks = <&ahb1_gates 6>;
+               resets = <&ahb1_rst 6>;
+               #dma-cells = <1>;
+       };
+
+Clients:
+
+DMA clients connected to the A31 DMA controller must use the format
+described in the dma.txt file, using a two-cell specifier for each
+channel: a phandle plus one integer cells.
+The two cells in order are:
+
+1. A phandle pointing to the DMA controller.
+2. The port ID as specified in the datasheet
+
+Example:
+spi2: spi@01c6a000 {
+       compatible = "allwinner,sun6i-a31-spi";
+       reg = <0x01c6a000 0x1000>;
+       interrupts = <0 67 4>;
+       clocks = <&ahb1_gates 22>, <&spi2_clk>;
+       clock-names = "ahb", "mod";
+       dmas = <&dma 25>, <&dma 25>;
+       dma-names = "rx", "tx";
+       resets = <&ahb1_rst 22>;
+};