1 ############################################################################################################################
2 # Date: <13/01/2017> Version: <1.1> #
3 ############################################################################################################################
6 Feature:Auth_NotAccept_by_UE_non_EPS_AuthUnaccpt
8 @authentication-procedure @Auth_NotAccept_by_UE_non_EPS_AuthUnaccpt @TS_24_301 @24_301_5_4_2_6 @24_301_5_4_2_7 @negTCs @Series-0004 @SS_changesReqd
10 Scenario: UE receives an AUTHENTICATION REQUEST message with "separation bit" in the AMF field is 0. UE shall send an AUTHENTICATION FAILURE message to the network, with the reject cause #26 "non-EPS authentication unacceptable"
12 # AuC system changes required. HSS should send Authentication request message with AMF=AMF_RESYNCH amf = {0xff 0xff}
13 # file name kdf.c line no: 156 uint8_t amf[] = { 0xFF, 0xFF };
15 Given all configured endpoints for SSH are connected successfully
17 Given the steps below will be executed at the end
18 When I stop S1AP simulator on node ABOT
19 When I run the SSH command "sudo service mme_gw restart" on node MME
20 Given that I setup S1AP Simulator with UE parameter "ABOT.UE.CONFIG.SECURITY.SYNC_FAILURE=false" on node ABOT
21 Given that I setup S1AP Simulator with USIM parameter "ABOT.UE.USIM.AttachWithImsi=true" on node ABOT
22 Given the execution is paused for {abotprop.WAIT_10_SEC} seconds
23 Then the ending steps are complete
25 # set ABOT configuration
26 Given that I setup S1AP Simulator with default parameters specified in {abotprop.ABOT.EPC.Defaults} on node ABOT
27 Given that I setup S1AP Simulator with UE parameter "ABOT.UE.CONFIG.SECURITY.SYNC_FAILURE=true" on node ABOT
28 Given that I setup S1AP Simulator with USIM parameter "ABOT.UE.USIM.AttachWithImsi=false" on node ABOT
30 # Execute ABOT S1AP Simulator
31 When I run S1AP simulator on node ABOT with 1 UE
33 Given the execution is paused for {abotprop.WAIT_10_SEC} seconds
34 Given the execution is paused for {abotprop.WAIT_10_SEC} seconds
36 # Validate Test Case Execution at Simulator
37 Then I receive S1AP response on node ABOT and verify the presence of all the following values:
38 | responseResult | existence |
39 | Send Attach Request message with GUTI | {string:nocase:present} |
40 | Received Identity Request message | {string:nocase:present} |
41 | Identification requested type = IMSI | {string:nocase:present} |
42 | Send Identity Response message | {string:nocase:present} |
43 | Received Authentication Request message | {string:nocase:present} |
44 | Send Authentication Failure message (cause=26) | {string:nocase:present} |