packages and configuration for an OPNFV deployment to execute. Once the disk
images have been written to node's disks the nodes will boot locally and
execute cloud-init which will execute the final node configuration. This
-configuration is largly completed by executing a puppet apply on each node.
+configuration is largely completed by executing a puppet apply on each node.
Installation High-Level Overview - VM Deployment
================================================
control node and 1 or more compute nodes for a Non-HA Deployment) will be
defined for the target OPNFV deployment. The part of the toolchain that
executes IPMI power instructions calls into libvirt instead of the IPMI
-interfaces on baremetal servers to operate the power managment. These VMs are
+interfaces on baremetal servers to operate the power management. These VMs are
then provisioned with the same disk images and configuration that baremetal
would be.
support is completed.
1b. If your Jump host already has CentOS 7 with libvirt running on it then
- install the install the RDO Newton Release RPM and epel-release:
+ install the RDO Newton Release RPM and epel-release:
``sudo yum install https://repos.fedorapeople.org/repos/openstack/openstack-newton/rdo-release-newton-4.noarch.rpm``
``sudo yum install epel-release``
install the opnfv-apex RPMs using the OPNFV artifacts yum repo. This yum
repo is created at release. It will not exist before release day.
- ``sudo yum install http://artifacts.opnfv.org/apex/danube/opnfv-apex-release-danube.noarch.rpm``
+ ``sudo yum install http://artifacts.opnfv.org/apex/euphrates/opnfv-apex-release-euphrates.noarch.rpm``
Once you have installed the repo definitions for Apex, RDO and EPEL then
yum install Apex:
(``/etc/opnfv-apex/``). These files are named with the naming convention
os-sdn_controller-enabled_feature-[no]ha.yaml. These files can be used in
place of the (``/etc/opnfv-apex/deploy_settings.yaml``) file if one suites
- your deployment needs. If a pre-built deploy_settings file is choosen there
+ your deployment needs. If a pre-built deploy_settings file is chosen there
is no need to customize (``/etc/opnfv-apex/deploy_settings.yaml``). The
pre-built file can be used in place of the
(``/etc/opnfv-apex/deploy_settings.yaml``) file.