Add the rt linux 4.1.3-rt3 as base
[kvmfornfv.git] / kernel / Documentation / arm / SA1100 / CERF
diff --git a/kernel/Documentation/arm/SA1100/CERF b/kernel/Documentation/arm/SA1100/CERF
new file mode 100644 (file)
index 0000000..b3d8453
--- /dev/null
@@ -0,0 +1,29 @@
+*** The StrongARM version of the CerfBoard/Cube has been discontinued ***
+
+The Intrinsyc CerfBoard is a StrongARM 1110-based computer on a board
+that measures approximately 2" square. It includes an Ethernet
+controller, an RS232-compatible serial port, a USB function port, and
+one CompactFlash+ slot on the back. Pictures can be found at the
+Intrinsyc website, http://www.intrinsyc.com.
+
+This document describes the support in the Linux kernel for the
+Intrinsyc CerfBoard.
+
+Supported in this version:
+   - CompactFlash+ slot (select PCMCIA in General Setup and any options
+     that may be required)
+   - Onboard Crystal CS8900 Ethernet controller (Cerf CS8900A support in
+     Network Devices)
+   - Serial ports with a serial console (hardcoded to 38400 8N1)
+
+In order to get this kernel onto your Cerf, you need a server that runs
+both BOOTP and TFTP. Detailed instructions should have come with your
+evaluation kit on how to use the bootloader. This series of commands
+will suffice:
+
+   make ARCH=arm CROSS_COMPILE=arm-linux- cerfcube_defconfig
+   make ARCH=arm CROSS_COMPILE=arm-linux- zImage
+   make ARCH=arm CROSS_COMPILE=arm-linux- modules
+   cp arch/arm/boot/zImage <TFTP directory>
+
+support@intrinsyc.com