NFVBENCH-161 NFVbench --force-cleanup deletes more ports than needed

[nfvbench.git] / docs / testing / user / userguide / hw_requirements.rst

diff --git a/docs/testing/user/userguide/hw_requirements.rst b/docs/testing/user/userguide/hw_requirements.rst
index 4fc6e21..44ab549 100644 (file)
--- a/docs/testing/user/userguide/hw_requirements.rst
+++ b/docs/testing/user/userguide/hw_requirements.rst
@@ -14,7 +14,8 @@ To run NFVbench you need the following hardware:
 - a DPDK compatible NIC with at least 2 ports (preferably 10Gbps or higher)
 - 2 ethernet cables between the NIC and the OpenStack pod under test (usually through a top of rack switch)
 
-The DPDK-compliant NIC must be one supported by the TRex traffic generator (such as Intel X710, refer to the `Trex Installation Guide <https://trex-tgn.cisco.com/trex/doc/trex_manual.html#_download_and_installation>`_ for a complete list of supported NIC)
+The DPDK-compliant NIC must be one supported by the TRex traffic generator (such as Intel X710, 
+refer to the Trex Installation Guide for a complete list of supported NIC)
 
 To run the TRex traffic generator (that is bundled with NFVbench) you will need to wire 2 physical interfaces of the NIC to the TOR switch(es):
     - if you have only 1 TOR, wire both interfaces to that same TOR
@@ -67,4 +68,4 @@ Finally, the correct iommu options and huge pages to be configured on the Linux
 - enable intel_iommu and iommu pass through: "intel_iommu=on iommu=pt"
 - for Trex, pre-allocate 1024 huge pages of 2MB each (for a total of 2GB): "hugepagesz=2M hugepages=1024"
 
-More detailed instructions can be found in the DPDK documentation (https://media.readthedocs.org/pdf/dpdk/latest/dpdk.pdf).
+More detailed instructions can be found in the DPDK documentation (https://buildmedia.readthedocs.org/media/pdf/dpdk/latest/dpdk.pdf).