1 ############################################################################################################################
2 # Date: <22/11/2016> Version: <1.1> #
3 ############################################################################################################################
5 Feature:Auth_NotAccept_by_Network_GUTIattach_IMSIdiff_AuthReject_re_Auth
7 @authentication-procedure @Auth_NotAccept_by_Network_GUTIattach_IMSIdiff_AuthReject_re_Auth @TS_24_301 @24_301_5_3_3 @24_301_5_5_1_2_2 @24_301_5_5_1_2_4 @24_301_6_5_1_2 @24_301_9_9_3_33 @TS_36_304 @36_304_4_3 @negTCs @Series-0001
9 Scenario: Authentication not accepted by the network when attach with GUTI, Authentication reject when RES is different from UE and MME. IMSI given by the UE during the identification procedure differs from the IMSI the network had associated with the GUTI
11 Given all configured endpoints for SSH are connected successfully
13 Given the steps below will be executed at the end
14 When I stop S1AP simulator on node ABOT
15 When I run the SSH command "sudo service mme_gw restart" on node MME
16 Given that I setup S1AP Simulator with UE parameter "ABOT.UE.CONFIG.SECURITY.RES=0x00" on node ABOT
17 Given that I setup S1AP Simulator with UE parameter "ABOT.UE.CONFIG.SECURITY.WRONGIMSI=false" on node ABOT
18 Given the execution is paused for {abotprop.WAIT_10_SEC} seconds
19 Then the ending steps are complete
21 # set ABOT configuration
22 Given that I setup S1AP Simulator with default parameters specified in {abotprop.ABOT.EPC.Defaults} on node ABOT
23 Given that I setup S1AP Simulator with USIM parameter "ABOT.UE.USIM.AttachWithImsi=false" on node ABOT
24 # set the value of RES parameter (other than 0x00) manually in Authentication Response message which is sent from UE to MME
25 Given that I setup S1AP Simulator with UE parameter "ABOT.UE.CONFIG.SECURITY.RES=0xFF" on node ABOT
26 Given that I setup S1AP Simulator with UE parameter "ABOT.UE.CONFIG.SECURITY.WRONGIMSI=true" on node ABOT
28 # Execute ABOT S1AP Simulator
29 When I run S1AP simulator on node ABOT with 1 UE
31 Given the execution is paused for {abotprop.WAIT_10_SEC} seconds
32 Given the execution is paused for {abotprop.WAIT_10_SEC} seconds
34 # Validate Test Case Execution at Simulator
35 Then I receive S1AP response on node ABOT and verify the presence of all the following values:
36 | responseResult | existence |
37 | Send Attach Request message with GUTI | {string:nocase:present} |
38 | Received Authentication Request message | {string:nocase:present} |