if [[ ${link_state} != 'UP' ]]; then
echo "${blue}${interface} state is ${link_state}. Bringing it UP!${reset}"
ip link set dev ${interface} up
+ sleep 5
link_state=$(ip link show ${interface} | grep -oP 'state \K[^ ]+')
if [[ ${link_state} != 'UP' ]]; then
echo "${red}Could not bring UP interface ${interface} link state is ${link_state}${reset}"
#Check whether PXE bridge exists
echo "${blue}Checking whether PXE bridge ${pxe_bridge} exists${reset}"
- if brctl show ${pxe_bridge} | grep 'No such device'; then
+ if brctl show ${pxe_bridge} 2>&1 | grep 'No such device'; then
echo "${blue}Creating PXE bridge ${pxe_bridge}${reset}"
brctl addbr ${pxe_bridge}
else
echo "${green}OK!${reset}"
fi
- #Check whether PXE bridge is UP
- check_interface ${pxe_bridge}
-
#Add VLAN 0 (PXE) interface to PXE bridge
echo "${blue}Checking whether VLAN 0 (PXE) interface ${pxe_interface} is added to PXE bridge ${pxe_bridge} exists${reset}"
- if ! brctl show ${pxe_bridge} | grep ${pxe_interface}; then
+ if ! brctl show ${pxe_bridge} 2>&1 | grep ${pxe_interface}; then
echo "${blue}Adding VLAN 0 (PXE) interface ${pxe_interface} to PXE bridge ${pxe_bridge}${reset}"
brctl addif ${pxe_bridge} ${pxe_interface}
- if ! brctl show ${pxe_bridge} | grep ${pxe_interface}; then
+ if ! brctl show ${pxe_bridge} 2>&1 | grep ${pxe_interface}; then
echo "${red}Could not add VLAN 0 (PXE) interface ${pxe_interface} to PXE bridge ${pxe_bridge}${reset}"
exit 1
fi
echo "${green}OK!${reset}"
fi
+ #Check whether PXE bridge is UP
+ check_interface ${pxe_bridge}
+
#Add Fuel Gateway IP Address to PXE bridge
echo "${blue}Checking whether Fuel Gateway IP Address ${fuel_gw_ip} is assigned to PXE bridge ${pxe_bridge}${reset}"
if ! ip addr show ${pxe_bridge} | grep ${fuel_gw_ip}; then