1 ############################################################################################################################
2 # Date: <13/01/2017> Version: <1.1> #
3 ############################################################################################################################
6 Feature:Auth_NotAccept_by_UE_SQN_failure
8 @authentication-procedure @Auth_NotAccept_by_UE_SQN_failure @TS_24_301 @24_301_5_4_2_6 @24_301_5_4_2_7 @negTCs @Series-0004
10 Scenario: UE receives an AUTHENTICATION REQUEST message with SQN out of range. UE sends an AUTHENTICATION FAILURE message to the network, with EMM cause "synch failure" and a re-synchronization token. Now UE receives a new correct AUTHENTICATION REQUEST message while T3420 is running. Finally UE sends a correct AUTHENTICATION RESPONSE message.
12 Given all configured endpoints for SSH are connected successfully
14 Given the steps below will be executed at the end
15 When I stop S1AP simulator on node ABOT
16 When I run the SSH command "sudo service mme_gw restart" on node MME
17 Given that I setup S1AP Simulator with UE parameter "ABOT.UE.CONFIG.SECURITY.SYNC_FAILURE=false" on node ABOT
18 Given that I setup S1AP Simulator with USIM parameter "ABOT.UE.USIM.AttachWithImsi=true" on node ABOT
19 Given the execution is paused for {abotprop.WAIT_10_SEC} seconds
20 Then the ending steps are complete
22 # set ABOT configuration
23 Given that I setup S1AP Simulator with default parameters specified in {abotprop.ABOT.EPC.Defaults} on node ABOT
24 Given that I setup S1AP Simulator with UE parameter "ABOT.UE.CONFIG.SECURITY.SYNC_FAILURE=true" on node ABOT
25 Given that I setup S1AP Simulator with USIM parameter "ABOT.UE.USIM.AttachWithImsi=false" on node ABOT
27 # Execute ABOT S1AP Simulator
28 When I run S1AP simulator on node ABOT with 1 UE
30 Given the execution is paused for {abotprop.WAIT_10_SEC} seconds
31 Given the execution is paused for {abotprop.WAIT_10_SEC} seconds
33 # Validate Test Case Execution at Simulator
34 Then I receive S1AP response on node ABOT and verify the presence of all the following values:
35 | responseResult | existence |
36 | Send Attach Request message with GUTI | {string:nocase:present} |
37 | Received Identity Request message | {string:nocase:present} |
38 | Identification requested type = IMSI | {string:nocase:present} |
39 | Send Identity Response message | {string:nocase:present} |
40 | Received Authentication Request message | {string:nocase:present} |
41 | Send Authentication Failure message (cause=21) | {string:nocase:present} |
42 | Received Authentication Request message | {string:nocase:present} |
43 | Send Authentication Response message | {string:nocase:present} |
44 | Received Security Mode Command message | {string:nocase:present} |
45 | Send Security Mode Complete message | {string:nocase:present} |
46 | Received Attach Accept message | {string:nocase:present} |